User manual JABRA BT2040 - QUICK START GUIDE

quick start 7-5 8/1/07 1:17 PM Page 1 2 1 3 WARNING! Headsets are capable of delivering sounds at loud volumes and high-pitched tones. Exposure to such sounds can result in permanent hearing loss damage. The volume level may vary based on conditions such as the phone you are using, its reception and volume settings, and the environment. Please read the safety guidelines below prior to using this headset. SAFETY GUIDELINES 1. Prior to using this product: Before putting on the headset, turn the volume control to its lowest level, put the headset on, and then slowly adjust the volume control to a comfortable level. 2. During the use of this product: Keep the volume at the lowest level possible and avoid using the headset in noisy environments where you may be inclined to turn up the volume; If increased volume is necessary, adjust the volume control slowly; and If you experience discomfort or ringing in your ears, immediately discontinue using the headset and consult a physician. With continued use at high volume, your ears may become accustomed to the sound level, which may result in permanent damage to your hearing without any noticeable discomfort. Using the headset while operating a motor vehicle, motorcycle, watercraft or bicycle may be dangerous, and is illegal in some jurisdictions. Check your local laws. Use caution while using your headset when you are engaging in any activity that requires your full attention. While engaging in any such activity, removing the headset from your ear area or turning off your headset will keep you from being distracted, so as to avoid accident or injury. 4 1 2 3 4 5 5 Light indicator (LED) Answer/end button Removable earhook Battery lid (backside) Battery 1. PUTTING THE BATTERY INTO THE HEADSET To put the battery into the headset, slide the lid on the backside off, place the battery in the headset, and slide the lid back on. CAUTION: Always place the battery in your BT2040 as illustrated in Step 1 at left. Placing the battery in upside down can result in the device overheating. If your device becomes warm remove the battery and check whether the battery was inserted properly. If the battery is inserted upside down, the headset will not work, but it will still overheat the device and wear out the battery quickly. FCC This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Users are not permitted to make changes or modify the device in any way. Changes or modifications not expressly approved by Jabra (GN Netcom) will void the user's authority to operate the equipment. IC Operation is subject to the following two conditions: (1) This device may not cause interference and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The term "IC:" before the certification/registration number only signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment. TURNING YOUR HEADSET ON AND OFF 3 Seconds 5 Seconds ©2007 GN US Inc. All rights reserved. Jabra® is a registered trademark of GN A/S. All other trademarks included herein are the property of their respective owners. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by GN US Inc. is under license. (Design and specifications subject to change without notice.) www.jabra.com Type: BT2040 MADE IN CHINA PARTNUMBER 81-01910 REVA QUICK START GUIDE quick start 7-5 8/1/07 1:17 PM Page 2 2. PAIRING THE HEADSET WITH YOUR PHONE 1a. FIRST TIME PAIRING: 3 Seconds Turn headset on ­ automatic pairing mode 1b. LATER PAIRING: Turn headset off ­ press and hold until solid light comes on 5 Seconds 2. Activate Bluetooth on phone. 3. Press "YES" on the phone and confirm with PIN code: 0000 (4 zeros). Connectivity MobilSurf Bluetooth Infrared Port WAP options Synchronization Networks Select Info Devices found Jabra BT2040 Passkey: Jabra BT2040 Jabra BT2040 Added. The handsfree is now ready for use Ok **** Select Ok 3. USING YOUR HEADSET ANSWER CALL: Tap the answer/ end button. <0.5 Second <0.5 Second END CALL: Tap the answer/ end button. 360° 4. WEARING STYLE Without earhook Optional earhook can turn 360° For optimal performance, wear the Jabra BT2040 and your mobile phone on the same side of your body or within line of sight. Register your Jabra at jabra.com/myjabra for news, support and competitions. CUSTOMER CONTACT DETAILS: WEB: www.jabra.com (for the latest support info and online User Manuals) E-MAIL: Tech Support: techsupp@jabra.com Information: info@jabra.com