DS100e Door Station Installation ACT 2000 Important ! Always Place Varistor Across Lock Terminals OP2 = Aux Relay OP3 = OP3 OP4 = OP2 IP1 = Aux Input IP2 = Door Contact IP3 = Push Button Door Contact NETWORK Door Release Button Network cable is single shielded twisted pair, Belden 9501 or similar To next door A B 0V A B 0V A B Shield DTR DOORS OP3 OP4 0V IP1 IP2 IP3 DTR RX TX 0V B SERIAL NETWORK A Total Length max 1.4km Wiring for Clock and Data / Wiegand Reader White Green Blue Red Black Brown Yellow Orange SENSE CLOCK / DATA 1 DATA / DATA 0 +5v 0v RED GREEN (Buzzer Ctrl) OP1 OP2 NC C NO NC C 5A 250VAC 5A 30VDC NO TAMPER 5A 250VAC 5A 30VDC Entry Reader Power Supply Unit +12V 0V MAINS PRESENT 12V DC + - 12345678 DATA N ADDRESS Entry/Exit Reader Note: If the Mains Present or Door Contact inputs are not used, they should be linked to 0V 45678 RED +5V On Max len 30M 8 4 5 6 7 8 4 5 6 7 Cable: 8 Core Screened Belden 9504 or equiv 03 OFF OFF OFF ON 04 OFF OFF ON 05 OFF OFF ON 06 OFF OFF ON 07 OFF OFF ON 08 OFF ON 09 OFF ON ON 10 OFF ON 11 OFF ON 12 OFF ON 13 OFF ON 14 OFF ON 15 OFF ON 16 ON OFF ON OFF ON ON ON ON ON OFF ON OFF OFF OFF ON ON ON OFF ON For Clock & Data Readers, wire exit reader in parallel but leave it's sense line unconnected. For Wiegand Readers, wire the DATA 0 of the exit reader to SENSE on the DS100e OFF OFF OFF ON ON ON OFF ON This illustration shows wiring On for a normally energised To set the door number, set address switches lock. If a normally de-energised 4-8 as shown lock is required, use the N/O relay contacts. LED Functionality: GREEN CLOCK SENSE 0V Red LED indicates the status of communications with the Controller. While online to the controller the Red LED will flash rapidly. If there is a problem it will flash slowly (about once a second). Green LED will flash if an event occurs on the DS100e. www.accesscontrol.ie Downloaded from: http://www.guardianalarms.net Required Address Required Address OFF OFF OFF OFF OFF ON OFF OFF OFF OFF FACTORY DEFAULT This unit should be reset to its factory default condition before installation. To do this, power the unit up with ALL switches in the OFF position. The two LED's will illuminate for about 2 sec. The correct switch settings may then be set. 18-00037 ...