Base Module The Advantage® plus Base Module is the primary communication processor and control unit for Advantage plus systems. Installed within the protected facilities, it is available in a standard UL version, attack version, or a military J-SIIDS version. It interfaces with all other optional modules and devices, and provides communication with the Advantor integrated monitoring system to transmit and display all security messages from the facility. It also includes listen back audio verification for up to four audio inputs. Dimensions Standard UL Enclosure · 17.25" W x 14.5" H x 3.25" D ( 43.82cm x 36.83cm x 8.26cm) · 20 gauge cold rolled steel with lock and key · Color: Light gray w/ Advantor logo Attack-Rated UL Enclosure · 17.25" W x 14.5" H x 3.25" D ( 43.82cm x 36.83cm x 8.26cm) · 18 gauge cold rolled steel with lock and key · Color: Light gray w/ Advantor logo PCB Foot Print · 8.5" W x 7.54" H (21.59cm x 19.15cm) J-SIIDS Compatibility · Direct replacement for current J-SIIDS applications · PCB is a replacement for the current transmitter and processor in conversions shown AVR PLUS BASE-C shown Alarm Points · 16 programmable, supervised, hard-wired points · N/C, N/O, or Both (dry contacts) · Programmable alarm codes · Assignable to any of 8 separate arming partitions (protected areas) · All alarm points operate normally under ground fault conditions · Expandable to a total of 144 points with Expansion Modules & another 63 points with the Wireless Module Transmission Media Dedicated · UL Grade AA, upgradeable to DES Class A · Supervision for Compromise, and Failure Dial Pulse or DTMF dialing Integrated cut line supervision RJ31X jack connection Secondary dial line capability with optional TelPlus Module · Secondary cellular communication with optional Cellular Module · Optional Telco "Level 2" Surge Protection · · · · Local Annunciation · Local bell drive: 12V at 1.25 Amp maximum · Audible keypad beeper Audio · Four balanced audio inputs supporting four verification audio sensors or any combination of up to eight optional SmartAudio or ListenIn Modules for up to 128 audio inputs. Arm/Disarm Function (Secure/Access) · 16 keypads · 8 partition capability · Programmable switch arming via momentary contact closure · Programmable access card arming via integrated card reader input (wiegand) · Programmable arm/disarm functions · Single key arming · Non-reporting · Reporting · Arm at shift · Optional SCIF package Wiegand Input · Interfaces with one card reader or biometric device for secure, user-friendly arm/ disarm of security and access control verification for up to 100 users. Access Modules may be added to the system to extend the capabilities to upto 10,000 users. 6101 Lake Ellenor Drive · Orlando, Florida 32809 Tel: 800/ADVANTOR · 407/859.3350 · Fax: 407/859.5205 http://www.advantor.com P/N 09820481, Rev. A 6/98 Specifications and part numbers are subject to change without notice. Downloaded from - http://www.guardianalarms.net Operating Environment · 0° F to 122° F (-18° C to 50° C) Communications Central Station · 300 Baud asynchronous, full duplex · Secure Protocol Communication · Transmit: 1070/1270 Hz/Receive: 2025/2225 Hz, FSK Auxiliary Outputs · Four, 100mA, programmable hard-wired · Expandable to 36 total with Loop Expansion Modules Base Module RS-485 Port · Communication link: 2,000 feet maximum using 22AWG, shielded twisted pair cable · Supports a maximum of 40 RS-485 devices, to include: · 16 total keypads · 8 Expansion Modules · 8 SmartAudio or ListenIn Modules in any combination · 1 Wireless Module · 7 Access Modules Primary Power Options · 100 to 120 VAC, 60Hz, using 16.5 VAC, 50VA, Class 2 plug-in transformer · 100 to 120 VAC, 50- 60Hz with internal transformer · 200 to 240 VAC, 50-60Hz with internal transformer · Can utilize existing J-SIIDS Power Supply · Optional AC "Level 2" Surge Protection Secondary Power · 12VDC, 7AH, sealed lead-acid rechargeable batteries (1 or 2, depending on kit) · Internal battery charger · Backup capabilities 12 to 24 hours typical (depending upon installed equipment) · Integral battery supervision for AC power loss, low battery and battery trouble Approvals · FCC Part 15, Class B · UL 294, "Access Control System Units" (using optional Access Module) · UL 365, "Police Connected Burglary" · UL 609, "Local Burglary" · UL 864, "Control Units for Fire Protective Signaling Service" · UL 985, "Household Fire Warning System Units" · UL 1023, "Household Burglar-Alarm Systems" · UL 1076, "Proprietary Burglar Alarm Units and Systems" · UL 1610, "Central Station Burglar Alarm Units" · Communicator for UL 611, "Central Station Burglary" · CSFM (California State Fire Marshal) · ULC Commercial Fire and Burglary Pending Auxiliary Power · 1.6 Amps continuous at 12VDC (plug-in transformer) · 1.3 Amps continuous at 12VDC (internal transformer) · 1.0 Amps continuous at 12VDC (JSIIDS power supply) Part Numbers AVR PLUS BAS Complete Base Kit, Standard enclosure, wall-mount transformer AVR PLUS BAS-C Complete Base Kit, standard enclosure, internal transformer (120VAC), (AC "Level 2" and telco "Level 2" dedicated line surge protection) AVR PLUS BAS220 Complete Base Kit, 220 VAC, Standard enclosure, internal transformer, (AC "Level 2" and telco "Level 2" dedicated line surge protection) AVR PLUS BAS220AT Complete Base Kit, 220VAC, Attack enclosure, internal transformer, AC "Level 2" and telco "Level 2 dedicated line surge protection AVR PLUS BAS-J JSIIDS Upgrade Kit, with AC "Level 2" and telco "Level 2 dedicated line surge protection AVRPLUSBASCELKT Factory integrated Base Module and Cellular Module, assembled in attack enclosure, with 120 VAC internal transformer. Includes AC "Level 2" surge protection and dial phone line "Level 2" surge protection AVR PLUS Complete Base Kit, Standard enclosure with SmartAudio module, wallmount transformer, 120VAC PCB, Base Module, UL Installation Connector Kit JSIIDS Installation Connector Kit Standard Enclosure with Lock & Key Attack Enclosure with Lock and Key Transformer, 16.5VAC, 50VA, Plug-In AC "Level 2" Surge Protector (120VAC) hardwired AC "Level 2" Surge Protector (220VAC) hardwired Telco "Level 2" Dedicated Line Surge Protector, hardwired Telco "Level 2" Dial Line Surge Protector, hardwired AC "Level 2" Surge Protection for plug-in transformer Base Module Installation Instructions Enclosure Tamper Switch Kit Battery, 12V, 7 AH, Gel Cell 90225102 40013701 40012810 90237200 90258200 08610416 08061699 08061431 08061698 08060085 08060084 09820450 40003401 08061206 6101 Lake Ellenor Drive · Orlando, Florida 32809 Tel: 800/ADVANTOR · 407/859.3350 · Fax: 407/859.5205 http://www.advantor.com Specifications and part numbers are subject to change without notice. SmartAudio Module Adds audio detection capability to the Advantage® plus system, while screening out many common environmental sounds. Continuously scans its audio channels, and analyzes sounds according to a predetermined set of audio algorithims or patterns. If a noise is determined to be a possible intrusion, the monitoring console is contacted. When a sound is deemed environmental, there is no call to the central station. Each Base Module can interface and control up to 8 SmartAudio or ListenIn Modules. Dimensions PCB Foot Print · 7.25" W x 8.5" H (17.41cm x 21.59cm) Audio · DSP processes 8 audio channels for intrusion detection · Each audio channel assignable to any of 8 separate arming partitions · Sensitivity adjustable from central station · 16 audio sensor inputs (two per audio channel) · Programmable audio sensor self-test at system arming and disarming · Balanced audio output to Base Module · Audio sensors annunciate Chime Mode & Entry/Exit Alert Stored Audio · One second pre-impact · Four seconds post-impact, followed by live audio Power Requirements · 200 mA at 12 VDC (from Base Module or optional APS12V1A-S Advantage PowerSource) Operating Environment · 0° F to 122° F (-18° C to 50° C) Communications · Base Module RS-485 Communication link up to 2,000 feet maximum with 22AWG shielded twisted pair cable Auxiliary Inputs · "No AC" and "Low Battery" inputs to monitor the status of an optional APS12V1A-S Advantage PowerSource · Tamper input Mounting · Mounts locally inside Base Module enclosure or remotely inside optional enclosure up to 2,000 ft. from Base Module Part Numbers ADV SAM Smart Audio Module with Installation Kit APS12V1A-S Power Supply, 12VDC AVR CHAS/SUR115 Standard Enclosure, Internal Transformer (120VAC) and AC "Level 2" surge protection AVR CHAS/SUR220 Standard Enclosure, Internal Transformer (220VAC) and AC "Level 2" surge protection 40003401 Enclosure Tamper Switch Kit 90228102 90237200 90258200 08610416 09820452 PCB, Smart Audio Module Standard Enclosure with Lock and Key Attack Enclosure with Lock and Key Transformer, 16.5VAC, 50VA, Plug-In SmartAudio Module Installation Instructions 6101 Lake Ellenor Drive · Orlando, Florida 32809 Tel: 800/ADVANTOR · 407/859.3350 · Fax: 407/859.5205 http://www.advantor.com P/N 09820486, Rev. A 6/98 Specifications and part numbers are subject to change without notice. BLANK 6101 Lake Ellenor Drive · Orlando, Florida 32809 Tel: 800/ADVANTOR · 407/859.3350 · Fax: 407/859.5205 http://www.advantor.com Specifications and part numbers are subject to change without notice. Expansion Module The Expansion Module provides the Advantage® plus Base Module with an additional 16 supervised, programmable alarm points, and four additional auxiliary outputs. Each Base Module can interface and control up to 8 Expansion Modules. Dimensions PCB Foot Print · 6.87" W x 4.125" H (17.45cm x 10.48cm) Alarm Points 16 programmable, supervised, hard-wired points N/C, N/O, or Both (Dry Contact) Programmable alarm codes Programmable into any of 8 separate arming partitions(protected areas) · All alarm points operate normally under ground fault conditions · · · · Operating Environment · 0° F to 122° F (-18° C to 50° C) Auxiliary Outputs · Four, 100mA, programmable hard-wired Communications · Base Module RS-485 Communication link up to 2,000 feet maximum with 22AWG shielded twisted pair cable Power Requirements · 12 VDC (from Base Module or optional APS12V1A-S Advantage PowerSource) · 130mA maximum in both Normal Standby and Alarm Mounting · One mounts locally inside Base Module enclosure or remotely inside an optional enclosure up to 2,000 feet from the Base Module Part Numbers Loop Expansion Module with Installation Kit APS12V1A-S Power Supply, 12VDC 90226101 PCB, Expansion Module 90237200 Standard Enclosure with Lock and Key AVR CHAS/SUR115 Standard Enclosure, Internal Transformer (120VAC) and AC "Level 2" surge protection AVR CHAS/SUR220 Standard Enclosure, Internal Transformer (220VAC) and AC "Level 2" surge protection ADV LEM 40003401 90258200 08610416 09820453 08061699 08061431 08061206 Enclosure Tamper Switch Attack Enclosure with Lock and Key Transformer, 16.5VAC, 50VA, Plug-In Loop Expansion Module Installation Instructions AC Surge Protector (120VAC), hardwired AC Surge Protector (220VAC), hardwired Battery, 12V, 7AH Gel Cell 6101 Lake Ellenor Drive · Orlando, Florida 32809 Tel: 800/ADVANTOR · 407/859.3350 · Fax: 407/859.5205 http://www.advantor.com P/N 09820483, Rev. A 6/98 Specifications and part numbers are subject to change without notice. BLANK 6101 Lake Ellenor Drive · Orlando, Florida 32809 Tel: 800/ADVANTOR · 407/859.3350 · Fax: 407/859.5205 http://www.advantor.com Specifications and part numbers are subject to change without notice. Access Module The Access Module adds access control to the Advantage® plus system. Each Base Module can interface and control up to seven Access Modules with each module controlling four card readers. General Features · Access for up to 10,000 cardholders, with 256 Access Levels · 128 programmable Time Shifts & Time Periods per property · Optional Anti-Passback, either local or global · Programmable outputs to control equipment, such as HVAC and lighting · Distributed Processing system with 8,000 event local buffer memory · Optional Free Exit or Card Controlled exit · Compatible with most card types · Weigand · Proximity · Magnetic stripe · Bar Code · Level 1 (card only); Level 2 (card plus PIN) or Level 3 (card, PIN and biometrics) capability. Dimensions Standard UL Enclosure · 17.25" W x 14.5" H x 3.25" D ( 43.82cm x 36.83cm x 8.26cm) · 20 gauge cold rolled steel with lock and key · Color: Light gray w/ Advantor logo Attack-Rated UL Enclosure · 17.25" W x 14.5" H x 3.25" D ( 43.82cm x 36.83cm x 8.26cm) · 18 gauge cold rolled steel with lock and key · Color: Light gray w/ Advantor logo PCB Foot Print · 12.75" W x 8.75" H (32.39cm x 22.23cm) shown ACCESS 4-A KIT shown Alarm Points · 14 programmable, supervised, hard-wired points · N/C ...