ACTSmart Controller Installation 3metres Direct Connect Cable (Supplied) Power Supply Unit ACTSmart Controller OP3 OP4 0V IP1 IP2 IP3 DTR RX TX 0V SERIAL NETWORK B A OP1 OP2 ACTWinSmart Software 5A 250VAC 5A 30VDC +12V 0V TAMPER MAINS PRESENT + 12V DC - A B 0V SLAVE GREEN CLOCK SENSE DATA N ADDRESS RED +5V 0V On Note: Tamper and Mains Present are not used. 12V = DC 5A/250V ~AC Continue daisy chain to remaining ACTSmart2 units (maximum 8). Programmable Input RELAY A Aux I/O 2 Aux I/O 1 Shield LED Functionality: Red LED indicates the status of communications with the PC. Green LED indicates the status of communications with the ACTSmart Units. Normally they flash rapidly. If there is a problem they will flash slowly (about once a second). www.accesscontrol.ie See ACTSmart2 Installation Manual for connection details. OMO RN 5A 5A FACTORY DEFAULT This unit should be reset to its factory default condition before installation. To do this, power the unit up with ALL switches in the OFF position. The two LED's will illuminate for about 2 sec. The correct switch settings may then be set. 8 To connect to PC set DIP 8 to the ON position RO N 1A 125V B N/C C N/ON/C C N/O 5A 250VAC 5A 30VDC Network cable is single shielded twisted pair, Belden 9501 or similar 12345678 On Shield Total cable length maximum 1.4km ACTSmart2 Unit + 12V DC 0V N/O COMM N/C Tamper 18-00036 ...