DVD/VCD/CD/MP3/MPEG4/XVID CAR RADIO WITH 7" SCREEN USB/SD/MMC INTERFACE ESP ANTI-SHOCK SYSTEM AM/FM RDS-TA/AF/PTY 160 WATT POWER DETACHABLE PANEL USER MANUAL AND INSTALLATION INSTRUCTIONS CONTENTS CONTENTS PRECAUTION .................................................................................................................. GB 1 ............................................................................................................... GB 3 ACCESSORIES ............................................................................................................... GB 2 INSTALLATION/REMOVAL AND ELECTRICAL CONNECTIONS DUAL ZONE MODE SETUP.................................................................................................. GB 5 FRONT PANEL ............................................................................................................... GB 9 BASIC OPERATION ....................................................................................................... REMOTE CONTROL .................................................................................................... TOUCH SCREEN CONTROLS.......................................................................................... RADIO OPERATION ....................................................................................................... DVD/VCD/CD/MP3/MPEG4/XVID OPERATION DVD SETUP ........................................................................................................... GB 10 GB12 GB17 GB21 GB34 GB39 GB41 .................................................................. GB24 TECHNICAL SPECIFICATIONS ........................................................................................ TROUBLESHOOTING ....................................................................................................... -GB 1- ACCESSORIES Mounting Bracket x1 (already mounted on the unit) Removable Trim Ring X1 (already mounted on the unit) Small metal strip x 1 Washer x 1 Nut x 1 Rubber X1 Remote Control X1 Release key X2 AV in Cable x1 VOL/SEL + ISO Wire connector X1 Removable control panel X1 (Already mounted on the unit) User manual X1 USB cable X1 screws X 4 -GB 2- PRECAUTION This unit is designed and manufactured with the user's safety in mind; however any improper use or operation may result in certain dangers. It is therefore highly recommended to read this manual thoroughly and adhere to the following precautions. SAFETY PRECAUTIONS To prevent an electrical shock, do not open the housing of the unit. In any case of malfunctioning, only have the unit serviced by an approved and qualified service centre. Do not expose to any water or to a very humid environment. Do not operate the unit when your hands are wet as this may cause a short circuit. For safe driving, keep the volume low in order to concentrate on traffic conditions. Do not clean the unit with alcohol, only clean with a soft dry cloth. If the unit has been kept at a high temperature or in a high humidity environment, cool down the car interior before turning on the unit. Do not use the unit for a long time without running the vehicle engine, as this may drain the battery and the vehicle's engine may not be able to start. Before final installation in the dashboard opening, connect the wiring and make sure the unit is working properly. Only use parts provided with the unit to ensure proper installation. Do not route wiring in places that the heat may melt the wiring insulation. When replacing the fuse, ensure that the new fuse has the capacity recommended by the manufacturer. -GB 3- PRECAUTION OPERATION PRECAUTIONS Do not operate the player with scratched, bent or broken discs. When a disc is not loaded properly, do not force it into the disc loader. Never insert any other objects into the disc loader like a coin or pin, etc as this may cause damage or a short circuit. Do not use different disc formats other than 8 cm or 12cm round discs. Please dispose of used batteries according to the regulations in your country. If the unit is disconnected to the battery, it will lose memorized data. If the source disc has poor sound quality due to scratches, dirt or a bad recording, the playback sound quality may be poor. Remote control: * Do not let the remote control fall onto the floor, where it may become jammed under the brake or accelerator pedals. * Do not short-circuit, disassemble or heat the battery. * Do not dispose of the battery in a fire. * Dispose of used batteries properly. IMPORTANT: Please adjust the touch effect on the TFT screen when you use the unit for the first time. (For more details, please refer to "SYSTEM SETUP ­ 5. SYSTEM: Touch Adjust".) -GB 4- INSTALLATION/REMOVAL AND ELECTRICAL CONNECTIONS NOTE: The unit should be installed horizontally (do not go beyond an angle of over 30° from to the horizontal) Before the final installation, first complete the electrical connections. DIN FRONT-MOUNT Installation of the unit 1. Metal Sleeve Install the metal sleeve in the dashboard. For optimum performance of the CD player, the unit should be positioned as horizontally as possible (do not go beyond 30° from the horizontal). Fix the metal sleeve into place by pushing the metal tabs outwards using screwdriver. Then complete the electrical connections (page 7) 2. Front Mounting Slide the main unit into the metal sleeve until the springs at either side of the radio snap into the sleeve openings. 3. Removing the Radio Insert the release keys supplied with the unit into the grooves at both sides of the unit until you hear a click sound. Then remove the unit from the dashboard by pulling the release keys towards you. -GB 5- ATTACHING & REMOVING THE DETACHABLE FRONT PANEL Removing the detachable front panel Press the REL button to unlock the front panel. Push the front panel to right and pull the left side of the front panel away from the unit, as shown in the figure Attaching the detachable front panel First insert the right side of the front panel as shown in the figure and gently push the left side of the front panel onto the unit until you hear a click sound, which confirms that the front panel is firmly attached. Note: Remove the protective plastic film from the screen in order to ensure optimum use of the touch screen. -GB 6- ELECTRICAL CONNECTIONS Most vehicles are fitted with ISO connectors behind the dashboard, which makes it easier to connect your car radio. These connections can be found in the dashboard where the car radio will be fitted. Use these cables to connect the car radio. If your car is not fitted with these ISO connectors, we strongly advise you to consult your car dealer or a specialist to obtain the right adaptor. Once you have these cables, you will need to connect your loudspeakers and the power supply to the ISO connector, following the connection instructions below. -GB 7- NOTES: INCORRECT CONNECTIONS OR USE WILL VOID THE WARRANTY. The manufacturer cannot be held responsbile if the unit malfunctions due to incorrect connections. - For safety reasons, the brown wire must be connected to the parking brake contact in order to activate the video display on the unit's screen. The video display is activated permanently on the rear monitor. - It is possible to connect a reversing camera (composite video) to the input provided for this purpose. In order to activate the reversing camera display, please also ensure that the orange cable is connected to the reversing contact or reversing light so that the unit automatically enters reversing camera mode when the reverse gear is engaged. DUAL ZONE mode setup This unit is equipped with a DUAL ZONE mode which allows the user, when one or two rear monitor(s) are (is) connected, to simultaneously obtain DVD, USB, SD or AUX mode on the rear monitor and radio mode on the unit. In this case, the DUAL AUDIO OUT output must be used to obtain the sound for the DVD, the USB device, the SD card or auxiliary source on the rear monitor. Main source and source selected to display on the rear monitor(s) (refer to the "SYSTEM SETUP" section) In any source menu, press the icon located at the top left of the screen to display the system setup menu. Next, press the source directly to select the front or rear zone. 1. When the unit is in radio mode, you can select any source for the rear monitor. 2. When the unit is in a mode other than radio mode, the rear monitors will display the same source as the one selected on the unit. Controlling the unit or rear monitor Press the IR-F/R button on the remote control to control the unit or the rear monitor. Note: This function is switched off when the rear monitor is not available. -GB 8- FRONT PANEL -GB 9- BASIC OPERATION 1. TA (Traffic Announcement) In radio mode, press the TA button to turn the traffic announcement function on /off. 2. PTY (Program Type) In radio mode, press once to seek a station by program type. Press it repeatedly to select a program type. 3. LCD screen 4. REL button Press this button to unlock the detachable front panel. 5. VOL/SEL+/- button Adjust the volume by turning the button clockwise or counter clockwise. Press this button briefly to display the menu. You can choose one of the following settings: L-front/R-front/L-rear/R -rear/ Sub woof / Bass / Middle / Treble / TILT / Volume. Rotate the button to adjust the desired settings. 6. IR window Receives the infrared signal from the remote control. 7. POWER/MUTE Press this button to turn on the unit. Press and hold down the button for 1 second to turn off the unit. When the unit is switched on, press the button briefly to shut off the sound output. Press it again to resume the previous sound level. 8. buttons In radio mode, press one of these buttons to seek a station automatically. Hold down one of the buttons to seek a station manually. In DVD/USB/CARD mode press these buttons to select the previous or next file. Hold down the button for 2 seconds to fast forward or fast rewind. 9. Disc Loading Slot 10. BAND/ In radio mode, press this button repeatedly to select the one of the following frequency bands: FM1/FM2/FM3/MW1/MW2. In play mode, press this button to pause or resume playback. 11. MODE button Press this button to select one of the following sources: RADIO/DVD/SD/USB/AV1/AV2. -GB 10- , 12. AV IN (audio/video in) Connect the jack on the AV cable (supplied) to the AV IN input on the detachable front panel of the unit. You can then connect an external audio/video device to this adaptor, using a suitable A/V cable if necessary, then press the MODE button to switch to AV1 mode. BASIC OPERATION 13. SD/MMC card slot Insert an SD/MMC card. The unit will read the files from the SD/MMC card automatically. NOTE: If the unit does not eject the SD/MMC card when it is pressed, just pull it out manually. 14. AF/DISP button (alternative frequencies/information display) In radio mode, press this button to turn the alternative frequencies function on/off. Hold down this button to display the following information: the current time, source selected for the main display, source selected for the front and rear displays and available media. 15. OPEN Press to open or close the TFT screen. 16. Press the button to eject a disc when it is loaded into the unit. Press this button for a longer time to force the disc to eject if there is a malfunction while the disc is loading. 17. USB port Insert a USB device, and the unit will automatically play the files on the device. 18. Anti-theft LED indicator This indicator will flash when the detachable control panel is removed. 19. RESET Insert a sharp object such as a pencil into the RESET button to reset the unit. 20. TFT touch screen 21. / - TILT+ Press one of these buttons to adjust the angle of the TFT screen. 22. SETUP In DVD mode, press the button to display the DVD setup menu. Hold down this button to display the system setup menu. In other modes, press the SETUP button to display the system setup menu. -GB 11- REMOTE CONTROL 10. PROG/A-B (program/repeat A-B) 11. EQ (equalizer) 12. 0-9, 10+ number buttons 13. DISP (display) 14. (Eject) 15. IR-F/R (front/rear in Dual Zone mode) 16. SETUP 17. SUB-T/LOC (subtitles/local stations) 18. MENU 19. (play/pause) 20. /PTY (slow/program type) 21. ST/AUDIO (stereo/audio) 22. ZOOM/AF (zoom/alternative frequencies) 23. LOUD (loudness) 24. RDM/TA (random/traffic announcement) 25. RPT/CLEAR 26. GOTO Installing the battery Slide the tray out on the back of the remote control and insert the battery with polarity (+) on top as shown. 1. 2. 3. 4. 5. 6. 7. 8. 9. POWER MODE BAND/P/N (band/TV system: PAL/NTSC) AMS/ANGLE (store stations automatically/angle TITLE [ / ] [ / ] [///]/ENTER (Stop) VOL- /VOL+/SEL (select) MUTE Use and care of the remote control Point the remote control to the IR window on the detachable front panel for operation. Notes: -GB 12- Using the battery incorrectly can cause malfunc ...