User manual AVENT EXPRESS BOTTLE AND BABYFOOD WARMER

AVENT®, Suffolk, CO10 7QS, England Tel. 44 1787 267 000 Fax. 44 1787 267 001 www.avent.com 83 0081 0371 #1 AVENT Express Bottle and Babyfood Warmer Please take 5 minutes to read through the whole of this leaflet before you use your AVENT Express Bottle and Babyfood Warmer for the first time and retain for future reference. The AVENT Express Bottle and Babyfood Warmer allows you to warm all AVENT feeding bottles, as well as baby food jars and tins, safely and quickly. The speed at which the Warmer heats the milk or food will depend on the size of the bottle or container and the starting temperature of the milk or food (e.g. room temperature 20 °C or out of fridge 5 °C). The attached guide gives an indication of the time you can expect the Warmer to take. Always test the temperature of feed before warming. Instructions for Use a) For AVENT Feeding Bottles 1) Ensure basket is in place inside the Bottle Warmer. 2) Place the assembled, filled bottle in the Warmer. 3) For 125 ml / 4 oz bottles, fill the Warmer with water to just above the level of milk in the bottle. 4) For larger bottles, fill the Warmer to 15 mm (1/2 inch) below the rim of the Warmer. 5) Never let the water level rise above the neck of the bottle or spill over the edge of the Warmer. 6) Plug in the unit and switch on at the mains. Turn the dial to setting 3. 7) The light will illuminate to indicate the Warmer is working. 8) When the water has reached the correct temperature, the light will come on and off to indicate that the water surrounding the bottle is being kept at a constant temperature. 9) Always shake the bottle gently and check the temperature of the milk by sprinkling a few drops on to your wrist before you feed your baby. Take care not to overheat the milk. NB: The basket can be removed when heating the AVENT Magic cup and other makes of bottles. b) For the AVENT Disposable System 1) Ensure basket is in place inside the Bottle Warmer. 2) Place the assembled, filled Disposable Bottle/Nurser in the Warmer. 3) Fill the Warmer with water to the level of milk in the bottle bag/liner. 4) Plug in the unit and switch on at the mains. Turn the dial to setting 2 and continue as 7-9 above. Do not attempt to heat milk in the Disposable bottle bags/liners on a higher setting as this could cause the bags to burst. 5) The Warmer can also be used to warm breast milk in the AVENT Disposable System in the same way. c) For baby food jars and tins: 1) Ensure basket is in place inside the Bottle Warmer. 2) Remove the lid and place jar or tin in the Warmer. 3) Fill the Warmer with water to 15 mm ( 1/2 inch) below the top of the jar/tin. 4) Turn the dial to setting 3. 5) The Warmer will work in the same way as for feeding bottles. Take care when removing the jar or tin as it, and the water surrounding it, will be hot. 6) Stir the food and test it on a spoon yourself to ensure it is not too hot for your baby. Take care not to overheat. 7) For small jars/tins you may find it beneficial to place a screw ring from an AVENT Bottle below the jar/tin before adding the water in order to remove the container easily. WARNING The AVENT Express Bottle Warmer is fitted with a non-rewireable moulded plug. In the event that this plug is unsuitable for the power sockets in your home it may be cut off and a suitable replacement fitted. Once removed, the moulded plug represents an electrical safety hazard and should be disposed of carefully. The mains supply cord of the appliance CANNOT be replaced: if the cord is damaged, the appliance should be discarded. This appliance must be earthed. This product is manufactured to comply with the Radio Interference Requirements and the EEC Directive 89/336/EEC. Guarantee Cannon AVENT guarantees that should the Express Bottle Warmer become faulty during twelve months from the date of purchase, it will be replaced free of charge during this time. Please return it to the retailer where it was purchased. Please keep your receipt as a proof of purchase, together with a note of when and where purchased. For the guarantee to be valid, please note: · The Warmer must be used according to the instructions in this leaflet and connected to a suitable electricity supply. · The claim must not be a result of accident, misuse, dirt, neglect or fair wear and tear. AVENT ® is here to help Freephone: 0800 289064 (UK ONLY) 1800 509021 (IRL ONLY) 1 300 364 474 (AUSTRALIA OUTSIDE NSW ONLY), (02) 9457 0000 (AUSTRALIA WITHIN NSW ONLY) E-mail: england@cannonavent.com write: AVENT, Suffolk, CO10 7QS, England www.avent.com AVENT America Toll free: 1-800-54-AVENT write: 475 Supreme Drive, Bensenville, IL 60106 USA www.aventamerica.com Hazard Warning · When in use the Warmer contains hot water. · Always keep the Warmer and its lead out of the reach of small children. · Before plugging in the Warmer for the first time, ensure the voltage is compatible with your electricity supply by checking the label on the base of the unit. · Always unplug from mains when not in use. · Always place bottle into Warmer before adding water. · Ensure water has been added before switching the unit on. · When the feed has reached the required temperature, remove immediately. If left in the Warmer, the temperature of the feed will continue to increase. · NEVER IMMERSE IN WATER. Care of your Bottle Warmer Unplug and allow to cool before cleaning. Remove basket and wipe inside and outside with a damp cloth only, this will keep the Warmer looking new. DO NOT USE AN ABRASIVE CLEANER. It may be advantageous to use pre-boiled or filtered water in your Bottle Warmer in order to reduce limescale build up. De-scaling You should de-scale your AVENT Express Bottle Warmer every four weeks to ensure it continues to work 100 % effectively. EITHER: Mix one sachet of citric acid (10 gms) with 200 ml / 7 fl.oz. of water. Ensure basket is in place and pour solution into Warmer. Heat for 10 minutes on setting 3. After 10 minutes, switch off by unplugging from the wall and leave to stand for 30 minutes. Pour the solution away and rinse the Warmer with tap water. OR Pour 50 ml / 2 fl.oz. of vinegar (white) mixed with 100 ml / 4 fl.oz. of cold water into the Warmer (with basket in place). Allow to stand in the unit until any limescale has dissolved. Empty the unit and rinse thoroughly. Contents a) Basket b) Bottle Warmer body c) Dial d) Babyfood container and feeding spoon