D1708PK PORTABLE 7" LCD MONITOR AND DVD PLAYER IN A BAG Notice: This Product incorporates copyright protection technology that is protected by method claims of certain U.S. Patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited. Notice: An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in "park" or when the vehicle's parking brake is applied. An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking brake is not applied must be installed to the rear of the driver's seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle. 2 A. Introduction Thank you for selecting the D1708PK portable DVD player in a bag. The main features include a 7" Screen (16:9 Aspect Ratio) Liquid Crystal Display (LCD) monitor and a DVD player. The unit applies the latest state of the art electronics and is designed for use in hotels, offices home or vehicle. The unit is constructed to provide years of reliable, trouble-free service, and is compact so that you can take it with you anywhere and is designed for quick and easy installation.Please read the entire instruction manual supplied with this product prior to operation. The documentation will assist you in installing the system properly to obtain the best equipment performance. All manuals should be stored for later use. B. Cautions and Warnings 1. Placement To prevent fire or electric shock, do not expose this appliance to rain or moisture. Do not place the set on an unstable cart, stand,tripod, bracket or table to prevent it from falling. Keep the unit away from strong magnets, heat sources, direct sunlight, excessive dust. If the unit is brought directly from a cold to a warm location, moisture may condense inside the unit. When you move it from a cold to a warm location, wait for about one hour before operating the unit, or remove the disc and leave the unit turned on until the moisture evaporates. 2. Installation Ensure that the D1708PK is installed in accordance with the instructions and illustrations provided in this manual. 3. Object and Liquid Do not push objects of any kind into the unit through openings; do not spill or spray liquid of any kind on or in the system (this may result in a fire or electric shock). Do not place anything heavy on the unit. To ensure proper ventilation and proper operation, never cover or block the slots and openings with a cloth or other material. 4. Disassembly Do not attempt to disassemble the cabinet. There is a risk of electric shock and/or exposure to Laser Radiation. Contact qualified service personnel if your system is in need of repair. 3 5. Cleaning Unit When cleaning, make sure the system is unplugged from the power source. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the system only. 6. Disc Do not use irregularly shaped discs such as heart or star-shaped discs as they may cause the unit to malfunction. Do not stick paper, tape or glue on the disc. Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Do not touch the surface of disc. Handle the disc by its edge. Clean the disc by wiping the disc from the center out with a cleaning cloth. Remove the disc from the unit and store it in its case after playing. Some playback operations of discs may be intentionally fixed by software producers. Since this unit plays discs according to the disc contents the software producers designed, some playback features may not be available. Also refer to the instructions supplied with the discs. C. Contents 1. 1 x 2. 1 x 3. 1 x 4. 1 x 5. 1 x 6. 2 x 7. 1 x 8. 1 x 9. 1 x 10. 1 x 7'' LCD Monitor & DVD Player Combo AC to DC Adapter Remote Control w/Battery (CR2025) Instruction Manual Audio/Video Cable Wired Headphones DC Adapter Mounting Bag w/Straps Carrying Bag Rechargeable Battery Pack D. Powering and installation 1. Powering the system indoors (Refer to Figure 1) Plug one end of the AC to DC adapter into the DC 9V jack on the right side of the main unit, then plug the other end into the 120V AC power receptacle. 4 2. Powering the system in a car Plug one end of the cigarette lighter adapter into the DC 9V jack on the unit, then plug the other end into the lighter socket. Figure 1 3. Powering the system with rechargeable Battery Please refer to L. * Rechargeable Battery Installation and Use (Page 32 and 34). E. Installation in Mounting Bag Make sure that the unit is placed into the bag with the clear plastic covering around DVD door, Load disc into the DVD compartment and then fasten the Velcro strap across the top portion of the unit. If you are installing the bag onto the seatback you will need to attach the supplied Seat Standoff to the back of the mounting bag with the Velcro bands to obtain the proper viewing angle as shown in Figure.2 5 1.Installing the System onto the seat back in a car (Refer to Figure 2) Seat Standoff Figure 2 1). Take one of the supplied straps from the carrier bag. Connect the latch to one of the upper metal rings on the mounting bag. Connect the "S" hook to the other upper metal ring and place the loop over the headrest. Adjust the strap until the bag is firmly secured. 2). Take another strap from the carrier bag, and connect the latch to the lower metal ring on the left side of the bag. Attach the "S" hook to the same ring after looping the strap around the seat rail. Repeat this process for the right side. In some vehicles, it may be necessary to attach the "S" connector to the rail directly, as it may not be long enough to reach back to the ring. 3). Adjust the straps tightly so that the bag is secured. 6 2. Installing the system between the driver/passenger seat (Refer to Figure 3) Figure 3 1). Take one strap and connect the latch to the upper metal ring on the left side of the bag. Attach the "S" hook to the same ring after looping the strap around the headrest of the driver's seat. Repeat this process for the right side (Passenger Seat). 2). Take another strap and connect the latch to lower metal ring on the left side of the bag. Attach the "S" hook to the same ring after looping the strap around the driver's seat rail. Repeat this process for the right side. In some vehicles, it may be necessary to attach the "S" connector directly to the rail, as it may not be long enough to reach back to the ring. 3). Adjust the straps tightly so that the bag is secured. 7 E. Controls, Indicators, and Connectors 1. Unit View (Refer to Figure 4) Figure 4 1) Menu 2) UP Button 3) Left Button 4) Down Button 5) OK Button 6) Right Button 7) Open Button 8) Previous Button 9) Stop Button 10) Next Button 11) Play button 12) Pause 13) Screen Mode (WIDE) Button 14) Monitor Off Button 15) Remote Control Sensor 16) Power LED 17) DVD Video Output Jack 18) DVD Audio L+R Output Jack 19) Video Input Jack 20) Audio L+R Input Jack 21) Power On/Off Switch 22) Volume Up/Down control 23) Headphone Jack 1 24) Headphone Jack 2 25) DC 9V Input Jack 26) Brightness Up/Down control 8 2. Remote Control View (Refer to Figure 5) 1) Display Button 2) Angle Button 3) Subtitle Button 4) Audio Button 5) Zoom Button 6) UP/DOWN/LEFT/RIGHT/ ENTER Buttons 7) Return Button 8) A-B Button 9) Forward Button 10) Reverse Button 11) Slow Button 12) Stop Button 13) Numeric Keypad 14) Setup Button 15) Menu Button 16) Repeat Button 17) SKIP18) SKIP+ 19) Play Button Figure 5 20) Pause Button F. Loading and Playing a Disc a. After connecting power to the unit, power on the "DVD player" with the power switch. The power indicator will light. b. Open the disc tray by pressing OPEN , and place a disc into the tray with the label side facing up. c. Close the tray by pressing the "PRESS" button.The unit will load the disc and start playing. d. Rotate the BRIGHTNESS and VOLUME controls to adjust the LCD's brightness and the DVD player's volume. e. To stop playing a disc, press STOP. f. To turn off the DVD player, slide the POWER ON/OFF to OFF. The DVD player's POWER indicator turns off. 9 G. SETUP Press `SETUP' to display the Main screen of the SETUP Menu on the screen. Press `SETUP' again to exit the SETUP Menu and the unit will resume it's last playback mode. Figure 6. Main SETUP Menu Screen 1) Press "Setup", the `GENERAL SETUP PAGE' will display on screen. Figure 7. General SETUP Menu Screen a).Select TV DISPLAY using the DOWN button, and then press RIGHT to enter the submenu. Select the TV display mode on the screen using UP/DOWN, and press ENTER to confirm the setting. Press LEFT to return. 10 * NORMAL/PS: When the player is connected to a normal TV, and a wide picture is shown on the full screen. * NORMAL/LB: When the player is connected to a normal TV, and a wide picture is shown on the screen with a black strip at both the top and bottom of the screen. * WIDE: When the player is connected to a wide screen TV, a wide picture is shown on the full screen. Figure 8. TV DISPLAY Screen Display b).Select `ANGLE MARK' using the DOWN buttton, and then press the RIGHT button to enter the submenu. Choose Angle Mark on or off using the UP/DOWN buttons and then press ENTER to confirm the setting. Press the LEFT button to return. Figure 9. ANGLE MARK Screen Display * ON: The screen will show the angle mark icon. (*If an angle option is available). * OFF: The screen will not display the Angle Mark icon. NOTE: Not all discs contain above features. 11 c). Select `SCREEN SAVER' using the DOWN button. Figure 10. SCREEN SAVER Display *ON: enables screen saver *OFF: disables screen saver (off) *NOTE: The DVD player will enter the Screen Saver mode after approximately five minutes if the same image remains on the screen. d). Select " Last Memory" by using the DOWN button. Figure 11. LAST MEMORY Screen Display *ON: The unit will return to the last position on the disc. *OFF: The unit will not return to the last position on the disc. 2) With no disc inside the player select "Video quality Setup"by using the LEFT/RIGHT buttons, press "enter" to enter the video quality set up page. Figure 12. Main SETUP Menu VIDEO QUALITY 12 a).Select "Brightness by using the UP or DOWN buttons ,then press "Enter"you can change the Brightness by pressing the LEFT or RIGHT buttons. To exit "Brightness Setting", press "Enter"again to return the main Menu. Figure 13. BRIGHTNESS Screen Display b).Select "Contrast" by using the UP or DOWN buttons,then press "Enter" you can adjust the Contrast by pressing the LEFT or RIGHT butttons. Figure 14. CONTRAST Screen Display To exit "Contrast" Setting, press "Enter"again to return to the main Menu. c).Select "Hue" by using the UP or DOWN buttons, then press "Enter" you can adjust the Hue by pressing the LEFT or RIGHT buttons. Figure 15. HUE (Tint) Screen Display To exit "Hue"Setting,press "Enter"again to return the main Menu. 13 d).Select "Saturation " by using the UP or DOWN buttons, then press "Enter" you can adjust the Saturation by pressing the LEFT or RIGHT buttons. Figure 16. SATURATION (Color)Screen Display To exit "Saturation"Setting,press "Enter"again to return to the main Menu 3).With no disc inside the player ,select "password" using the LEFT or RIGHT buttons, then press the ENTER button, then press the right button to enter the submenu. Figure 17. PASSWORD CHANGE Menu Press `ENTER' to enter the Password Change Page. Input the Old Password or the Default Password, the New Password, and the Confirmed New Password. Press `ENTER' to confirm the change. Figure 18. PASSWORD CHANGE MENU 14 Figure 19. PASSWORD VERIFY Input Screen isplay NOTE: The Default Password is 3308. This password is always effective even after you have selected your own password and changed it. To avoid the possibility of others using the default password to set the parental level and change the password, you can record this default password in another area and delete it from this manual. Some discs can be limited depending on the age of users while some discs cannot. 4).With no disc inside the player select `PREFERENCES' using the LEFT or RIGHT buttons, then press `ENTER' to enter the preferences page. Figure 20. Preference Audio Language a. Select `AUDIO' using the DOWN button, then press `RIGHT' to enter the submenu. Select t ...