User manual AVENT EXPRESS BOTTLE STEAM STERILISER

AVENT®, Glemsford, Suffolk, CO10 7QS, England Tel. 44 1787 267 000 Fax. 44 1787 267 001 www.aventbaby.com 83 0081 0258 #4 UK 6 Bottle Steam Steriliser Please take 5 minutes to read through the whole of this leaflet before you use your AVENT EXPRESS Steam Steriliser for the first time. As well as bottles and breast feeding accessories, you can sterilise any other boilable items (please refer to the manufacturer's instructions regarding sterilisation). Please keep these instructions safe for future use. These instructions are also available on our website. HAZARD WARNING · When in use, the steriliser contains boiling water and steam escapes from the vent in the lid. · Ensure the steriliser is placed on a firm level surface when in use. · Never open the unit when in use. · Always keep out of reach of children. · Always unplug from the mains when not in use. · Never place items on top of the steriliser. · To stop the steriliser during the cycle, unplug at the mains. · Take care when opening as steam can burn. · Never immerse the steriliser in water. · The lead supplied must not be used on any other appliance and no other lead should be used with the AVENT EXPRESS Steam Steriliser. Contents (see diagram A) a) Lid b) 2 x Upper basket c) Bottle rack d) Lower basket e) Central stem f) Steriliser body g) Lead and plug h) Tongs NB: Upper and lower baskets are identical Before using your steriliser for the FIRST TIME (see diagram B) Remove all items from inside the steriliser body. 1) Pour in exactly 90ml of tap water. Check the water does not exceed the `max' line in the steriliser body. 2) Assemble all the blue components (baskets, stem and bottle rack). Place the assembled components in the steriliser and put the lid on. 3) Connect the lead into the back of the steriliser and plug into the mains supply. The light should come on automatically. If it does not, press down on the steriliser switch. 4) At the end of the cycle the unit will switch off automatically and the light will go out. 5) Allow unit to cool, turn off at the mains, unplug and disconnect the lead from the back of the steriliser. 6) Remove baskets and bottle rack, pour away any remaining water and wipe dry. BEFORE EACH USE 1) Before sterilising, wash all items in mild soapy water and rinse. 2) Pour exactly 90ml of water into the steriliser body. If you add more than 90ml you will prolong the cycle time. If you use less than 90ml, your items may not be properly sterilised. Check the water does not exceed the `max' line. NB: When loading, always ensure that the steam can effectively circulate around all surfaces and that any water can drain off easily. To sterilise up to six 260ml, 125ml or 330ml AVENT bottles (see diagram C) 1) Slide the lower basket onto the central stem. 2) Thread 2 screw rings onto the central stem. 3) Slide the bottle rack down the central stem, with the neck facing down, until it rests on the top scew ring. 4) Place the teats through the centre of the holes in the bottle rack onto the lower basket. 5) Thread 4 screw rings onto the central stem. 6) Place the 6 inverted bottles in the bottle rack. 7) Push the upper basket onto the central stem until it rests on the catch. Place the 6 dome caps and tongs into the upper basket. 8) The upper basket is not required when sterilising 330ml bottles (see diagram C8). 9) Place the assembled unit into the steriliser body and put the lid on. 10) Put the lead into the back of the steriliser body and plug into the mains supply. Switch on. 11) Cycle times will vary depending on the load. After each cycle the unit will switch off automatically and the light will go out (approx. cycle time: 8 minutes). To sterilise the AVENT ISIS Breast Pump (see diagram D) 1) Click the ISIS breast pump body into the slot in the upper basket and arrange the other breast pump components as shown. Assemble remaining components of the ISIS Breast Pump in the lower basket. 2) Up to six bottles (not including screw rings, teats or dome caps) can be sterilised with the pump. 3) Place assembled unit into the steriliser body, put the lid on. 4) Put the lead into the back of the steriliser body and plug into the mains supply. Switch on. To sterilise narrow neck bottles and other feeding items Teats should be placed around the central stem in the lower basket and screw rings in the top basket, as they are too narrow for the stem. Always ensure items are positioned within baskets / racks to ensure effective circulation of steam. The bottle rack and / or upper basket can be removed to make more room. After sterilisation (see diagram E) 1) Do not remove the lid straight away. Let the steriliser cool down for 3 minutes. 2) Turn off at the mains, unplug and disconnect the lead from the back of the steriliser. 3) Wash your hands thoroughly before removing the sterilised items. 4) Remove the lid. UK 5) If necessary, shake excess water from items before assembling. 6) The tongs can be used to remove small items and to pull the sterile teats through the screw rings of the bottles. 7) The contents will remain sterile for three hours, following the end of the cycle, provided the lid is not removed. 8) If feeds are made up after the bottles have been sterilised, they can be stored in the fridge for up to 24 hours. 9) The steriliser must be left to cool for at least 10 minutes between each use to allow the thermostat to reset. 10) After each use, pour away any remaining water, rinse and wipe dry. Dishwasher Basket (see diagram F) 1) The upper and lower baskets can be clipped together to hold small items such as teats, breast pump parts, soothers, etc for washing in the top rack of your dishwasher prior to sterilisation. 2) To clip together, align the two baskets so that the indicators are opposite each other and snap the baskets together. To open basket, pull apart with fingers using side recesses. WARNING: If your AVENT items are washed in the dishwasher with dirty items covered with remnants of strong sauces, such as tomato sauce, they may discolour over time. Care of your steriliser You should de-scale your steriliser every four weeks to ensure it continues to work 100% effectively. It may be advantageous to use pre-boiled or filtered water in your Express Steam Steriliser in order to reduce limescale build up. EITHER: 1) Mix one sachet of citric acid (10gms) with 200ml of water. Pour into the empty steriliser. Do not put lid on. Switch on for 1-2 minutes. Switch off at mains and leave to stand for 30 minutes. Drain and rinse out the steriliser. Run a full cycle empty with the lid on, using exactly 90ml of water. Wipe out the steriliser. (Citric Acid is available from most chemists ­ avoid contact with eyes as this may Troubleshooting guide Steriliser will not work Check that the mains lead is connected to the steriliser as well as plugged into the mains. Check fuse in plug. Parts incorrectly loaded. Refer to diagrams C/D. Steriliser needs de-scaling (see section headed `Care of your steriliser'). cause irritation. Keep out of reach of children.) OR: 2) Pour 100ml vinegar mixed with 200ml cold water into steriliser. Allow to stand in the unit until any limescale has dissolved. Empty the unit and rinse thoroughly. Warnings 1) Do not use bleach or chemical sterilising solutions/tablets in your steam steriliser or on products to be sterilised. 2) Do not use abrasive, anti-bacterial materials or scourers to clean the steriliser. 3) Do not use softened water in the steriliser. 4) The steriliser lead is fitted with a moulded plug. In the event that this plug is unsuitable for the power sockets in your home, it may be cut off and a suitable replacement fitted. Remove the fuse and dispose of the cut-off plug carefully, as it could be dangerous if ever inserted into a live wall socket. The replacement plug must be fitted with a 13 amp fuse. This appliance must be earthed. GUARANTEE Cannon Rubber Ltd. guarantees that should the AVENT EXPRESS Steam Steriliser become faulty during twelve months from the date of purchase, it will be replaced free of charge during this time. Please return it to the retailer where it was purchased. Please keep your receipt as a proof of purchase, together with a note of when and where purchased. For the guarantee to be valid, please note: · The AVENT EXPRESS Steam Steriliser must be used according to the instructions in this leaflet and connected to suitable electricity supply. · The claim must not be a result of accident, misuse, dirt, neglect or fair wear and tear. AVENT® are here to help AVENT, Glemsford, Suffolk, CO10 7QS, England. Freephone: 0800 289064 www.aventbaby.com Excessive steam escaping from under the lid Bottles come out with marks Steriliser takes too long to switch off Too much water is being used. Use EXACTLY 90ml of water, OR: The steriliser is loaded with only a few items ­ light loads will take longer to cycle.