VOD705 P OW ER E JE C T RE V P LAY FWD STOP PROVE8 VO LU ME CH A N N EL AU T O S OU RC E P ROG RA M S E LE C T PIC T URE S E LE C T ON OFF AUT O 8" LCD OVERHEAD TV/MONITOR WITH DVD PLAYER HEADPHONE S AUDIO IN PUT VIDEO IR L R ® ELECTRONICS CORP. 128-6700 IMPORTANT An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function then the vehicle is in `park' or when the vehicle's parking brake is applied. An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking brake is not applied, must be installed to the rear of the driver's seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle. Warnings ! Do not use any solvents or cleaning materials when cleaning the video monitor. ! Do not use any abrasive cleaners, they may scratch the screen. Use only a lightly dampened lint free cloth to wipe the screen if it is dirty. ! Lock the LCD screen in the fully closed position when not in use. ! Before putting on headphones always adjust the volume setting to the lowest position. ! Remember to leave the dome light switch in the off or auto positions when the vehicle is unattended, as the dome lights, if left on, can drain the vehicle's battery. ! Do not put pressure on the screen. ! Caution children to avoid touching or scratching the screen, as it may become dirty or damaged. Television Reception This entertainment system is designed primarily for viewing prerecorded movies or playing video games. Television reception in a moving vehicle will be limited and in some areas will not be possible due to weak and variable signal strength. Television viewing in a stationary vehicle will result in an improvement, but may still be marginal due to signal strength. The quality of the picture will not be consistent with home TV reception. Reception may be affected by weather and distance from TV station. A weak signal may cause the picture to roll, be snowy, or cause some color loss. Features Congratulations on your purchase of the Audiovox PROVE8 DVD Player with Drop-Down Video Monitor. The PROVE8 has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product and to ensure that you obtain the best results from your equipment. Please note: Installation options vary, see the individual owner's manuals for each component in your system to obtain a full understanding of each component's operation. · · · 8 Inch (4:3) TFT (Thin Film Transistor) Active Matrix LCD (Liquid Crystal Display) Monitor Built-in DVD Player Built-in TV Tuner · AVI Input · AUX (Game/Camcorder) Input OSD (On Screen Display) for Control of Picture Quality and Functions Five Frequency FM Modulator (remote control) with OSD for Frequency Display Dual Channel Infrared Transmitter for IR Wireless Headphones Headphone / Speaker Amplifier Headphone Jacks Forward and Side Remote Sensor Dome Lights with Switch Backlit Controls for Low Light Operation Full Function Remote Control · · · · · · · · · Safety Precaution For safety reasons, when changing video media it is recommended that the vehicle is not in motion, and that you do not allow children to unfasten seat-belts to change video media or make any adjustments to the system. System adjustments can be accomplished using the remote control unit, while seat-belts remain fastened. Enjoy your Audiovox entertainment system but remember-safety of all passengers remains the number one priority. Controls and Indicators Diagram 1 2 11 13 12 4 6 VO LUM E 3 5 7 9 25 PO WER EJECT V REW PLAY W F.F D STOP 14 15 16 17 CHANNE L A UTO SO URCE PIC TU RE PROG RAM SELECT SELECT 8 ON O FF AUTO 10 18 19 20 21 22 23 INPU T 24 AU DIO R HEADPHONES VIDEO ,5 L Figure 1 Note : Audiovox recommends the use of the Audiovox HP275 Headphones when using wired headphones. Main Function Descriptions 1. DVD disc insertion slot. 2. Infrared Transmitter and Sensor ­ Use to transmit audio to wireless headphones. Also allows the remote control to operate the PROVE8 and to control other accessories in the system. 3. PLAY ( ) Button ­ This button is used to enter the play mode. 4. FWD ( ) Button ­ Allows the user to search in a forward direction at 2, 4, 6 and 8 times the normal speed. 5. STOP ( ) Button. - Pressing this button once will stop playback at the current position; pressing this button twice will return to the beginning of the disc. 6. PICTURE SELECT Button ­ Each time this button is pressed, the on screen picture adjustment display cycles through "adjustment bars" for BRIGHTNESS, CONTRAST, COLOR, and TINT. Once the desired adjustment bar is displayed, use the VOLUME UP/DOWN buttons to adjust the setting. The display will automatically turn off if no adjustments are made within 6 seconds, or if any other button is depressed. 7. VOLUME DOWN (-) Button ­ Use this button to decrease the volume level of the headphone jacks. It is also to make picture adjustments in picture select mode. 8. VOLUME UP (+) Button ­ Use this button to raise the volume level of the headphone jacks. It is also used to make picture adjustments in picture select mode. Note: These buttons will not affect the volume of wireless headphones or the wired RF modulator. When using these devices the volume must be adjusted with the wireless headphone volume control or with your radio's volume control (see page 16, Wireless Headphones, or page 17, Wired FM Modulator). 9. Three · · · position Dome Light Switch Auto ­ Automatically switches on the dome lights in conjunction with the vehicle's interior illumination. Off ­ The dome lights will not turn on in this position. On ­ Turns on the dome lights. 10.Screen Release ­ Moves in direction of the arrow to release the drop down screen. ­ 11.REV ( ) ­ Allows the user to search in a backwards direction. 12.Eject ( ) Button ­ Ejects Disc. 13.Power Button ­ Bright red when system is on, dim when off. 14.Source Select (TV, AV1, AUX, DVD). 15.TV Auto-program ­ Allows the user to scan and program active TV stations into memory. 16.Channel Up ( 17.Channel Down ( ) Button ­ Use this button to increase the channel number to the desired number. ) Button ­ Use this button to decrease the channel number to the desired number. 18.Dome Lights ­ provide additional interior illumination. 19.Drop Down LCD Panel. 20.Auxiliary Audio Right Input. 21.Auxiliary Audio Left Input. 22.Auxiliary Video Input. 23.Side Remote Sensor Eye ­ Allows the remote control to operate the PROVE8 OSD (On Screen Display), control volume to wired headphone jacks and control the other accessories. Note: Audiovox recommends the use of the Audiovox HP275 Headphones when using wired headphones. 24.Headphone Jack - Allows the use of wired headphones with a 1/8" plug for listening to video program audio. 25.PROVE8 Ventilation Opening Remote Control Operation 34 33 POWER 1 SOURCE ON/OFF FM TRANSMITTER SELECT EJECT 32 2 Battery Installation Before attempting to operate your Remote Control, install the batteries as described below. 1) Turn the Remote Control face down. Using a fingernail, lift the battery cover off. 2) Install two "AAA" batteries as shown. Make sure that proper polarity (+ or -) is observed. 3) Align the cover tabs with the remote control and press down until the cover clicks. The remote control will operate the PROVE8 and Audiovox VCP's. It is not a universal remote control and will not control equipment from other manufacturers. AUTO MEMORY SKIP/ SEARCH 3 4 5 6 7 9 8 31 VOL ERASE/ WRITE 30 CH PIX MUTE 29 28 ENTER MENU SETUP 27 26 10 11 12 13 14 15 16 CH RETURN A-B REPEAT 23 21 19 24 22 20 25 18 17 DVD Function Descriptions *Function control is available on the unit and the remote control. 1. POWER Button* Press this button to turn the PROVE8 on. Press the button again to turn the PROVE8 off. 2. SOURCE Button* Video signals from video equipment connected to the audio / video inputs can be displayed on the monitor by pressing this button. Each time the button is pressed, the audio / video source will change the sources: DVD, TV, AV1 and AUX. 3. AUTO MEMORY Button* When the AUTO MEMORY button is pressed, all channels are searched and channels that are detected with signals of sufficient levels are automatically stored. Please refer to page 2 for more information on TV reception. 4. SKIP/SEARCH Button This button selects between SKIP and SEARCH mode. In "SKIP mode" the TV tuner will tune and stop on channels that are programmed into memory when CHANNEL UP/DOWN buttons are used. When the SKIP mode is disable, the TV will stop on all active channels. 5. ERASE/WRITE Button While tuned to a channel, pressing this button will store or erase the channel from memory. The stored channel numbers are displayed in "GREEN" on the LCD display screen, and the erased channel numbers are displayed in "RED". 6. Channel Up ( ) Button Use this button to increase the channel number to the desired channel and to scroll upward in menu options. 7. MUTE Button Press this button to mute the audio. Pressing the button again restores sound to the previously set level. 8. ENTER Button Used to implement setting selected. 9. LEFT ( ) Button Allows the user to shift left in the menu options. 10. MENU Button Allows the user to access the main menu. 11. RETURN Button Allows the user to return to the menu while PBC on. Note: This function only present on VCD2.0. 12. TV Mode Select Button Switches certain function keys on the remote control for TV functions. 13. DISPLAY Button Press to display DVD Disc current information. Press DISPLAY button Once Twice 3 times 4 times 5 times 6 times 7 times 8 times DVD Player Perform Display current TITLE & CHAPTER Display current SUBTITLE Display current AUDIO language & channel Display SURROUND current status Display current ANGLE Display A-B current status Display REPEAT current status Display is turn off For Title & Chapter, use cursor buttons to do title/chapter selection, then press Enter button to implement the selection. For Subtitle, Audio, Surround, Angle, A to B & Repeat, press Enter key repeatedly to change the options. These options may vary from disc to disc. 14. PAUSE ( ) Button Allows the user to pause the playback. ) Button 15. PREVIOUS ( | Allows the user to return to the previous chapter or track. 16. NEXT ( | ) Button Allows the user to skip to the next chapter or track. 17. REV ( ) Button* Allows the user to search in a backward direction at 2,4, 6 and 8 times the normal speed. 18. FWD ( ) Button* Allows the user to search in a forward direction at 2,4, 6 and 8 times the normal speed. 19. PLAY ( )Button* Press this button to activate the play mode while a disc is loaded into the disc compartment. 20. STOP (#) Button* # DVD disc play will be stopped. 21. DVD Mode Select button Switches certain function keys on the remote control for DVD functions. 22. VCP Mode Select button Switches certain function keys on the remote control for VCP functions. 23. A-B Button Allows the user to repeat play of a DVD or CD from point A to point B. 24. REPEAT Button Allows the user to repeat various positions of a DVD, CD or MP3. 25. Channel Down ( ) Button Use this button to decrease the channel number to the desired channel and to scroll downward in the menu options. 26. SETUP Button Allows the user to select the DVD player's options (Display, OSD Language, Defaults, Parental Control, Password, Exit Setup). 27. RIGHT ( ) Button Allows the user to shift to the right in the menu options. 28. PIX Button (PICTURE SELECT)* Each time this button is pressed, the on screen picture adjustment display the "adjustment bars" for BRIGHTNESS, CONTRAST, COLOR or TINT. Once the desired adjustment bar is displayed, use the VOLUME UP/DOWN buttons to adjust the setting. The display will automatically turn off if no adjustments are made within 6 seconds, or if any other button is depressed. 29. VOLUME DOWN (-) Button* Use these buttons to decrease the volume level of the headphone jacks. They are also used to make picture adjustments in picture select mode. 30. VOLUME UP (+) Button* Use these buttons to raise the volume level of the headphone jacks, They are also used to make picture adjustments in picture select mode. Note: The volume buttons will not affect the volume of wireless headphones or a wired RF modulator. When using these devices the volume must be adjusted with the wireless headphone volume control or with your radio's volume control (see ...