Update 01/2004 The Eigenschaften: Each single Plunger has a 3 to 4mm variable screw length "A". By changing single parts of it - Pin and/or slotted nut and/or thread cylinder - a screw-in length from 17.5 mm up to 34.5 mm can be reached. The available combinations are shown on the table on the previous page. PLUNGER C A (min) mm A (max) mm The Beiter Plunger is offered - according to the model with a choice out of two nuts, which are allowing a different screw-in depth "A" . HINTS AND MAIN FEATURES: The Beiter Plunger has a "hard" spring mounted (0.60 mm thickness). If during the tuning of your bow the notching scale cylinder goes close to 0 on the thread scale, change to the "extra hard" spring (0.70 mm thickness). This usually occurs if the arrow reacts too weak. If the thread scale goes close to 10, then replace the "hard" spring with the "soft" spring (0.45mm thickness). This usually occurs if the arrow reacts too stiff. Following table - included in each sold Plunger - shows how the single springs are reacting: with the "hard" spring (0.60) on scale position 1.0 you will reach a tensile strength of approx. 8N (Newton). You can reach the same tensile strength with an "extra hard" spring (0.70) on scale position 7.5. Important: A wrong arrow (an arrow with the wrong spine) cannot be compensated by any plunger! Werner Beiter Daimlerstr. 18 DE-78083 Dauchingen www.WernerBeiter.com Tel. +49 7720 856860 Fax +49 7720 4238 email: info@wernerbeiter.com ...