Detailed instructions for use are in the User's Guide.
SmartLock Installation Instructions
The SmartLock improves the security of ACTSmart2 installations by allowing the installer to locate the lock control relay inside a secure area. The SmartLock learns an ID code from the ACTSmart2 and only operates its' relay when a valid card or PIN is presented to the ACTSmart2. Since the SmartLock is inside a secure area, an attacker has no access to the lock control relay. Installation The normally open door release button should be connected to the SmartLock. When the input is activated, the door will open for the Door Relay Time programmed into the ACTSmart. ACT recommends installing the SmartLock inside the Power Supply Unit. Some PSUs can accomodate the Smartlock directly, otherwise drill holes to suit the SmartLock, (5mm drill bit required). For a Maglock, two fused outputs are required - one fused output for the ACTSmart2 and another for the Smartlock and Maglock. This prevents a short from +12V to 0V on the ACTSmart2 side of the door from deenergising the Maglock. Ensure that the Door Release wires are not accessible to an attacker. The Data line from the SmartLock to the ACTSmart2 must be less than 30m. Programming 1. Connect the ACTSmart2 and the SmartLock as in the diagram below and power up. 2. The red LED on the SmartLock will be on steady. 3. Program one of the AUX I/Os on the Smart2 for SmartLock operation. For AUX I/O 2 enter followed by the programming code (default code is 9999) and 5211 . 4. The red LED on the SmartLock flashes every second. 5. Press and hold the Programming button until the LED flashes rapidly. The SmartLock is now programmed. 6. Remember to change the other AUX I/O and the Programmable Input from Door Release Button. To set the Programmable Input to Door Contact enter then the programming code and 500 . To set AUX I/O 1 to Door Alarm enter followed by the programming code and 5108 . 7. If the ACTSmart2 unit is ever replaced or defaulted, then repeat this procedure.
PO
O
O
O
PO PO
Power Supply Unit 0V
ACTSmart2 Unit
Red LED
Programming Button
+12V Fuse 1 +12V Fuse 2
5A/250V ~AC
B A Aux I/O 2
Programmable Input
12V = DC
Aux I/O 1
Max. 30m
Data
12V = DC
0V
5A/250V ~AC
Door Contact
This illustration shows wiring for a normally energised lock (eg. maglock). If a normally de-energised lock (doorstrike) is required, use the N/O relay contact.
Note: A Break-Glass Unit (not shown) is required for Maglock installations.
Unit 8, U nit 8 IDA BBusiness Centre, Whitestown, Tallaght, Dublin 24, Ireland. Tallaght us ines s Park, W hites town, T allaght, Dublin 24, Ireland. T elephone: 353 1 462 2585. T elefax: 353 1 462 2587. E -m ail: s ales @ actrl.com W eb: www.actrl.com Telephone: 353 1 462 2585. Telefax: 353 1 462 2587. E-mail: sales@accesscontrol.ie Web: www.accesscontrol.ie 30-00030
OMO RN 5A 5A
RO N 1A 125V
+
12-24V DC/AC 0V N/O COMM N/C
12-24V DC/AC 0V
Push Button
Tamper
N/O COMM N/C
Door Release Button
SmartLock
Important! Always Place Varistor Across Lock Terminals
...
