VOD705 VOD1021 DVD PLAYER WITH DROP-DOWN VIDEO MONITOR ® ELECTRONICS CORP. 128-7092 Release Date: 6-28-04 128-7092 1 of 28 Important Notice An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in "park" or when the vehicle's parking brake is applied. An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking brake is not applied must be installed to the rear of the driver's seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle. It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a screen that is located in the motor vehicle at any point forward of the back of the driver's seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. In the interest of safety, the VOD1021 should never be installed where it will be visible, directly or indirectly, by the operator of the motor vehicle. Warnings Do not use any solvents or cleaning materials when cleaning the video monitor. Do not use any abrasive cleaners, they may scratch the screen. Use only a lightly dampened lint free cloth to wipe the screen if it is dirty. Lock the LCD screen in the fully closed position when not in use. Before putting on headphones always adjust the volume setting to the lowest position. Remember to leave the dome light switch in the off or auto positions when the vehicle is unattended, as the dome lights, if left on, can drain the vehicle's battery. Do not put pressure on the screen. Licensed under one or more of the following patents, Patent NOS. 5,775,762 and 5,927,784 -2- 128-7092 2 of 28 Features Congratulations on your purchase of the Audiovox VOD1021 DVD Player with Drop-Down Video Monitor. The VOD1021 has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product and to ensure that you obtain the best results from your equipment. Please note: Installation options vary, see the individual owner's manuals for each component in your system to obtain a full understanding of each component's operation. · · · · · · · · · · · · · · 10.2" TFT Active Matrix Color LCD Monitor Built-In DVD Player DVD/CD/MP3 compatible On Screen Display 16:9 and 4:3 Screen Mode (switchable) IR Remote Repeater for AV1 & AV2 Inputs Dual IR Sensors Remote Control Four Source Selection (DVD/AV1/AV2/AUX) AUX Input for Game or Camcorder 6 Frequency FM Modulator (Remote Control Accessible) Dual Headphone Jacks Built-In Dual IR Transmitter Built-In Dome Lights with Switch Safety Precaution For safety reasons, when changing video media it is recommended that the vehicle is not in motion, and that you do not allow children to unfasten seat-belts to change video media or make any adjustments to the system. System adjustments can be accomplished using the remote control unit, while seat-belts remain fastened. Enjoy your Audiovox entertainment system but remember-safety of all passengers remains the number one priority. · Last position memory for DVD -3- 128-7092 3 of 28 Controls and Indicators Diagram 1 2 3 1 6 4 5 7 8 8 9 10 11 12 13 14 21 20 19 18 17 16 15 -4- 128-7092 4 of 28 Main Function Descriptions 1. DVD Disc insertion slot ­ For loading Disc. 2. POWER Button ­ Bright red when system is on dim when off. 3. EJECT ( ) Button ­ For ejecting discs from the disc compartment. 4. PLAY ( ) Button ­ This button is used to enter the play mode. 5. STOP ( ) Button ­ To stop playback. 6. Infrared Transmitter and Sensor ­ Use to transmit audio to wireless headphones. Also allows the remote control to operate the VOD1021 and to control other accessories in the system. 7. VOD1021 Ventilation Opening. 8. Dome Lights ­ Provide additional interior illumination. 9. SOURCE Select ­ Used to select one of the four sources (AV1, AV2, AUX, DVD). 10. REV Button­ Allows the user to search in a backwards direction at 2X, 4X, 6X, 8X times the normal speed. 11. PAUSE Button ­ Allows the user to pause the playback. 12. FWD Button ­ Allows the user to seach in a forword direction at 2X, 4X, 6X, 8X times the normal speed. 13. Side Remote Sensor Eye ­ Allows the remote control to operate the VOD1021, control volume to wired headphone jacks and control the other accessories. 14. AUX Input · · · Auxiliary Audio Right Input. Auxiliary Audio Left Input. Auxiliary Video Input. 15. Drop Down LCD Panel. 16. Headphone Jack ­ Allow the use of wired headphones with a 1/8" plug for listening to video program audio. 17. Screen release ­ Moves in direction of the arrow to release the drop down screen. 18. VOLUME ( ) Button ­ Use this button to decrease the volume level of the wired headphone jacks. It is also used to make picture adjustments in the picture select mode. 19. FM Select Button ­ Each time this button is pressed the FM Modulator will cycle through the following options: (FM OFF ­ POD AUDIO ­ SAT AUDIO) The frequency of the FM modulator will remain same. -5- 128-7092 5 of 28 20. VOLUME ( ) Button ­ Use this button to raise the volume level of the headphone jacks. It is also used to make picture adjustments in picture select mode. Note : Audiovox recommends the use of the Audiovox HP275 Headphones when using wired headphones. 21. Three position Dome Light Switch · Auto ­ Automatically switches on the dome lights in conjunction with the vehicle's interior illumination. · Off ­ The dome lights will not turn on in this position. · On ­ Turns on the dome lights. Note:The volume buttons will not effect the volume of the wireless headphones or the wired FM modulator. When using these devices the volume must be adjusted with the wireless headphone volume control or with your radio's volume control (see page 15, Wireless Headphones, or page 16, Wired FM Modulator). -6- 128-7092 6 of 28 Remote Control Operation POWER EJECT 1 SOURCE 32 2 3 4 5 6 MUTE AUTO MEMORY SKIP/ SEARCH ERASE/ WRITE 31 ­ VOL + 30 CH PIX 29 28 Battery Installation Before attempting to operate your Remote Control, install the batteries as described below. 1) Turn the Remote Control face down. Using a fingernail, lift the battery cover off. 2) Install two "AAA" batteries as shown. Make sure that proper polarity (+ or -) is observed. 3) Align the cover tabs with the remote control and press down until the cover clicks. The remote control will operate the VOD1021 and most Audiovox VCP's. It is not a universal remote control and will not control equipment from other manufacturers. 7 8 9 MENU Enter SETUP 27 10 11 RETURN CH REPEAT 26 25 24 23 21 12 13 34 22 33 35 20 19 18 17 14 15 16 -7- 128-7092 7 of 28 Remote Control Function Descriptions *Function control is available on the unit and the remote control. **Not used in this model. 1. POWER Button* Press this button to turn the VOD1021 on. Press the button again to turn the VOD1021 off. 2. SOURCE Button* Video signals from video equipment connected to the audio / video inputs can be displayed on the monitor by pressing this button. Each time the button is pressed, the audio / video source will change sources in the following order: DVD, AV1, AV2 and AUX. 3. AUTO MEMORY Button (AUTO PROGRAM Button)** When the AUTO MEMORY button is pressed, all channels are searched and channels that are detected with signals of sufficent levels are automatically stored. 4. SKIP/SEARCH Button** This button selects betweeen SKIP and SEARCH mode. In "SKIP mode" the TV tuner will tune and stop on channels that are programmed into memory when the CHANNEL UP/DOWN buttons are used. When in the SEARCH mode, the TV will stop on all active channels. 5. ERASE/WRITE Button** While tuned to a channel, pressing this button will either store or erase the channel from memory. The stored channel numbers are displayed in "GREEN" on the LCD display screen, and the erased channel numbers are displayed in "RED". -8- 128-7092 8 of 28 6. Channel** Up ( ) Button Used to scroll upward in menu options. 7. MUTE Button Press this button to mute the audio. Pressing the button again restores the sound to the previously set level. 8. ENTER Button Used to confirm a selected setting or option. 9. LEFT ( ) Button Allows the user to shift left in the menu options. 10. MENU Button Allows the user to access the DVD (DVD MODE) main menu and monitor menu (TV MODE). 11. RETURN Button** Allows the user to return to the menu while PBC on. Note: This function only present on VCD2.0. 12. TV Mode Select Button** Switches certain function keys on the remote control for TV functions. -9- 128-7092 9 of 28 13. DISPLAY Button Press to display DVD Disc current information. Press DISPLAY button Once Twice 3 times 4 times 5 times 6 times 7 times DVD Player Perform Display current TITLE & CHAPTER Display current SUBTITLE Display current AUDIO language & channel Display current ANGLE Display A-B current status Display REPEAT current status Display is turn off For Title & Chapter, use cursor buttons to do title/chapter selection, then press Enter button to implement the selection. For Subtitle, Audio, Angle, A to B & Repeat, press the Enter key repeatedly to change the options. These options may vary from disc to disc. 14. PAUSE ( ) Button* Allows the user to pause playback. 15. PREVIOUS ( ) Button Allows the user to return to the previous chapter or track. 16. NEXT ( ) Button Allows the user to skip to the next chapter or track. -10- 128-7092 10 of 28 17. REV ( ) Button* Allows the user to search in a backward direction at 2,4, 6 and 8 times the normal speed for DVD. Allows the user to activate the video tape rewind search mode for VCP. 18. FWD ( ) Button* Allows the user to search in a forward direction at 2,4, 6 and 8 times the normal speed for DVD. Allows the user to activate the video tape fast forward search mode for VCP. 19. PLAY ( )Button* Press this button to activate the play mode while a disc is loaded into the disc compartment for DVD. Press this button to activate the play mode while a video tape compartment for VCP. 20. STOP (!) Button* ! DVD disc play will be stopped. Video tape play will be stopped 21. DVD Mode Select button Switches certain function keys on the remote control for DVD functions. 22. VCP Mode Select button Switches certain function keys on the remote control for VCP functions. 23. A-B Button Allows the user to repeat play of a DVD or CD from point A to point B. 24. REPEAT Button Allows the user to repeat various positions of a DVD, CD or MP3. -11- 128-7092 11 of 28 25. Channel** Down ( ) Button Used to scroll downward in the menu options. 26. SETUP Button Allows the user to select the DVD player's setup options (Display, OSD Language, Defaults, Parental Control, Password, Exit Setup). 27. RIGHT ( ) Button Allows the user to shift to the right in the menu options. 28. PIX Button (PICTURE SELECT) Each time this button is pressed, the unit will display "adjustment bars" for BRIGHTNESS, CONTRAST, COLOR or TINT. Once the desired adjustment bar is displayed, use the VOLUME UP or DOWN buttons to adjust the setting. The display will automatically turn off if no adjustments are made within 6 seconds, or if any other button is pressed. 29. VOLUME DOWN (-) Button* Use these buttons to decrease the volume level of the wired headphone jacks. This button is also used to make picture adjustments in the picture select mode. -12- 128-7092 12 of 28 30. VOLUME UP (+) Button* Use this button to raise the volume level of the wired headphone jacks. This button is also used to make picture adjustments in the picture select mode. Note: The volume buttons will not affect the volume of wireless headphones or a wired FM modulator. When using these devices the volume must be adjusted with the wireless headphone volume control or with your radio's volume control (see page 15, Headphones, or page 16, Wired FM Modulator). 31. NUMBER Buttons - Allows the user to enter the numbers 0 to 9 for selection of CD tracks, DVD chapters, and password setting. - Allows the user to enter the numbers 0 to 9 for selection of TV channel. 32. EJECT ( )Button* Use this button to eject a disc. 33. FM TRANSMITTER ON/OFF Button Turns FM Modulator power on/off. 34. SOURCE SELECT Button* With FM ON, used to select from POD Audio (Selected Source mode) or SAT Audio (Second IR input). With FM OFF, used to select from SAT Audio or Car Audio. 35. CHANNEL SELECT Button Selects the FM modulator Frequency (Frequency 1, 88.3MHz, Frequency ...