RHINO CRANK COCKING DEVICE ASSEMBLY AND OPERATING INSTRUCTIONS 1. Remove the butt plate on the rear stock of your Rhino by removing the two Phillips head screws. 2. Insert Rhino Crank Device unit on the rear stock of Rhino. Attach unit with the two new screws included with the crank device shown in figure 1. Figure 1 Figure 4 Operation 1. To cock your crossbow using the Rhino Crank Device, first release the safety latch (on the crank). Then pull the hooks until they reach the groove directly behind and below the scopemounting bracket. 2. Place the rope into the groove. See Figure 2. Continue pulling the hooks down and attach to string keeping hooks tight to flight track Reengage Crank safety. See Figure 3. 3. Slowly crank the handle so that it moves in a forward rotation see figure 4. The crossbow safety will engage when crossbow is cocked. Figure 2 Figure 3 4. During shooting we recommend pulling the string hooks and rope backward off the crossbow and letting them hang fully extended below the back of the stock, or wind the rope and hooks back in. The crank handle can be rotated some to provide a comfortable shooting position. DO NOT FIRE your crossbow with the Crank Cocking Device hooks still fixed on the string. This may cause severe damage to your bow or personal injury. -------------------------------------------------------------------------------------------Barnett International Inc. Warranty Registration on opposite side *** DO NOT TURN THE HANDLE BACKWARDS WHILE DRAWING THE BOW! THIS WILL DAMAGE THE ROPE*** The latch mechanism should always be engaged when cocking the crossbow. An audible clicking sound should be present while turning the handle in a forward rotation. If this clicking sound is not present, pull latch release down to engage. If the clicking sound is still not present, improper installation may have occurred. Re-check installation and contact the Barnett Service Department at 1-800-237-4507. Note: The Crank Cocking Device cannot be turned in reverse while the latching mechanism is engaged. Once the crossbow is cocked, the latch must be disengaged so that the string hooks can be removed from the string. Always leave the latch mechanism engaged when the crossbow is not in use. Uncocking the Crossbow Do not uncock the crossbow with the Crank Cocking Device. This could cause injury and damage to your crossbow. The best way to uncock a crossbow with a Crank Cocking Device attached is to shoot an arrow into the ground. You may want to keep an old arrow in your quiver at all times for this purpose. BARNETT INTERNATIONAL INC. LIMITED WARRANTY The Crank Cocking Device is guaranteed to the original purchaser to be free of manufacturing defects for a period of one year from date of purchase. Our liability extends to parts, labor and return transportation to consumer. NOT COVERED ARE: Ropes, transportation of defective product to our Service Dept., damage caused by abuse, modification or failure to perform normal maintenance, any other expense, consequential damages, incidental damages or incidental expenses including damage to property or person. Warranty registration card (attached) must be mailed within 10 days of purchase to validate the warranty. HOW TO OBTAIN SERVICE: DO NOT return the unit to the dealer. Dealers are not authorized to make exchanges, replacements or refunds on our behalf. Attach to the product our name, address, telephone number and letter describing the problem. Carefully package and return the product, transportation charges prepaid to: Barnett International Inc. Service Dept., 13447 Byrd Drive, Odessa, FL 33556. Mark the package in large print "Service Return". There are no other warranties expressed or implied. This warranty gives you specific legal rights and you may also have other rights, which vary from state to state. Cut Out and Mail Immediately Barnett International Inc., PO Box 934, Odessa, FL 33556 CRANK COCKING DEVICE WARRANTY CARD NAME:_____________________________________________________________AGE_______________ ADDRESS:___________________________________________________________________________________ CITY:_______________________________STATE___________________ZIP____________________________+ DATE OF PURCHASE_________________________-PHONE_________________________________________ DEALER_____________________________________PRICE PAID_____________________________________ DEALER ADDRESS:___________________________________________________________________________ TYPE OF STORE: GUN SHOP ( ) DEPT. STORE ( ) SPORT STORE ( ) MAIL ORDER ( ) OTHER ( ) PLEASE SPECIFY______________________ REGISTRATION NO. _______________________________ ...