QUALITY, RLIABILITY, & PURE BLISS DUAL SUB BANDPASS SYSTEM ABP102N / ABP122N OPERATING INTSTRUCTIONS PLEASE RETAIN MANUAL FOR FUTRE USE AND REFERENCE Features and Specifications ABP122N Dual 12" Tuned Bandpass System High Quality MDF Construction Black Carpeted Covering 3/8" Plexiglass Window Blue Interior Neon Lighting Audiobahn Embroidery Dual 12" IMPP Cone with EPDM Rubber Surround 50 oz. Strontium Magnet 2" 4-Layer Voice Coil Bumped Back Plate Extended & Vented Pole Piece Gold Binding Post Terminals Power Handling: 800 Watts RMS Sensitivity: 103dB Frequency Response: 28Hz-150Hz Impedance: 4 Ohm Stereo Dimensions: ABP102N Dual 10" Tuned Bandpass System High Quality MDF Construction Black Carpeted Covering 3/8" Plexiglass Window Blue Interior Neon Lighting Audiobahn Embroidery Dual 10" IMPP Cone with EPDM Rubber Surround 50 oz. Strontium Magnet 2" 4-Layer Voice Coil Bumped Back Plate Extended & Vented Pole Piece Gold Binding Post Terminals Power Handling: 600 Watts RMS Sensitivity: 102dB Frequency Response: 32Hz-150Hz Impedance: 4 Ohm Stereo Dimensions: 14 7/8"(H) x 29 1/2"(W) x 17 5/8"(D) Wiring And Hookup The box can be wired in 1) a stereo configuration (each sub wired to a different channel) or 2) a mono configuration (both subs wired together to a single channel of an amp, or two bridged channels of an amp). Looking at the back of the box you will see each side's terminals. The left terminal is negative (-) and the right terminal is positive (+) for each set. If wiring in stereo mode, you will have a 4 ohm stereo load. If you wire the subs together in mono mode, you will see a 2 ohm load if wiring in parallel, and an 8 ohm load if wiring in series. Please see the Tech Tips section of this manual for wiring diagrams. Your bandpass box also comes with another terminal that looks like the one pictured above. You need to hook this up to a 12 volt power source and a ground. The power (+) is on the right side and the ground (-) on the left side. You may want to wire this up to a switch so you can turn the neon light on and off. You can wire it up to the remote wire so the neon light turns on when you turn your stereo on. ...