User manual GATEWAY SOLO 1450 - Install Guide

Installing a Solo 1400/1450 CD, CD-RW, DVD, or DVD/CD-RW drive This package includes a CD, CD-RW, DVD, or combination DVD/CD-RW drive for your Solo 1400 or Solo 1450 notebook and these printed instructions. Tools you need You need a small Phillips and small flat blade screwdriver to install the drive. Preventing static electricity discharge The components inside your computer are extremely sensitive to static electricity, also known as electrostatic discharge (ESD). Caution ESD can permanently damage electrostatic discharge-sensitive components in the computer. Prevent ESD damage by following ESD guidelines every time you open the computer case. Warning To avoid exposure to dangerous electrical voltages and moving parts, turn off your computer and unplug the power cord and modem and network cables before opening the case. Before installing the drive, follow these guidelines: I I Turn off the computer power. Wear a grounding wrist strap (available at most electronics stores) and attach it to a bare metal part of the computer. Warning To prevent risk of electric shock, do not insert any object into the vent holes of the notebook. I I I Touch a bare metal surface on the back of the computer. Unplug the power cord and modem and network cables. Remove the battery. www.gateway.com Before working with computer components, follow these guidelines: I I Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam. Remove components from their antistatic bags only when you are ready to use them. Do not lay components on the outside of antistatic bags because only the inside of the bags provide electrostatic protection. Opening the keyboard compartment To open the keyboard compartment: 1 2 3 Follow the guidelines under "Preventing static electricity discharge" on page 1. Shut down your notebook. Unplug the AC adapter and modem and network cables. Warning To avoid injury, disconnect the AC adapter and modem and network cables before removing the keyboard. Replace the keyboard before reconnecting power. 4 5 Remove the battery. Open the LCD panel to the normal viewing position. 2 www.gateway.com Installing a Solo 1400/1450 CD, CD-RW, DVD, or DVD/CD-RW drive 6 Insert a small flat blade screwdriver under the bottom-right corner of the keyboard bezel, between the INS and DEL keys, and gently pry it up. Important Inserting a piece of cloth between the screwdriver and keyboard and notebook case will help prevent damage to your notebook. www.gateway.com 3 7 Pull the bezel off the notebook. You will hear small snapping sounds as the bezel comes off the notebook. Be careful not to break off the tabs located on the left end of the bezel. 4 www.gateway.com Installing a Solo 1400/1450 CD, CD-RW, DVD, or DVD/CD-RW drive 8 With a small Phillips screwdriver, remove the two keyboard screws and put them in a safe place. www.gateway.com 5 9 10 Raise the back edge of the keyboard slightly, then carefully slide the keyboard back until the five tabs on the front edge of the keyboard are free from their slots. Slowly rotate the keyboard toward you so it lies keys-down on top of the notebook. Be careful not to damage the LCD panel. 6 www.gateway.com Installing a Solo 1400/1450 CD, CD-RW, DVD, or DVD/CD-RW drive www.gateway.com 7 Replacing the drive To replace the drive: 1 With a small Phillips screwdriver, remove the two drive screws and put them in a safe place. 8 www.gateway.com Installing a Solo 1400/1450 CD, CD-RW, DVD, or DVD/CD-RW drive 2 Slide the existing drive out of the notebook. www.gateway.com 9 3 Slide the new drive into the same bay that the existing drive was located in. The drive is inserted properly when the logo on the drive door is right side up. 10 www.gateway.com Installing a Solo 1400/1450 CD, CD-RW, DVD, or DVD/CD-RW drive 4 Replace the two drive screws. www.gateway.com 11 Attaching the keyboard To attach the keyboard: 1 2 Rotate the keyboard toward the LCD panel until the keyboard is almost face-up. Insert the five tabs locate at the front edge of the keyboard into the corresponding slots under the palm rest. 3 Gently press the keyboard down until it is flat all the way across. The keyboard should easily fall into place. Be careful not to damage the LCD panel. 12 www.gateway.com Installing a Solo 1400/1450 CD, CD-RW, DVD, or DVD/CD-RW drive 4 Replace the two keyboard screws. 5 Slide the two tabs located on the left end of the bezel under the notebook frame. www.gateway.com 13 6 Press down on the bezel in several places until it clicks in place. The bezel is correctly mounted when you can run you finger along the bezel and find no loose spots. The bezel should be flat all the way across. If the bezel is mounted incorrectly, complete the instructions under "Replacing the bezel" on page 15. Warning If the bezel is not correctly replaced, your notebook could be damaged when you try to close the LCD panel. 7 8 9 Replace the battery. Plug in the AC adapter and modem and network cables. Turn on the notebook. 14 www.gateway.com Installing a Solo 1400/1450 CD, CD-RW, DVD, or DVD/CD-RW drive Replacing the bezel If the bezel was mounted incorrectly, complete the following procedure. Warning If the bezel is not correctly replaced, your notebook could be damaged when you try to close the LCD panel. To replace the bezel: 1 Insert a small flat blade screwdriver under the bottom-right corner of the keyboard bezel, between the INS and DEL keys, and gently pry it up. Important Inserting a piece of cloth between the screwdriver and keyboard and notebook case will help prevent damage to your notebook. 2 3 Pull the bezel off the notebook. You will hear small snapping sounds as the bezel comes away from the notebook. Be careful not to break off the tabs located on the left end of the bezel. Slide the two tabs on the left end of the bezel under the notebook frame and press down on the bezel in several places until it clicks in place. Technical Support Refer to your user's guide for Gateway Technical Support information. Safety, Regulatory, and Legal Information Refer to your user's guide for important safety, regulatory, and legal information. © 2002 Gateway, Inc. All rights reserved. Gateway, Gateway Country, the Gateway stylized logo, and the black-and-white spot design are trademarks or registered trademarks of Gateway, Inc. in the United States and other countries. All other brands and product names are trademarks or registered trademarks of their respective companies. www.gateway.com 15 MAN US RPL SL1450 OPTC DRV R0 04/02 16 www.gateway.com