QUICK SETUP n Connect your source (instrument, mic, mixer) to either of MIDIVERB II's inputs; both inputs if you have a stereo signal. Connect the MIDIVERB II outputs to your instrument amp(s) or stereo mixer returns. Set the MIX control to 50/50 Start the source signal. Turn the INPUT control clockwise until the green SIGNAL LED stays on (when signal is present) and the red OVLD (overload) LED flashes occasionally on peaks. n n n n n n n n n Turn the OUTPUT control clockwise to the volume level you desire. Change Programs manually by pressing any two numbered buttons 00-99 Set the MIDI receive channel: Press CHAN followed by two numbered buttons 01-l 6. Assign Programs to MIDI Patch numbers: Press PATCH followed by two numbered buttons 01-32. Press PRGM followed by two numbered buttons 00-99 Hold STORE and press PATCH. The system always reverts to Program mode (PRGM LED on). ...