Wiring for Entry/Exit Readers ACTPro Product Range 1030/1040/1050/1060 ACT1050 Pin and Proximity Reader (Entry) 1 2 3 Wiring for Clock and Data / Wiegand Reader White Green Blue Red Black Brown Yellow Orange Sense Clock / Data1 Data / Data 0 +5v 0v Red Led Grn Led (Buzzer Ctrl) 4 5 6 Controller 7 8 9 0 ACT1030 Proximity Reader (Exit) Sense Clock Data +5v 0v Red Led Grn Led Wire both readers in parallel but leave the SENSE line on the Exit reader unconnected. For Wiegand readers . Wire both readers in parallel but connect D0 line of the exit reader into the SENSE line on the controller,leave the SENSE line on the Exit reader unconnected. B A T C H: S E R IA L The above diagram is valid only for clock-and-data type readers. The +5V reader supply on ACT controllers is normally rated at 100mA. Typically this is sufficient to power 2 ACT readers. Note however that readers from other manufacturers may need to be powered separately if their current requirements exceed this or if they require 12V. Card/Prox Reader The standard wiring colours for ACTPro Proximity and Pin readers is shown above. Readers should be a maximum of 30m from the controller when powered from +5V and a maximum of 100m when powered from +12V. 02X X -1 P R ODUC T : AC T P ro R E V 1.3 NUMB E : 00X X X X R 0123456789 1A 125V AC 1A 30V DC Rear view of ACTPro 1040/1050/1060 connected to the ACT2000/1000/DS100 0V R ed L E D G rn L E D B uzz C trl 5-12V dc Data / D0 C lock / D1 Sense Downloaded from: http://www.guardianalarms.net U nit 8 Tallaght B usiness Centre, W hitestown, Tallaght, Dublin 24, Ireland. Telephone: 353 1 462 2585. Telefax: 353 1 462 2587. E-mail: sales@ accesscontrol.ie W eb: www.accesscontrol.ie OMR ON 5A 250V AC 5 A 3 0 V DC OMR ON Internal buzzer is activated by applying 0V to Buzz Ctrl Fig 1 Mounting instructions for flush mount unit Spacers break away from main component when required by installer for use. View showing spacers stacking Standard pattress box. SCREWS View showing mounting plate before spacers are broken away by installer. Note: Determine the distance between the pattre and the mounting plate, using the spacers are labeled 1mm to 4mm. This allows the installer to make the required spacer leng 10mm by stacking each spacer together. Security screw supplied with the unit. Mounting plate is attached to the pattress box using the screws supplied, ENSURE the corect spacers have been used to bridge the gap between the mounting plate and the fixing wings of the pattress box to avoid the mounting plate being distorted. Place the cap onto the unit and push firmly into place. Place the Reader / Keypad onto the surface mount collar and clip down into place.Use the security screw supplied to attach the unit to the surfce mount collar. Fig 2 Mounting instructions for surface mount unit Security screw supplied with the unit. The surface mount collar is mounted on the wall using the fixing kit supplied in the box. Place the Reader / Keypad onto the surface mount collar and clip down into place.Use the security screw supplied to attach the unit to the surfce mount collar. Place the cap onto the unit and push firmly into place. ...