86037_3.fm Page 1 Tuesday, November 19, 2002 7:55 AM ST60 Setup & Operation Cue Card Introduction This cue card provides a quick reference guide to the operation and calibration features of the ST290 Tridata instrument. Unless stated otherwise, all key presses are momentary. Operation Current depth Boat speed Log Trip Shallow alarm threshold Maximum speed Water temperature 1s to Reset 2s to Reset Count-up timer Deep alarm threshold Average speed 1s to Reset Race start timer 1 VMG to windward Anchor shallow alarm threshold Race start timer 2 2s to Reset 1s to Reset 1s to Reset Anchor deep alarm threshold To adjust a timer, simultaneously press AND to enter Adjust mode. In Adjust mode, use OR to set timer value. To leave Adjust mode, simultaneously press AND 86037_3.fm Page 2 Tuesday, November 19, 2002 7:55 AM ST60 Setup & Operation Cue Card Illumination Enter Illumination Mode Hold down for 1 second Press repeatedly to cycle through settings Alarms Switch On/Off Hold down for 2 seconds Enter & Exit Adjust Mode Momentary while alarm value is displayed Adjust Increase value Calibration User Calibration Depth Depth Units Depth Offset Shallow Alarm Lock Speed Speed Units Speed Resolution Log Units Speed Calibration (SOG or manual) Temperature Units Temperature Calibration Time Beep (On/Off) Intermediate Calibration Software Version Master/Repeater Selection (manual setting) Speed Calibration (auto) Dealer Calibration User Calibration (On/Off) Speed Response (Fast/Slow) Depth Response (Fast/Slow) Boatshow Mode (On/Off) Factory Defaults (On/Off) Decrease value User Calibration Mode 2 seconds Intermediate Calibration Mode 4 seconds Exit Calibration Mode & Save Changes 2 seconds Dealer Calibration Mode then 12 seconds Document number 86037_3 (to be used with handbook: 81040_4) Date: 1st December 2002 ...