Support for VISCA-compatible Cameras The Polycom® iPowerTM 9000 system provides support for the VISCATM command protocol. This capability allows users to control VISCA-compatible cameras from the iPower system interface. Supported Cameras The following VISCA-compatible cameras have been tested and support the controls listed in the section "Supported Functionality." Sony EVI-D30 Sony EVI-D31 Sony EVI-D100 Sony EVI-D101 To connect the camera to the iPower system, use the control cable adapter (part number 1457-50527-001). To order this cable, contact Polycom and request order number 2200-51000-001. Supported Functionality VISCA-compatible cameras support the following iPower camera controls: Pan Tilt Zoom Brightness Presets Copyright © 2002 Polycom, Inc. Polycom and the Polycom logo are registered trademarks of Polycom, Inc. iPower is a trademark of Polycom, Inc. VISCA is a trademark of Sony Corporation. Edition: 3725-50564-001/A *P3725-50564-001* Restrictions Note the following restrictions when using VISCA-compatible camera with the iPower 9000 system: Hardware Diagnostics does not detect the Sony D30 and D100 cameras. You cannot test these cameras using Hardware Diagnostics. Daisy-chaining of cameras is not supported. If you configure a Pan, Tilt, or Zoom preset for a Sony D30 camera for the minimum or maximum positional setting, the preset may not work reliably. Additional Information For the latest information and updates, use your Web browser to go to the Polycom Web site, www.polycom.com. 2 ...