® ELECTR ONICS CORP. DV9000 9" Color TV and DVD Player Floor Console For Customer Service Visit Our Website At Product Information, Photos, FAQ's Owner's Manuals WWW.audiovox.com Owner's Manual A. Introduction The DV9000 is a self-contained entertainment center for your vehicle which will make your road trips enjoyable. This versatile floor console incorporates a 9" color TV with a built-in DVD Player, complete with speakers, foil antenna, external antenna jack, headphone jacks, AV inputs, AV outputs and a remote control. The DV9000 is easily installed between the front seats of any mini or full size van. The console is constructed to provide years of enjoyment. Standardized design and manufacture ensures reliability and longevity. Please read the following instructions thoroughly for correct installation and proper operation. Store this manual in a convenient and safe place for future reference. B. Cautions and Warnings 1. Installation In order to maintain a safe mounting arrangement, this console must be secured to the floor of the vehicle according to Installation Guide contained in this manual. Failure to do so may result in the console becoming a projectile in the event of an accident. Before working under the vehicle, block the wheels to prevent accidental move ment of the vehicle which could result in injury. Before drilling any holes in the vehicle, verify that the drill bit will not damage the frame rail(s) of the vehicle, electrical wires, fuel lines, brake lines, hoses, exhaust system components or any other items that will impair the operation of the vehicle. The console must be secured to the floor panel of the vehicle. Check under the vehicle to ensure that the holes will be in the proper locations. Also check under the carpet to ensure that there are no wiring harnesses, fuel lines, etc. that could be damaged when drilling through the floor of the vehicle. 2. Power Use only the supplied power cable supplied with this set to avoid electric hazards. Always disconnect the unit from the cigarette lighter socket when it is not in use. 2 3. Discs Do not use irregularly shaped discs such as heart-or star-shaped discs as they may cause the unit to malfunction. Do not stick paper, tape or glue on the disc. Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Do not touch the surface of disc. Handle the disc by its edge. Clean the disc by wiping the disc from the center out with a clean cloth. Remove the disc from the unit and store it in its case after playing. Some playback operations of discs may be intentionally fixed by software producers. Since this unit plays discs according to the disc contents the software producers designed, some playback features may not be available. Also refer to the instructions supplied with the discs. 4.TV Reception Due to the nature of TV signals, the vehicle's motion, the direction the vehicle is facing, the distance from transmitters, nearby surroundings and weather may adversely affect TV reception. These conditions may result in picture roll, poor reception (snowy picture) and momentary loss of color (especially when the vehicle is in motion). 5. Headphones Use caution when children wear headphones; as becoming entangled in the wires could present a hazard. 6. Objects and Liquids Keep strong magnets, heat sources, direct sunlight, and excessive dust away from the unit. Do not push objects of any kind into the system through openings. Do not spill or spray liquid of any kind on or in the system (this may result in a fire or electric shock). Do not place anything heavy on the unit. To ensure proper ventilation and proper operation, never cover or block the slots and openings with a cloth or other material. 7. Disassemble To avoid harm from the laser beam assembly and to reduce the risk of electric shock, do not attempt to disassemble the cabinet. Contact qualified service personnel if your system is in need of repair. 8. Cleaning Unit When cleaning, make sure the system is unplugged from power source. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning. Clean the exterior of the system only. 3 C. Contents 1. TV and DVD Player Floor Console 2. Remote Control 3. Cigarette Lighter Adapter (for powering the unit) 4. Owner's Manual 5. Cardboard Mounting Template (for positioning the mounting holes on the floor) 6. Velcro Strips (for securing the remote to the main unit or wherever desired) 7. Hardware Package for Securing Console to Vehicle. The package contains the following: 6 Bolts 6 Sealing Washers 6 Fender Washers 6 Nuts 1 Mounting Plate D. Installation Guide (Refer to Figure 1) Figure 1 4 1. Temporarily place the cardboard mounting template in the appropriate mounting location on the floor between driver/passenger seats, with the four hole end of the template facing the front of your vehicle. Be sure to leave enough space for the disc tray to fully open. Make sure that you have checked underneath the vehicle and within the vehicle (under the carpet) for obstructions. Mark the mounting hole locations. 2. Drill 6 small 1/8" pilot holes though the marks and verify that the holes are in the proper locations on the floor. After verifying that the 1/8" pilot holes are in the proper locations, use the 1/4" drill bit to enlarge the pilot holes. 3. Place the mounting plate on the floor over the 4 holes close to the front of the vehicle, with the tongue end of the plate facing the rear of the vehicle. Place 4 floor bolts through the mounting plate and into the holes just drilled. Under the vehicle place 1 sealing washer (rubber side towards vehicle floor) and 1 large fender washer over each of the bolts and attach the nuts. In addition to the sealing washer it may be desirable to place a small circle of silicon sealer around the hole under the vehicle before installing the washers and nut. This will further prevent moisture from getting into the vehicle. Have a second person inside the vehicle hold the floor bolts securely with a box-end wrench while the person underneath the vehicle tightens down the nuts securely. 4. Set the console on the mounting plate, with the slot of the console base pointing to the tongue end of the mounting plate. Push forward to mate the console base and the floor mounting plate, with the tongue of the mounting plate projecting into the slot of the console base. 5. Place 2 bolts through the 2 holes in the front base of the console and into the 2 holes through the vertical floor. Under the vehicle place 1 sealing washer (rubber side towards vehicle floor) and 1 large fender washer over each of the bolts and attach the nuts. In addition to the sealing washer it may be desirable to place a small circle of silicon sealer around the hole under the vehicle before installing the washers and nut. This will further prevent moisture from getting into the vehicle. Have a second person inside the vehicle hold the bolts securely with a box-end wrench while the person underneath the vehicle tightens down the nuts securely. 5 E. Unit View (Refer to Figure 2 and Figure 3) OPTIONAL CONNECTIONS Figure 2 24 12 Vdc ANT FM MOD Figure 3 6 RADIO 1. Remote Control Sensor 2. Previous Button 3. Play Button 4. Next Button 5. Stop Button 6. Auto Program Button 7. TV Channel Up/Down Buttons 8. Volume Up/Down Buttons 9. Picture Select Button 10. TV/AV Select Button 11. Power Button 12. Headphone Input Jack #1* *NOTE: Mutes Internal Speakers 13. Video Input Jack 14. Audio L Input Jack 15. Audio R Input Jack 16. Headphone Input Jack #2 17. Play Button 18. Open/Close Button 19. DC Input Jack 20. Audio R Output Jack 21. Audio L Output Jack 22. Video Output Jack 23. Antenna Terminal 24. Disc Tray F. Power Supply Connection (Refer to Figure 3) 1. Open the access panel on the bottom rear of the unit by pressing the latch located on the left side of the panel toward the center of the console and pulling outward. 2. Plug one end of the cigarette lighter adapter into the DC input jack in the rear of the console. 3. Replace the access panel and have the power cord pass through either hole at the bottom of the panel. 4. Plug the other end into the cigarette lighter receptacle in the vehicle. 7 G. Remote Control View (Refer to Figure 4) 1. TV/DVD Button* 2. DVD Select Button 3. Number Buttons 4. TV/CATV Button 5. Mute Button 6. Picture Button 1 7. Volume Up/Down Buttons 2 8. AB Button 9. Up-Down/Left-Right/Enter Buttons 10. Menu Button 3 11. Display Button 12. Stop Button 13. Reverse Scan Button 4 14. Forward Scan Button 5 6 15. Audio Button 16. Subtitle Button 7 17. Power Button 18. TV Select Button 8 19. Auto Memory Button 20. TV Display Button 9 21. Skip Search Button 10 22. Erase/Write Button 11 23. Sleep Button 12 24. Channel Up/Down Button 13 14 25. DVD Power Button 15 26. Setup Button 16 27. Play Button 28. Pause Button 29. Next Button 30. Previous Button 31. Repeat Button 32. Slow Button * 17 18 19 20 21 22 23 24 25 PAUSE 26 27 28 29 30 31 32 Figure 4 Function control is available on the unit and the remote control 8 H. DVD Player 1. Basic Operation POWER* OPEN/CLOSE# PAUSE/PLAY* STOP* NEXT* PREVIOUS* FORWARD SCAN REVERSE SCAN SLOW UP/DOWN/LEFT/RIGHT ENTER NUMBERS REPEAT A-B MENU SUBTITLE AUDIO DISPLAY SETUP Turn the unit ON or OFF Open and close the disc tray Resume play mode / Go into the standby mode (1 time) Stops at the present playing point / (2 times) Stops playing Go to the next chapter, track or scene during playback Go back to the preceding chapter, track or scene during playing Scan forward at 2, 4, 6, or 8 times normal speed Scan backward at 2, 4, 6, or 8 times normal speed Play at 1/2, 1/4, or 1/8 times speed For Navigating the Set-Up Menu Execute item or setting For entering a password Repeat playing of title, chapter, or track Repeat a specific portion of the DISC from point A to point B Display the root menu of the DISC Select the subtitle language and turn it on/off Select the audio language Display information about the DISC Display the setup menu * # Function control is available on the unit and the remote control Function control is on main unit ONLY 2. Menu When you play a DVD, a root menu of the disc will appear on the screen of your TV or Monitor. The contents of the menu vary from disc-to-disc. Press MENU during playback to display the menu, and press ENTER or PLAY to start playing. Some DVDs allow you to select various options using the DVD menu. 9 3. Display (The contents vary from disc-to-disc.) 1). Playing time and remaining time a. During playback press DISPLAY to display the current title number (1), the total number of titles (2), the current chapter number (3), the total number of chapters (4), and the elapsed time for the title (5). The heading will disappear automatically in about 3 seconds. b. Press DISPLAY again to display the remaining time for the title. The heading will disappear automatically in about 3 seconds. TITLE REMAIN c. Press DISPLAY the 3rd time to display the elapsed time for the chapter. The heading will disappear automatically in about 3 seconds. 10 Press DISPLAY the 4th time to display the remaining time for the chapter. The heading will disappear automatically in about 3 seconds. Press DISPLAY the 5th time to exit. 2). Subtitle During playback press SUBTITLE to select the subtitle language you desire, the current subtitle language number (1) and the total number of subtitle languages (2) displayed. Press SUBTITLE again to select other subtitle languages. The subtitle display will disappear automatically in about 3 seconds. 3). Audio During playback press AUDIO to select the audio language desired, with the current audio channel number (1) and the total number of audio channels (2) displaying. Press AUDIO again to select other audio language's. The audio display will disappear automatically in about 3 seconds. 11 4). A-B Repeat a. During playing press A-B to set the starting point A. b. Press A-B to set the ending point B and the player will repeat edly play the part between Point A and Point B. 12 c. Press A-B the 3rd time to cancel the A-B repeat playing and resume normal playback from Point A. 5). Repeat a. During playback press REPEAT to repeat the current chapter. b. During playback press REPEAT again to repeat the current title. 13 c. During playback press REPEAT the 3rd time to cancel the repeat play and resume normal playback. The repeat display will disappear automatically in about 3 seconds. 4. Setup (The contents vary from disc-to-disc.) Press SETUP to display the main page of the setup menu on the screen. Press SETUP again to quit and the unit will resume play back. 1). Highlight GENERAL SETUP using to enter to the general setup menu. , then press ENTER 14 A. Highlight TV DISPLAY using then use the to button enter the TV DISPLAY submenu. Highlight the desired TV display mode and press ENTER to confirm the setting. Press setup to ...