once C rf 3j.lrfem CUSTOMER INSTRUCTIONS TO SET SYSTEM (Turn on) The D A Y indicator should be showing. Enter your code number. Check that the system is clear (none of the zone indicators arc showing). If clear. the sounder will produce a bleep tone and you may now leave by the correct route. The system will set at the end of exit time. If the system is not clear. the sounder will produce a broken tone and the zone indicator will display the fault. Either. enter your code to turn off and investigate the cause of the fault, or omit the faulty zone from the system. TO UNSET THE SYSTEM (Turn off) Enter your code, if the system i\ clear (no alarm has been activated) the unit will return to D A Y . If the system has been activated. then entering the code will turn off the sounders and the cause of the alarm will be displayed. Press RESET to clear the indication and return to TO QUICK SET THE SYSTEM During the exit time the system may be set quickly by pressing SET. This removes the time normally allowed for exit, and would be used if you are not leaving the premises. If you omit part of the system and require quick set. press SET twice. POWER INDICATORS A red power indicator should be showing at all times. on both the power supply and the keypad. If either indicator gocs out call the engineer to check the system. DAY. TO OMIT ANY ZONE FROM THE SYSTEM. Starting from thc DAY modc. Enter code and the exit time begins Press OMIT and the exit tone will now change to an omit tone. Enter the zone numbers you wish to omit e.g. pressing 2 then 4 will remove zoncs two and four from the system. The zone two and four leds will flash to show correct selection. I f you make a mistake and a wrong zone number is pressed then press 0, this will cancel the previous selection and allow another zone to be omitted. When the selection is correct press SET. the unit will now return to exit modc and the timer will continue. Thc maximum number of zones which may be omitted at any one time is three. CUSTOMER PROGRAMMING Customer code change. Alarm memory recall and Alarm tests arc all available from the cu\rorner program. With the D A Y light showing press the following button\ In the correct sequence. daQuJuu Press PROG button Enter vour code ALARM TFST A l l lights will show. Pres~ 0 Q 0 A l l Ilght. u11l \how I D A Y and T A M P E R lights show. Press Four Zone indicators show. The unit will bleep m Enter your code D A Y and TAMPER lights show. D A Y . TAMPER dnd A T T A C K Ilghts shou M>OO now enter New C O D E ( 4 digits) yt;;;; again. The unit is now in the te\t program Press The new code is now cntered into the Concept memory. 1'0 test the Strobe (cont~nuesuntil 0 i s pressed). Press AI ARM MEMORY R E C A U Press P R O G button Press m m To test the Oulstde Sounder (continues until 0 is pressed). m Enter your code Press 0 To test Low Sounder (continues until 0 i\ pressrd). A l l lights will bhow. D A Y and TAMPER lights show. To test High Volume Sounder (continues until 0 i s pressed). 0 MEM buttolr The last alarm will now be displayed for 5 seconds. The system will bleep and return to program. to return to D A Y . T'o cnter walk test. Internal Sounder u l l l nou operate each tlrnc a zone 15 opened (continues u n t ~ l 0 I.; pressed). r u i c e to rt.turr1 r o D A 1' rnotle. ...