What would you like to do ? Help us find the most requested user's guides Upload your
user manual Search for a user manual Register Login and access your manuals Reset your password

	Browse all user guides
	The ADE OPTIMA @@ OPTIMA XM product forum
	Upload your user manual
	Sign-up Log in
	Help us find the most requested user's guides
	Include the add-on to download manuals from your site, forum or blog
	Frequently Asked Questions
	Contact Diplodocs team
ALL GUIDES BY CATEGORY Domestic Appliance TV & Audio Car & Motorcycle Phone Computer Camera & Video Music Sport Gardening & Housekeeping Video Game & Software Jewelry & Watch Baby & Toys Hygiene & Health Other

TO S T THE SYSTEM (turn on) E The Day indicator should be showing. Enteryour code number.Check that the system is clear (none of the zone indicators are showing].If clear, the sounder will produce a bleep tone and you may now leave by the approved route. The system will Set at the end of the exit tirr~e and the tone will stop. If the system is not clear, the sounder will produce a broken tone and the zone fault will be displayed. Either re-enter your code to turn off and investigate,or omitthe fai,lty zone from the system. TO UNSET THE SYSTEM (turn off) If you make a mistake, press 0 to cancel and then enter the zones required to be omitted, When the selection is correct press S T The system will now return to exit E. mode and the exit tone will continue. QUICK S T E During exit time (after entering your code] the system may be Set quickly by pressing S T This removes the time normally E. allowed for exit and would be used if you are not leaving the premises. If you omit zones and require quick Set, press SET twice. POWER INDICATOR A red Power indicator should be showing on the control panel at all times. If this Enter your code, if the system is clear (no alarm has been activated) thesystem will return to Day. If the system has been activated, then entering the code will turn off the alarm and cause the condition to be displayed. Press RESET to clear the indication and return to Day. T OMIT A ZONE O indicator goes out, the mains supply has failed or been disconnected. If in doubt call the engineer for assistance. FAULTS/PROBLEMS Starting from the Day mode, enter your code and the exit tone will start. Press the OMlT button and the exit tone changes to an omit tone. Now enterthe zones you wish to omit e.g. pressing 2 then 4 will remove zones 2 and 4 from the system. The zone 2 and 4 indicators will now be displayed. It is importantto have your alarm system checked and tested regularly to ensure correct operation. It is also advisable to have a maintenance contract or agreement with the alarm installation company. If any faults occur, or any fault indicators remain on the display and cannot be cleared, call the engineer. Fill in the details below, to help keep a record of your alarm system. ALARM COMPANY NAME ......................... . . .............. . .. ................................................ ADDRESS ................... . . .......................................................................................................................................................... . ....... TEL. NO. DAY........................................................ E L NO. NIGHT ................... . =.................................................. . DATE OF INSTALLATION......................................... ZONE 1 2 ACCOUNT NO. ................................................................................ AREA PROTECTED 3 4 Customer code change,alarm memory recall and alarm tests are all available from the customer programme.With the Day indicctor showing, press the following buttons in the correct sequence. All indicators will Enter your code D Y and T M E indicators show A A PR Four Zone indicators show Now enter your D Y and T M E indicators show A A PR DAY, T M E and A PR ATTACK indicators show The system Is now In the test routlne T test the strobe o to return The new code is T test outside o belllsounder T test low volume o inside sounder T test high volume o D Y and T M E indicators show A A PR be displayed for 5 seconds. The system will bleep and D Y and A T M E indicatorswill A PR T enter walk test. o The sounder will now bleep each time a zone is opened.