User manual LINKSYS EPSX3 - INSTALL GUIDE

Making Connectivity Easier TM Instant EtherFast® Series EtherFast 10/100 PrintServers ® Model No.: EFSP42 ver. 2, EPSX3, PPSX1 Quick Installation For All Windows Operating Systems This sheet will guide you through the basic steps needed to install any of the EtherFast® 10/100 PrintServers onto your network. If you have any problems during installation, refer to the Troubleshooting section of the User Guide. Overview After installing the PrinServer hardware onto your network, you will need to install the PrintServer Driver software. For information on hardware installation or if you experience any difficulty, refer to your User Guide. Note: To set up DHCP on the PrintServer, install Bi-Admin first (see page 37 of the User Guide), then install DHCP (see page 57 of the User Guide), then proceed to install the Printer Driver. 3. Click Next to accept the Destination Directory default, shown below. W indows Driver Setup 1. Click on Start, Run, and enter D:\Driver\Win9xnt\Setup.exe. Click OK. 4. The Select Components window appears. If your computer is the network administrator's computer, check Install TCP/IP Setup Program (System Administrator only). Otherwise, select the default, Install Linksys PrintServer Driver. Click Next. 2. The Install Wizard window appears. Click Next. Continued on back... QI-EFSP42v2-10720A DG 5. Accept the default Program Folder. Click Next. The window below will appear as the files are copied to your computer. 7. On the network administrator computer only, click Start, Programs, Linksys PrintServer Driver, and TCPIP Setup to set up your PrintServer's IP address. 6. Before the file copy finishes, the Configure PrintServer window will pop up again as a pre-test. Click Cancel to complete the file copy. To check for your successful file copy, click on Start, Programs, Linksys PrintServer Driver, and check to see that TCPIP Setup is on its subfolder. 8. In the Device Name field, enter the PrintServer's 8-digit Default Name written on page 10 and the white barcode sticker on your unit. The example settings below for the PrintServer Settings and the Network Administrator Computer Settings show how the settings have been set for the picture in step 7. If you are not sure what settings to use, see your network administrator. Printserver Settings Device Name: SCA71107 IP Address: 10.0.0.2 Subnet Mask: 255.255.255.0 Gateway: 0.0.0.0 (optional) Network Administrator Computer Settings IP address: 10.0.0.1 Subnet Mask: 255.255.255.0 9. When you are finished entering the values for the IP address, Gateway address (optional), and the Subnet Mask, click Set Device. The Windows PrintServer driver installation is complete. Refer to the section on Windows Port Configuration section for your operating system of your User Guide for more information about the setup of the Printserver. If you are setting up the network administrator's computer, finish steps 7 to 10. Otherwise, if you are simply installing this on a network user's computer, skip steps 7 to 9 and proceed to step 10 to finish this section. QI-EFSP42v2-10720A DG