009-0214-01 Don't Look Into The Lens! Be extremely careful not to look directly into the lens when the 210 is on. The bright light can harm your eyes. Be especially careful to keep children from looking into the lens. SAFETY SUMMARY: Please read these instructions before using your LitePro 210. Failure to comply could result in fire, electrical shock, personal injury or equipment damage. Don't Disassemble Do not open the 210 case! Doing so exposes you to an electric shock hazard. Except for the projection lamp, there are no user-serviceable parts. All service must be performed by an In Focus Systems Authorized Service Provider. Avoid Hot Surfaces The inside of the 210 lamp housing can be very hot. Allow the 210 to cool for at least 45 minutes before opening the lamp door to replace the lamp. Use extreme care. Avoid touching the hot surfaces inside. Use Only The 210 Power Cord Definition of Safety Icons on Product Labels Always use the power cord that came with the 210. Although other cords might look the same, they have not been safety-tested with the 210. Never use the power cord if it's damaged or frayed. When you disconnect the 210, always remove the power cord from the electrical outlet first, then from the 210. Don't Defeat The Purpose Of The Grounding Plug Refer to the User's Guide for more information. The 210 is grounded through the grounding conductor on the power cord. To avoid electric shock, plug the power cord into a properly wired receptacle. Use The Correct Fuse To avoid the risk of fire, use only a T6.3AH 250V 5x20mm fuse. Avoid Liquid Spills Avoid hot surfaces. Don't set drinks on top of the 210. Spilled liquids can flow inside causing damage. Don't Block Ventilation Openings in the case provide ventilation to protect the 210 from overheating. Keep loose papers and other objects away from the bottom, top and side grills. Don't place the 210 on top of or close to a computer or other heat-producing equipment. Bulb explosion hazard. ...