User manual GATEWAY 46 - INSTALLATION GUIDE

ATTACHABLE SPEAKERS Instruction Manual Thank you for purchasing the attachable speakers. Before using this product, please read this instruction manual thoroughly so that you can use this product at its full functionality. After reading, retain this manual in an easily accessible location so that you can refer to this manual whenever you have a problem or trouble during use. This product is exclusively for use with 46-inch plasma monitors. Care and Maintenance · When the cabinet gets dirty . . . Wipe with a lint-free, soft, dry cloth. If the cabinet is seriously stained, soak a cloth in a neutral detergent solution, wring well and, after wiping remove moisture by wiping with a dry cloth. If you want to use a chemical cloth for cleaning, read well the caution provided with the chemical cloth product. · Do not use solvent such as thinner or benzine for cleaning. Otherwise the surface finish will be deteriorated or the coating will be stripped off. · To remove dust from the speaker nets, use a brush adapter of a cleaner. Avoid applying the cleaner inlet directly without using a brush adapter or using a nozzle adapter. · To prevent damage to the cabinet and speaker nets, do not scratch or hit them with a fingernail or other hard object. Also do not stab the speaker nets with a sharp object to prevent making a hole. Do not apply volitle agents such as insecticide on the cabinet or leave a rubber or vinyl product in prolonged contact with it. Otherwise the surface finish will be deteriorated or the coating may be stripped off. This speaker is of an antimagnetic design. However, depending on its placement, for example, bringing the speaker into the vicinity of a monitor other than a plasma monitor, the speaker may cause irregular color or other effects. Should this occur, please move the speaker away from the monitor. Note Specifications Checking the Package Contents Make sure the following items are included in the delivery package. If any of the following items are missing or defective, immediately contact your dealer. Type: Passive radiator design/2-Way system Impedance: 8 Rated input: 10 W Maximum input rating: 15 W Dimensions (W×H×D): 100 × 781 × 76.8 mm (including stand) 100 × 721 × 76.8 mm (without stand) M4×10 Screw (8) Base (2) Steel Bracket (4) M4×30 Screw (4) Weight: 3.1 kg (one speaker - including stand) 2.1 kg (one speaker - without stand) · The design and specifications are subject to change without notice. st In ct ru n io M ua an Speaker unit (2) (2.2M×2) (0.3M×2) Instruction Manual Connection Cord CONNECTIONS 1. Installing the speakers When using a base Tighten the screws to fasten the speaker unit to the base. 2. Temporarily tighten the included screws in the screw holes on both the left and right sides of the monitor and hook on the monitor mount fittings hook on both sides. Fully tighten the screws on both sides to connect the monitor and the speakers. Speaker unit Press in the speakers gently while tightening the screws. M4×30 Screws (2) 2. Connecting the cords When mounting on the monitor 1. Insert the steel brackets into the slots in the speaker unit on the diagram below and fasten them with the included screws. M4x10 Screw (x4) Steel breaket Turn the power of the equipment to be connected before connecting it. Use the provided connection cords. There is polarity ­ + with the conductor of each connection cord. Connect each conductor to the correct terminal. Black Red Speaker terminals M4×10 Screws (4) Black Red Speaker terminal Monitor terminal Steel brackets Monitor terminals While holding the button of each speaker terminal, insert a conductor of the connection cord.