User manual ALPINE RUE-4187

Handling Precautions R Do not drop or apply shock to the unit. It may be get permanently damaged. 1 2 5 6 7 8 9 ! " # Clean with a soft, lint-free cloth or cotton swab slightly dampened with a mild solution of detergent and water. Do not operate this unit in a manner that could distract you from driving safety. RUE-4187 Remote Control Unit 3 4 Keep the unit away from water and moisture, direct sun and heat, and excessive dust. Never use scouring pads, steel wool, abrasive powders or harsh chemical agents, such as lye solution, for cleaning. Battery Replacement Applicable battery: Use two "AAA" sized dry batteries or equivalent. Owner's Manual 8 1 g Button Radio mode: SEEK (DN) Button CD/CD changer mode: Press the button to go back to the beginning of the current track. Tape mode: REW Button Audio Processor Mode: Press this button to adjust the MODE that is called by pressing the A.PROC button. f Button Radio mode: SEEK (UP) Button CD/CD changer mode: Press the button to advance to the beginning of the next track. Tape mode: FF Button Audio Processor Mode: Press this button to adjust the MODE that is called by pressing the A.PROC button. 9 Button Radio mode: Pressing the button will select, in descending order, stations programed into the radio's presets as shown below. 6 5 ... 1 CD Changer mode: DISC Select (DN) Button Press the button to select a disc in descending order. Tape mode: Pressing this button enters the Program Sensor Down mode.This allows for music selection towards the beginning of the tape. Audio Processor Mode: Press this button to adjust the MODE that is called by pressing the A.PROC button. Mute Button · Press the button to lower the volume by 20 dB instantly. Press the button again to cancel. · Press the button for at least 2 seconds to raise the monitor. Press the button again to lower the monitor. (Head unit with Monitor Display, etc.) Audio Processor Button Press the button to call the external audio processor mode. Opening the battery cover. 2 Replacing the battery. Put the batteries in the case observing the polarities as illustrated. 3 Closing the cover. Push the cover as illustrated until a click is heard. Slide out the battery cover while firmly pressing the direction of arrow. Controls on Remote Control 1 2 3 Power Button Press the button to turn the power on/off. Source Button Press to select the audio source. -/J /Enter Button Press the button to switch between the Play and Pause modes for CD or MD and Tape. Audio Processor Mode: Enter button Press this button to adjust the MODE that is called by pressing the A.PROC button. ANGLE 89 Buttons Press the button to adjust the angle of the movable display. Band/Program Button Radio mode: BAND Button Changer mode: BAND Button Switches changers (when a Multi-Changer Switching device is connected). TAPE mode: PROG Button Press the button to change between the A and B side of the tape. Volume Adjustment Buttons To increase the volume level: Press the L button To decrease the volume level: Press the K button 8 Button Radio mode: Pressing the button will select, in ascending order, stations programed into the radio's presets as shown below. 1 2 ... 6 CD Changer mode: DISC Select (UP) Button Press the button to select a disc in ascending order. Tape mode: Pressing this button enters the Program Sensor Up mode.This allows for music selection towards the end of the tape. Audio Processor Mode: Press this button to adjust the MODE that is called by pressing the A.PROC button. 9 In Case of Difficulty Problem Remove Control Inoperative. Solution Place the battery correctry into its cradle in the compartment. Replace the battery with a new one. Remote Control not Point the remote control pointed toward the directly toward your head unit. head unit. Cause Reverse placement of battery. Dead battery. Specifications Battery Type ................................. AAA sized dry batteries Battery Quantity ................................................................ 2 Dimensions(W x H x D) ........................... 42 x 121 x 23mm (1-21/32" x 4-25/32" x 29/32") Weight (without battery) .................................. 50g (1.8 oz) Accessory ............................... Remote Control Unit Holder 4 ! 5 6 " R 7 ALPINE ELECTRONICS, INC. Tokyo office: 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan Tel.: (03) 3494-1101 ALPINE ELECTRONICS OF AMERICA, INC. 19145 Gramercy Place, Torrance, California 90501, U.S.A. Tel.: 1-800-ALPINE-1 (1-800-257-4631) ALPINE ELECTRONICS OF CANADA, INC. Suite 203, 7300 Warden Ave. Markham, Ontario L3R 9Z6, Canada Tel.: 1-800-ALPINE-1 (1-800-257-4631) ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD. 6-8 Fiveways Boulevarde Keysborough, Victoria 3173, Australia Tel.: (03) 9769-0000 ALPINE ELECTRONICS GmbH Kreuzerkamp 7-11 40878 Ratingen, Germany Tel.: 02102-45 50 ALPINE ITALIA S.p.A. Via C. Colombo 8, 20090 Trezzano Sul Naviglio MI, Italy Tel.: 02-48 47 81 # ALPINE ELECTRONICS FRANCE S.A.R.L. (RCS PONTOISE B 338 101 280) 98, Rue De La Belle Etoile, Z.I. Paris Nord Il B.P. 50016 F-95945, Roissy, Charles De Gaulle Cedex, France Tel.: 01-48 63 89 89 ALPINE ELECTRONICS OF U.K., LTD. 13 Tanners Drive, Blakelands, Milton Keynes MK14 5BU, U.K. Tel.: 01908-61 15 56 ALPINE ELECTRONICS DE ESPAÑA, S.A. Portal De Gamarra 36, Pabellón 32 01013 Vitoria (Alava)-Apdo. 133, Spain Tel.: 34-45-283588 68P01434K62-O Printed in China(Y) For the operation of external audio processor, refer to the Owner's Manual of the external audio processor you purchased. This button is used in conjunction with an optional Ai-NET processor. NOTE Depending on the device you are using, you cannot operate or may need to operate differently some devices on the remote control. For details, refer to the Owner's Manual of the device you purchased.