Contents Safety Precautions Important Safety Instructions 1 2 Overview of TV Panel Description Back Panel Description Antenna Connections Connections i. YPbPr/YCbCr (component) Connection ii. S-Video and Video (Composite) Connections 4 5 7 8 9 11 12 13 15 17 iii. PC Connection iv. HDMI/DVI Connection Remote Control Overview Remote Control Operation Basic Operation Menu Operation i. Picture Menu ii. Sound Menu iii. Channel Menu Iv.. Window Menu v. Setting Menu Function Button Instruction PIP PBP POP V-Chip 18 19 20 24 25 31 36 38 39 41 44 45 48 49 50 51 CCD Use USB Memory and Multimedia Memory Card Maintenance Trouble Shooting Display Mode Specifications Safety Precautions NOTE TO CABLE/TV INSTALLER: CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN THE LIGHTNING FLASH WITH ARROW-HEAD SYMBOL WITHIN AN E Q U I - L AT E R A L T R I A N G L E I S INTENDED TO A-LERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE UNIT'S CABINET THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRE-SENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE MANUAL AC-COMPANYING THE ! ! ! ! ! Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. When in use, there must be a distance at least 5cm between the TV and some object front or back of it, at least 1cm between the TV and some object leftward or rightward of it . WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE. NEVER ATTEMPT TO OPEN THE CABINET, DANGEROUS HIGH VOLTAGES ARE PRESENT IN THE UNIT. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. NOTE TO CABLE/TV INSTALLER: This reminder is provided to call the cable TV system installer's attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical. CAUTION: Do not attempt to modify this product in any way without written authorization from AMOI Electronics Co., Ltd. Unauthorized modification could void the user's authority to operate this product. RECORD YOUR MODEL NUMBER (Do this now, while it is convenient) The model and serial number of your Machine are located on the back of the TV cabinet. For your future convenience, we suggest that you record these numbers here: MODEL NO.____________________________________ SERIAL NO.____________________________________ Wet Location Marking C-UL Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. -1- Important Safety Instructions 1.Read These Instructions-All the safety and operating instructions should be read before the product is operated. 2.Keep These Instructions-The safety and operating instructions should be retained for future reference. 3.Heed All Warnings-All warnings on the product and in the operating instructions should be adhered to. 4.Follow All Instructions-All operating and use instructions should be followed. 5.Do not use this product near water-Do not use this product near water for example, near a bathtub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like. 6.Clean only with dry cloth-Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use dry cloth for cleaning. 7.Do not block any ventilation openings. Install in accordance with the manufacturer instructions. 8.Do not install near any heat sources such as radiators, heat register, stoves, or other apparatus (including amplifiers) that produce heat 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11.Only use attachments and accessories specified by the manufacturer. 13.Unplug this apparatus during lightning storms or unused for long period of time. 14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 15.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions. 16.Protective Attachment Plug -The product is equipped with an attachment plug having overload protection. This is a safety feature. See Instruction Manual for replacement or resetting of protective device. If replacement of the plug is required, be sure the service technician has used a replacement plug specified by the manufacturer that has the same overload protection as the original plug. 12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart. Apparatus combination to avoid injury from tip-cover. -2- Important Safety Instructions 17.Power Lines -An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal . 18.Overloading -Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. 19.Object and Liquid Entry -Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. 20.Replacement Parts -When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. 21.Safety Check -Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 22.Wall or Ceiling Mounting -The product should be mounted to a wall or ceiling only as recommended by the manufacturer. Any mounting of the product should follow the manufacturer instructions, and should use a mounting accessory recommended by the manufacturer. 23.Outdoor Antenna Grounding -If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See figure below. Note: Children'd better not play around the TV, since the sharp edge may hurt them. -3- Panel Description 1 2 3 4 5 Overview of TV 6 6 7 8 1 SOURCE Press to display the menu of the available viewing source. 2 MENU Press to display the OSD menu. CH+/Press to change the channel. The two buttons also act as direction buttons VOL+/Press to adjust volume . The two buttons also act as direction buttons POWER Power on/off the TV. Bottom type speaker Standby indicator Remote control sensor 3 . 4 . 5 6 7 8 -4- Back Panel Description Overview of TV Video-2 input Audio-2 input S-Video 2 input Headphone Output VIDEO R AUDIO AV -2 IN L S-VIDEO Rear interface Rear interface description 100240 V 50/60HZ POWER S-VIDEO 1 AV OUT / AV-1 IN COMPONENT IN (HDTV/DVD) PC AUDIO COAXIAL OPTICAL SERVICE IN ONLY ANTENNA PC IN HDMI/DVI IN These interfaces are available for models: LC32AF1U/LC32A1U LC37AF1U/LC37A1U LC40AF1U/LC40A1U -5- Back Panel Description Overview of TV Video-2 input Audio-2 input S-Video 2 input Headphone Output VIDEO R AUDIO AV -2 IN L S-VIDEO Rear interface Rear interface description 100240 V 50/60HZ POWER S-VIDEO 1 AV OUT / AV-1 IN COMPONENT IN (HDTV/DVD) PC AUDIO IN ANTENNA PC IN SERVICE ONLY HDMI/DVI IN OPTICAL These interfaces are available for models: LC26AF1U/LC26A1U -6- Antenna Connections *For optimum picture quality, adjust antenna direction. Indoor Antenna Connection Typical Wall antenna jack used in apartment buildings, connect the antenna cable as shown below (Please use the correct type of antenna cable according to the type of wall antenna jack). 75 ohm Round Cable Bronze Wire 300 ohm Flat Wire ANTENNA Antenna Converter Apartment buildings Wall Connection Jack *If you have a 75 ohm round cable, insert the bronze wire and then tighten the connection nut. *If you have a 300 ohm flat wire, connect the twisted wire to the antenna converter and then connect the converter to the antenna jack on the TV. *When using 75 ohm round cable, please do not bend the bronze wire, it may make the video quality poor. Outdoor Antenna Connection This type of antenna is commonly used in single family dwellings. VHF Antenna 75 ohm Round Cable UHF Antenna ANTENNA 300 ohm Flat Wire Antenna Converter Single Family Home VHF UHF *In poor signal areas, to get better picture quality, install the antenna as shown to the right. *You can share the antenna with a signal splitter for two TV sets. Signal Amplifier 75 ohm Round Cable -7- YPbPr/YCbCr (Component) Connection: COMPONENT IN (HDTV/DVD) Y 1 Y Pb / Cb DVD, etc - Pb /Cb Pr /Cr L -AUDIO - R Pr / Cr AUDIO(L) AUDIO(R) 2 Audio Cable Component Video Cable Note: Please refer to the illustration above to connect TV with DVD player or other component signal sources. Connect Component video Cable and Audio Cable to corresponding jacks of DVD player or other component signal sources. Please choose the "Component" in the "Source menu"when you employ Component signal source. How to select the viewing source(''Component'') Please press the "SOURCE" button after finishing the connection. The source menu will be displayed on the screen. Source TV Component1 AV1 Component2 AV2 PC HDMI USB / SD / CF Please use numerical buttons directly to select source "Component1" or "Component2"; Or use the direction to select item "Component1" or "Component2" and then press the "OK" button to confirm. -8- S-Video and Video (Composite) Connections: S-Video or composite signal output AV OUT / AV-1 IN POWER VCR S-VIDIO VIDEO L - AUDIO - R OUT AUDIO(R) AUDIO(L) VIDEO S-VIDEO IN AV Cable S-Video Cable Note 1.Please refer to the illustration above and in the last page to connect TV with S-Video or other composite signal sources. Connect S-Video/composite video cable and audio cable to corresponding jacks of DVD player or other composite signal sources. Please choose "AV1" in the "Source" menu when you connect DVD player. 2 . When S- ...