Cobra AW850 Deluxe Installation Guide. WARNING! Static electricity might cause , severely damage to electronic parts. Take these precautions: 1. Drain static electricity away from your body before touching any electronic parts. (You can touch the internal metal frame of PC while its un-plugged, for example) 2. Keep all components in its anti-static bags until you are ready to install it. 3. When handling the card, hold it by its edges and avoid touching its circuitry. : 1. , ( ) 2. 3. , 1. 2. 3. HAREWARE Installation 1 Unplug all electrical cords on PC before you Open the PC case. , Locate the PCI slot in M/B and plug in the card and properly.. PCI , PCI 2 3 Check the connector type on SOUND card and properly connect to your devices. , 4 Close PC case then turn on the PC power. , 5 Please check backside for `SOFTWARE Installation' "" Page 1 SOFTWARE Installation 1 Power on the PC and enter Windows system. , OS 2 Click the `Cancel' button when `New Hardware Found' windows displays. "", "" 3 Enter Windows main screen and plug in bundled Driver Disc. , CD-ROM Driver Disc 4 The Installation wizard displays, select `Install Device Driver & Install Utilities' items and press `OK' button. , " ", "" Driver Disc Auto Run Install Utilities Install Device Driver FCC Class B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measure: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/television technician for help. Notice 1: The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2: Shielded interface cables must be used in order to compiliy with the emission limit. Page 2 ...