MOTHERBOARD K7Upgrade-600 User Manual Version 1.1 Published August 2004 Copyright©2004 ASRock INC. All rights reserved. 1 Copyright Notice: No part of this manual may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, except duplication of documentation by the purchaser for backup purpose, without written consent of ASRock Inc. Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. Disclaimer: Specifications and information contained in this manual are furnished for informational use only and subject to change without notice, and should not be constructed as a commitment by ASRock. ASRock assumes no responsibility for any errors or omissions that may appear in this manual. With respect to the contents of this manual, ASRock does not provide warranty of any kind, either expressed or implied, including but not limited to the implied warranties or conditions of merchantability or fitness for a particular purpose. In no event shall ASRock, its directors, officers, employees, or agents be liable for any indirect, special, incidental, or consequential damages (including damages for loss of profits, loss of business, loss of data, interruption of business and the like), even if ASRock has been advised of the possibility of such damages arising from any defect or error in the manual or product. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ASRock Website: http://www.asrock.com 2 Contents 1. Introduction ...................................................... 5 1.1 1.2 1.3 1.4 Package Contents .............................................................. Specifications .................................................................... Motherboard Layout .......................................................... ASRock I/O ........................................................................ 5 6 8 9 10 11 11 12 13 15 17 20 20 21 22 22 22 23 26 26 31 32 33 34 35 35 36 36 37 37 39 40 41 43 2. Installation ........................................................ 10 Pre-installation Precautions ........................................................ 2.1 CPU Installation .................................................................. 2.2 Installation of CPU Fan and Heatsink ................................ 2.3 Installation of Memory Modules (DIMM) ............................ 2.4 Expansion Slots (K8 Bridge, PCI, and AGP Slots) .................... 2.5 Jumpers Setup .................................................................. 2.6 Onboard Headers and Connectors .................................. 2.7 Serial ATA (SATA) Hard Disks Installation ......................... 2.8 Hot Plug and Hot Swap Functions for SATA HDDs .......... 2.9 Making An SATA Driver Diskette ........................................ 3.1 BIOS Setup Utility ................................................................. 3.1.1 BIOS Menu Bar .......................................................... 3.1.2 Legend Bar ................................................................ 3.2 Main Menu ............................................................................ 3.3 Advanced, Security, Power, Boot, and Exit Menus ........... 3.3.1. Advanced BIOS Setup Menu .................................... 3.3.2. Security Setup Menu ................................................. 3.3.3. Power Setup Menu .................................................... 3.3.4. Boot Setup Menu ....................................................... 3.3.5. Exit Menu ................................................................... 4.1 Introduction ........................................................................ 4.1.1 BIOS Menu Bar ...................................................... 4.1.2 Navigation Keys ..................................................... Main Screen ...................................................................... Advanced Screen ............................................................. 4.3.1 CPU Configuration .................................................. 4.3.2 Chipset Configuration ............................................ 4.3.3 ACPI Configuration ................................................. 4.3.4 IDE Configuration ................................................... 4.3.5 PCIPnP Configuration ............................................. 3. BIOS Setup (K7Upgrade-600) ........................... 22 4. BIOS SETUP UTILITY (754BRIDGE) ....................... 35 4.2 4.3 3 4.4 4.5 4.6 4.7 4.3.6 Floppy Configuration ............................................. 4.3.7 Super IO Configuration .......................................... 4.3.8 USB Configuration ................................................. Hardware Health Event Monitoring Screen ...................... Boot Screen ...................................................................... 4.5.1 Boot Settings Configuration ................................... 4.5.2 Boot Device Priority ................................................ Security Screen ................................................................ Exit Screen ........................................................................ 44 44 45 46 46 47 47 48 48 5. Software Support ............................................. 50 5.1 5.2 Install Operating System ................................................... Support CD Information ..................................................... 5.2.1 Running Support CD .............................................. 5.2.2 Drivers Menu ......................................................... 5.2.3 Utilities Menu .......................................................... 5.2.4 Contact Information ................................................ 50 50 50 50 50 50 4 1. Introduction Thank you for purchasing ASRock K7Upgrade-600 motherboard, a reliable motherboard produced under ASRock's consistently stringent quality control. It delivers excellent performance with robust design conforming to ASRock's commitment to quality and endurance. In this manual, chapter 1 and 2 contain introduction of the motherboard and step-bystep guide to the hardware installation. Chapter 3 and 4 contain the configuration guide to BIOS setup and information of the Support CD. Because the motherboard specifications and the BIOS software might be updated, the content of this manual will be subject to change without notice. In case any modifications of this manual occur, the updated version will be available on ASRock website without further notice. You may find the latest memory and CPU support lists on ASRock website as well. ASRock website http://www.asrock.com 1.1 Package Contents ASRock K7Upgrade-600 Motherboard (ATX Form Factor: 12.0-in x 8.2-in, 30.5 cm x 20.8 cm) ASRock K7Upgrade-600 Quick Installation Guide ASRock K7Upgrade-600 Support CD One 80-conductor Ultra ATA 66/100/133 IDE Ribbon Cable One Ribbon Cable for a 3.5-in Floppy Drive One Serial ATA (SATA) Data Cable One Serial ATA (SATA) HDD Power Cable(Optional) One ASRock I/O Shield One Jumper Cap Remover 5 1.2 Specifications Platform: CPU: Chipsets: ATX Form Factor: 12.0-in x 8.2-in, 30.5 cm x 20.8 cm 462-Pin Socket Supporting AMD AthlonTM / AthlonTM XP / DuronTM / 32-bit SempronTM Processor North Bridge: VIA KT600, FSB @ 400 MHz South Bridge: VIA VT8237, supports USB 2.0, ATA 133, SATA 1.5Gb/s Memory: 2 DDR DIMM Slots: DDR1, DDR2 Support PC3200 (DDR400) / PC2700 (DDR333) / PC2100 (DDR266), Max. 2GB IDE: IDE1: ATA 133 / Ultra DMA Mode 6 IDE2: ATA 133 / Ultra DMA Mode 6 Support up to 4 IDE devices Serial ATA: 2 SATA connectors Support 1.5Gb/s data transfer rate Floppy Port: Supports up to 2 floppy disk drives Audio: 5.1 channels AC'97 Audio LAN: Speed: 802.3u (10/100 Ethernet), supports Wake-On-LAN Hardware Monitor: CPU Temperature Sensing Motherboard Temperature Sensing CPU Overheat Shutdown to Protect CPU Life (ASRock U-COP)(see CAUTION 1) CPU Fan Tachometer Chassis Fan Tachometer Voltage Monitoring: +12V, +5V, +3.3V, Vcore K8 Bridge: Supports CPU upgrade from AMD K7 462-Pin CPU to AMD K8 754-Pin CPU (see page 14 for details) PCI slots: 4 slots with PCI Specification 2.3 AGP slots: 2 AGP slots, support 1.5V, 8X/4X AGP card (see CAUTION 2) 1.5V_AGP1 supports for K7 AGP Interface AGP2 supports for K8 AGP Interface USB 2.0: 8 USB 2.0 ports: include 4 ready-to-use USB 2.0 ports on the rear panel, plus two on-board headers supporting 4 extra USB 2.0 ports (see CAUTION 3) ASRock I/O: 1 PS/2 mouse port, 1 PS/2 keyboard port, 6 BIOS: OS: 1 serial port: COM1, 1 parallel port: ECP/EPP support, 4 ready-to-use USB 2.0 ports, 1 RJ-45 port, Audio Jack: Line In / Line Out / Microphone AMI BIOS Supports "Plug and Play" ACPI 1.1 compliance wake up events SMBIOS 2.3.1 support CPU frequency stepless control (only for advanced users' reference, see CAUTION 4) Microsoft® Windows® 98SE / ME / 2000 / XP compliant CAUTION! 1. While CPU overheat is detected, the system will automatically shutdown. Before you resume the system, please check if the CPU fan on the motherboard functions properly and unplug the power cord, then plug it back again. To improve heat dissipation, remember to spray thermal grease between the CPU and the heatsink when you install the PC system. 2. 3. Do NOT use a 3.3V AGP card on the AGP slot of this motherboard! It may cause permanent damage! Power Management for USB 2.0 works fine under Microsoft® Windows® XP SP1 / 2000 SP4. It may not work properly under Microsoft® Windows® 98 / ME. Please refer to Microsoft® official document at http://www.microsoft.com/whdc/hwdev/bus/USB/USB2support.mspx 4. Although this motherboard offers stepless control, it is not recommended to perform over clocking. Frequencies other than the recommended CPU bus frequencies may cause the instability of the system or damage the CPU. The CPU host frequency of this motherboard is determined by the jumper-setting. To perform over-clocking, you must set the FSB jumper according to your AMD CPU before you use the "Manual" option as the FSB setting in BIOS setup. Please check page 26 for details. 7 1.3 Motherboard Layout 1 23 PS2_USB_PWR1 1 4 20.8cm (8.2 in) SOCKET 462 5 6 PS2 Mouse CPU_FAN1 J1 1 PARALLEL PORT DDR1 (64/72 bit, 184-pin module) DDR2 (64/72 bit, 184-pin module) COM1 DDR400 PS2 Keyboard USB 2.0 Top: T: USB0 RJ-45 B: USB1 7 8 Super I/O 35 34 33 32 31 30 29 28 AGP 8X 1.5V_AGP1 J14 J6 J4 1 IDE1 IDE2 Clock Gen 30.5cm (12.0 in) AUX1 CD1 ATXPWR1 36 USB 2.0 T: USB2 B: USB3 GAME_AUDI1 VIA KT600 Chipset 1 J8 PCI LAN AGP2 4Mb BIOS J7 1 1 1 J9 K7Upgrade-600 Audio CODEC PCI 3 SATA ATA133 CMOS Battery 1 CLRCMOS2 J12 27 PCI 4 JR1 1 CHA_FAN1 SATA1 SATA2 Line Out Line In Mic In 26 GAME PORT 9 10 11 12 10 13 14 15 16 17 18 12 19 K8BRIDGE_1 K8BRIDGE_2 1 FSB400 J5 FSB_SEL0 FSB_SEL1 FSB_SEL2 J13 J11 J16 PCI 1 PCI 2 VIA VT8237 JL1 IR1 AUDIO1 1 FLOPPY1 USB2.0 5.1 CH PLED PWRBTN PANEL 1 1 USB45 1 USB67 1 SPEAKER1 1 HDLED RESET 25 24 23 22 21 20 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 PS2_USB_PWR1 Jumper CPU Fan Connector ( CPU_FAN1 ) J1 Jumper ( 5 x 3-Pin ) CPU Socket North Bridge Controller 184-pin DDR DIMM Slots ( DDR1-2 ) Primary IDE Connector ( IDE1, Blue ) Secondary IDE Connector ( IDE2, Black ) J14 Jumper ( 3 sets of 1 x2-Pin ) J4/ J5 Jumpers ( 8 x 2-Pin ) Future CPU Bridge ( K8BRIDGE_2 ) J7/ J8/ J9/ J12 Jumpers ( 4 sets of 4 x 3-Pin ) FSB Select Jumpers ( FSB_SEL0, FSB_SEL1, FSB_SEL2 ) J11/ J13/ J16 Jumpers ( 3 sets of 1 x 3-Pin ) South Bridge Controller Secondary Serial ATA Connector ( SATA2 ) Primary Serial ATA Connector ( SATA1 ) Clear CMOS Jumper ( CLRCMOS2 ) 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 Chassis Fan Connector ( CHA_FAN1 ) System Panel Header ( PANEL1 ) Chassis Speaker Header ( SPEAKER1 ) USB 2.0 Header ( USB67, Blue ) USB 2.0 Header ( USB45, Blue ) Floppy Connector ( FLOPPY1 ) Infrared Module Header ( IR1 ) Front Panel Audio Header ( AUDIO1 ) JR1 / JL1 Jumpers 4 x PCI Slots ( PCI1- 4 ) Flash Memory AGP Slot ( AGP2 ) Future CPU Bridge ( K8BRIDGE_1 ) J6 Jumper ( 5 x 2-Pin ) AGP Slot ( 1.5V_AGP1 ) Internal Audio Connector: CD1 ( Black ) Internal Audio Connector: AUX1 ( White ) ATX Power Connector ( ATXPWR1 ) 8 1.4 ASRock I/O TM 1 2 3 10 9 8 7 6 5 4 1 2 3 4 5 Parallel Port RJ-45 Port Game Port Microphone (Pink) Line In (Light Blue) 6 7 8 9 10 Line Out (Lime) USB 2.0 Ports Serial Port (COM1) PS/2 Keyboard Port (Purple) PS/2 Mouse Port (Green) 9 2. Installation K7Upgrade-600 is a ...