User manual VALENTINE ONE VALENTINE ONE V1 - CHANGING THE FUSE

INSTALLATION: Direct-wire Power Adapter An adapter has been provided so that you can wire Valentine One directly into your car's electrical system. If you are unfamiliar with automotive electrical systems, see a mechanic or car-stereo installer: 1. Valentine One works only with negative ground electrical systems. If your car is old, or is an unusual brand of import, make sure it's negative ground. Select a "switched" wire, i.e., one that's off when the ignition is switched off, and has 12 volts when the ignition is switched on. Position wiring-harness connector around "switched" wire and squeeze with pliers to install. Plug red wire from Direct-wire Power Adapter into wiring-harness connector. Make ground connection by clamping the end of the black wire under any grounded screw. Plug power cord from Valentine One into the modular jack labeled "Main Unit" on the Direct-wire Power Adapter. Connector plugs into red wire. Pinch connector around power wire. 2. 3. 4. 5. 6. Changing the Direct-wire Power Adapter Fuse Fuse holder is in-line with the power wire (red) to the adapter. Unscrew fuse holder to change fuse. Use a 1 amp. 5mm x 20mm fuse (to change Lighter Adapter Fuse, see page 22). 19 Lighter Adapter Articulated Bracket Acc: Plug cord to Concealed Display or Remote Audio Adapter here. Articulated bracket may be removed when not needed for Concealed Display. Main: Plug power cord to V1 here. Lighter Adapter Changing the Lighter Adapter Fuse Slide Fuse Ejector along its channel to eject fuse. A firm push will be needed. Replace with 2 amp, Mini Blade Fuse. Push Fuse Ejector towards fuse to eject. 22