User manual DELPHI ROADY 2 SA10109-11P1 - Quick Start

Using Your Roady2 Personal Audio System Tuning XM Channels Switch to XM mode, then use your Roady2 controls as usual. white logo Volume It's best to change the volume using the joystick controls, but you can also use the volume control on your headset, or on the Roady2 unit itself. Personal Audio System Tuning FM channels Switch to FM mode, then move the joystick to change channels. A short tap and release will tune to the next station. Hold in either side for one second and release it to seek until an FM station is found. Tap the joystick anywhere to stop. Quick Guide For Use With Roady2TM Satellite Radio Receiver white logo white logo FM button Delphi Corporation 1441 West Long Lake Road · Troy, Michigan 48098-5090 U.S.A. Customer Service: [1] 877.GO DELPHI Volume control www.delphi.com www.shopdelphi.com The Roady2 name, XM name, and related logos are trademarks of XM Satellite Radio Inc. © 2004 Delphi Corporation. All rights reserved. DPSS-04-E-069 Channel control Setting up Your Roady2TM Personal Audio System Note: Before using your Roady2 Personal Audio System for the first time, it is recommended that you fully charge the battery. See your Roady2 Personal Audio System User Guide for more information. Mode switch Important Things to Know Display The Roady2 Personal Audio System display shows the mode (FM or XM), FM station, battery charge indicator, and volume. (XM channels appear on your Roady2 display.) Step 1: Push down the latches on both sides. Step 3: Gently place your Roady2 into the docking station and slide the tray back in until latches click. Step 5: Slide the mode switch to XM or FM. Important: For Roady2 operating instructions, consult the Roady2 User Manual that came with your Roady2. Headset Your Roady2 Personal Audio System headset not only produces great sound, it contains a built-in antenna. Keep the antenna in line of sight with the satellite for best reception. You can adjust the volume with the control on the right side. Backlight Any time you adjust the controls or change modes, the blue LED backlight comes on so you can easily read the display. Battery pack To recharge the battery, plug the AC adaptor into the unit with the battery in place. The Lithium Ion battery will fully charge in about two hours when the unit is turned off, but you can charge it while using it. The indicators at the upper left part of the display indicate the state of the battery. Step 2: Slide the tray out. Roady2 setup See page 5 of your Roady2 User Guide for important setup information. Step 4: Plug in your headset. Caution: Turn down the volume before using headset to avoid ear damage. Step 6: Remove your Roady2 by pushing down the latches on both sides and sliding the tray outward.