A U T O T E C H Installation Instructions www.autotech.com Part Number: Description: Notes: 10.199.023K HD Polyurethane mount set, A4 Chassis trans/subframe Our A4 transmission brace bushings reduce engine `rock' under acceleration, resulting in better power transfer Procedure: 1) Remove the transmission brace from the car. Using a 16mm and a 13mm wrench, unbolt the 4 bolts marked A and B (below) and remove the brace from the car. A: 15ftlb/20Nm plus 90°; B: 30ftlb/40Nm plus 90° 2) Disassemble the brace by removing the bolt from the end. 3) Replace the rubber inserts with the new polyurethane versions. Use the diagram below as a reference for proper location and orientation. Re-install the bolt and captive nut. 18 ftlbs / 25Nm 4) Re-install the brace on the car and tighten to specification (see step 1 for torques). 1/1 32240-E Paseo Adelanto, San Juan Capistrano, CA 92675 Phone 949.240.4000 Fax 949.240.0450 ...