REFRESHMENT CENTER Built-in appliance EIW60000X welcome to the world of Electrolux electrolux 3 Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. We promise that it will provide a superior User Experience delivering Ease-ofMind. Good luck! 4 electrolux contents Contents Electrical safety ........................ 5 Electrical safety .................... 5 Installation........................... 6 Use .................................... 6 Cleaning .............................. 6 Environment ......................... 6 Appliance description.................. 7 Units .................................. 7 Identification plate (Fig. 2) ........... 8 Technical Characteristics ............. 8 Installation .............................. 9 Installation steps: .................. 9 Package content .................... 9 1 Unit positioning ................. 9 2 Water mains and siphon connection ..................... 10 3 Install filter cartridge ........ 11 4 Startup ......................... 12 Using the Refreshment Unit..... 13 Front touch panel................. 13 Dispensing.......................... 13 Alarms .................................. 14 Maintenance........................... 16 CO2 bottle replacemen .......... 16 Sanification + filtration cartridge17 Environment care..................... 19 Electric diagram ...................... 20 Hydraulic diagram .................... 21 Guarantee/Customer Service....... 22 The following symbols are utilized with this manual: Safety information Environment Disposal directives electrical safety electrolux 5 Electrical safety This appliance conforms to the following safety electrical European Directives: This manual has been written for your own safety and of others. Please read manual carefully before installation and/or use. Please keep this instruction manual in a safe and dry place. This appliance conforms to the following safety electrical European Directives: 73/23/CEE, 89/336/CEE, 92/31/CEE, 98/37/CEE. Please keep this instruction manual in a safe and dry place. This manual has been written for you own safety and of others. Please read manual carefully before installation and/or use. Electrical safety The unit needs to be connected to a power supply line that conforms fully to local safety regulations regarding electrical safety. If in doubt please have your electrical system checked by a specialized electrician. Please do not try to repair the unit as you might cause additional damage. Contact your nearest Technical assistance center. Remove power supply cord before proceeding with repair operations. If the power supply cord appears to be damaged, please ask for a replacement cord. 6 electrolux appliance description Installation Please handle appliance with care to prevent damaging of the refrigeration circuit. Avoid prolonged exposure of the appliance to direct sunlight. To guarantee maximum stability and safety, it's necessary to install the builtin appliance only in AEG, REX and Electrolux sized cabinets. Please follow instruction carefully before, during and after installation. If the appliance is transported in vertical position, please place in horizontal (normal) position and wait 1 hour for the oil to return to the compressor before turning unit on. Do not bend water supply and discharge tube excessively during installation. Use Do not use the Refreshment Unit for something else other than dispense cold, carbonated, ambient water and ice. An incorrect use of the appliance may harm people or cause damage to the appliance itself. Do not allow children to use the appliance if not under the supervision of adults. Cleaning Do not use metallic tools to clean the appliance as it may cause damage. Environment Please follow local disposal regulations. appliance description electrolux 7 Appliance description The Refreshment Unit is a domestic appliance designed to dispense purified cold, carbonated and ambient temperature water and icecubes. The appliance has 2 outlet from which the following products can be 1 23 4 5 6 dispensed: - Ambient temperature water - Cold water - Carbonated water - Ice-Cubes. 7 89 Units The unit is mainly composed of: 1 St. Steel front display 2 Filter head 3 Water dispense nozzle 4 5 Glass touch command panel Ice dispense outlet 10 11 12 13 6 7 8 9 Drip tray CO2 bottle H2O pressure regulator with gauge Filter cartridge 10 11 12 13 Power supply socket Main on/off switch H2O inlet H2O drainage 8 electrolux identification plate Identification plate (Fig. 2) Should you need to contact a technical Assistance Center, make sure you have the serial number handy for identification. The serial number is on the identification plate in the side of the appliance. Extract from cabinet to identify plate. MODEL TYPE XXXXXXXX 230 V ~ 50 Hz MAX 190 W PNC xxx xxx xxx SERIAL No.: Refreshment Center xxxxxxxx MADE IN ITALY Fig. 2 Technical Characteristics Power Supply Frequency Power consumption Cold water dispense capacity Carbonated water dispensecapacity Dispense temperature Water mains pressure (water inlet) CO2 pressure Filtration Filter capacity Ambient temperature conditions range Unit dimensions L x P x H (mm) Weight Refrigerant gas 230-240 V 50 Hz 190 W 2lt @ 1 l/min. 2lt @ 1 l/min < 13°C > 2.0 bar 2.5-4 bar 0.5 micron 3000 litres 18°C-32°C 594x530xH378 38 Kg R134a ­ 60gr installation electrolux 9 Warning In order for the unit to work correctly, the Technical Characteristics specification chart on page 6 needs to be observed. Installation steps: 1. Refreshment unit assembly inside kitchen 2. Water mains connection 3. Water filter connection 4. Electric power supply Installation Power supply cord H2O inlet flexible hose and discharge tube Filtration Cartridge Package content Open package and immediately check for any transport damages. During installation please handle with care. Inside you should find the following material: A. Refreshment Center B. 2 Sliding Rails C. Mounting base plate D. 6 spacers 2x1mm, 2x2mm, 2x3mm Sanitazing cartridge and liquid 1 Unit positioning A B C D Please install unit as far away as possible from heat sources Install the mounting base plate inside the kitchen cabinet after checking after checking dimension requirements as shown in Fig. 4. Mount the 2 sliding rails onto the base plate. Place the Refreshment Center on the sliding rails. 10 electrolux installation 360 580 564 Fig. 4 2 Water mains and siphon connection Warning Connect only to potable water mains. All water mains connections should be carried out by a certified plummer. Warning Water mains pressure can be set through the H2O pressure regulator placed near the CO2 bottle. Pressure should be no higher than 3.0 bars and no lower than 2.0 bars. Complete following operations (Fig. 5): - Connect the flexible hose to the H2O inlet on the unit. Connect water mains to flexible hose. - Connect discharge tube to discharge barbed connection on unit and to sink siphon. Fig. 5 installation electrolux 11 3 Install filter cartridge Lift locking spring placed under drip tray (Fig. 5a). Fig. 5a Pull unit from cabinet. On the left side of the unit please find the filter cartridge (Fig. 6). Filter cartridge Fig. 6 Remove filter plastic cap and install filter in filter head as shown on filter instruction booklet (Fig. 7). Fig. 7 Verify the on/off valve near the reducer is closed Check for water leaks and make sure the CO2 bottle is tightly fixed on the CO2 pressure regulator. Open the pressure regulator valve and set pressure to 3 bars on gauge. Pressure can be increased to 4 bars to increase carbonation levels (Fig. 9). Fig. 9 12 electrolux installation 4 Startup Warning Before plugging unit to power supply, please check for correct power supply voltage and frequency as stated on Technical Characteristic chart (see page 6). Fig. 10 which will take approx. 4 minutes. Connect unit to 230V through supplied cord. This preliminary operation will be Electric supply circuit should conform carried out every time the unit is turned off and on through the main to local laws and regulations. on/off switch inside the cabinet. Warning During this process the touch control The supplier declines any panel is inactive. responsibility should any safety rule not be respected during installation. After 4 minutes turn unit on through Turn unit on through main on/off on/off button on touch control panel switch on side of unit. The unit will to activate all functions. undergo an initialization process At this point please wait approx. 3 hours before the unit reaches final working temperatures in order to dispense cold water, carbonated water and ice-cubes. Ambient water is readily immediately. installation electrolux 13 Using the Refreshment Unit Front touch panel 1 2 3 4 5 6 7 8 1 Empty CO2 bottle led 2 On/Off switch 3 Water ambient temperature button 4 Carbonated water button 5 Cold water button 6 Ice dispense button 7 Light button On/Off 8 Exhaust filter led Dispensing After turning appliance on through on/off switch on touch screen, wait for cooling time before dispensing. Place a glass under dispense nozzle. Press button corresponding to desired selection. Release until desired dispense water level or number of icecubes is reached. Please do not dispense more than 1 liter of carbonated water continuously since you might experience CO2 exhaust from nozzle. Should that occur, please wait 1 minute and restart dispensing carbonated water. 14 electrolux alarms Dispensing is signalled by the corresponding led. In order to dispense in bottles or carafes, please extract dispense nozzle by grabbing on sides of nozzle and pulling forward. Alarms Led indications Led blinks slowly Message Filter is about to exhaust. 2900 liters have been dispensed. Please change filter as described in the following chapters. Led is lit Filter is about to exhaust. 2980 liters have been dispensed. Please change filter as described in the following chapters. Led is lit All dispense buttons disabled. 3000 liters have been reached. Please change filter as described in the following chapters. alarms electrolux 15 Carbonated water led blinks slowly Carbonated water is disabled. Time-out protection on carbonation pump activated. To reset status please turn unit off/on on touch control panel. Carbonated water is disabled. CO2 bottle is empty. Replace CO2 bottle to restore Carbonated water dispensing. Please change CO2 bottle as described in the following chapters. CO2 bottle led on Leds - ambient water - ice blink simultaneously Ice forming bin blocked. Turn unit on/off through main on/off switch on side of unit. Leds - ambient water - cold water - carbonated water blink simultaneously Leds - carbonated water - ambient water - cold water - ice blink simultaneously Volumetric turbine malfunctioning. Dispense functions enabled but during dispense operation the 3 leds will blink. Main water tank fill time-out. Please check water supply to unit. Make sure filter shut off valve to be open. To reset status turn unit on/off through main switch inside cabinet. 16 electrolux maintenance All leds on simultaneously All dispense buttons disabled. 2 main causes: 1. Water present on base of unit. Possible leak. 2. Water level too high inside water tank. Water discharge blocked. For the first case switch off and dry the base of the unit. For the second case turn unit on/off through main switch inside cabinet. Should alarms repeat themselves after all restart attempts, please call service assistance. Maintenance Before any maintenance or cleaning procedure, please switch off the appliance and disconnect it from main by unplugging the power plug. CO2 bottle replacement When the CO2 led turns on, it's necessary to replace the CO2 bottle as described below: 1. Pull appliance from cabinet (A-Fig. 12). 2. Grab the CO2 bottle and extract it from it's locking clip. 3. By holding the bottle fixed, turn the pressure regulator clockwise to remove from the bottle (fig. 13). Fig. 12 maintenance electrolux 17 4. Place new bottle under the regulator and screw counter clockwise till fully tightened. 5. Lock bottle in place and close cabinet. Fig. 13 Sanification + filtration cartridge When the exhaust filter led turns on, it is time to replace the filter cartridge: 1. Turn unit off through main on/off switch (Fig. 11). 2. Pull unit from cabinet (Fig. 5a) and look for two shot off valves on the base of the unit under the CO2 cylinder. 3. Close valve (Fig. 14). 4. Unwind the wrapped tube to a container or glass and open valve 1 to r ...