User manual SEKONIC L-308S FLASHMATE - QUICK GUIDE

L-308S Quick Guide POWER BUTTON (ON/OFF SWITCH) POWER LUMISPHERE MEASURING BUTTON MODE MODE BUTTON FLASH FLASH W/CORD DAYLIGHT DAYLIGHT UP BUTTON ISO DOWN BUTTON ISO BUTTON · PRESS ISO BUTTON DOWN WHILE USING UP/DOWN BUTTONS TO SELECT ISO. , TO CHANGE · IN AMBIENT MODE BETWEEN F-STOP AND EV MEASUREMENTS, HOLD DOWN THE ISO BUTTON AND PRESS THE MODE BUTTON. FLASH SYNCHRO TERMINAL WHEN CORD IS ATTACHED PUSH MEASURE BUTTON TO TRIGGER FLASH AND MEASURE LIGHT LCD SCREEN Battery Indicator Shutter Speed, f.p.s. Display Measuring Mode ISO Display Aperture Value, EV Display L-308S Basic Operation Set ISO While holding down ISO button, press the Up/Down buttons. Use as Reflected Meter Slide Lumisphere away to expose meter cell. Use as Incident Meter Slide Lumisphere over meter cell. Measure Brightness /Contrast Difference Clip in flat Lumidisc over meter cell. Ambient Reading Select Ambient Mode, press Measuring button. Cordless Flash Reading Select Cordless Flash Mode, press Measuring button to manually trigger the flash. Flash Reading Using Flash Cord Select Flash with Cord Mode, connect flash synchro cord into PC socket and press the Measuring button. EV Reading Select Ambient EV Mode. In Ambient Mode, change between F/Stop and EV readout by holding down ISO button and pressing Mode button. To Set Increments of Reading 1.Turn power off. 2.Press down Mode button while turning on meter. 3.Press Mode button to select Full, 1/2 or 1/3 f-stop increment reading. 4.Turn power off and then back on to activate functions.