- SCOPE Ø29 D F C B A Update 09/01 BASIC EQUIPMENT: A: 1 Scope-Body B: 1 ZEISS - Lens Ø29mm C: 1 O-Ring for lens 1 O-Ring 4x2 or 5x2 D: 1 ClearThreadring, Hole-Ø1,5mm E: 1 Level in holder 1 Scope Tool F: 1 Fluor Pin Red for Hole-Ø1,5mm/sight-n1,5mm E LENSES: Convex/concave ZEISS-Lenses, extra-coated, 29mm diameter. Power: + 0.25,+ 0.50, + 0.75, + 1.00, +1.25 OPTIONS: Righthanded or Lefthanded Threads: #8-32 or #10-32 Colours: Black, Clear, Red, Green ACCESSORIES: WEATHERSHIELD Colours: Black, Red, Light THREADRINGS Colours :Black, Clear, Red, Green - no Crosshair - Crosshair, Hole-Ø1,5mm - Crosshair, Hole-Ø2,5mm FLUORPINS Colours: Red, Green Orange, Blue, Black - for Hole-Ø1,5mm/sightn1,5mm - for Hole-Ø2,5mm/sight n2,5mm Colours: Red, Green Orange - for Hole-Ø1,5mm/sight n2,5mm - for Hole-Ø2,5mm/sight n3,5mm LEVEL IN HOLDER - green level in clear holder - red level in clear holder - green level in black holder - red level in black holder MOUNTING ADVICE ATTENTION: The Scope must be fixed tight to the sight! Use following Beiter Spacers: - #8-32 (black) 2mm (a) and 5mm (b) - #10-32 (grey) 2mm (a) and 5mm (b) - O-Ring 4x2 for #8-32 (c) - O-Ring 5x2 for #10-32 (c) b c a SHIELD for LEVEL Without Pin (d), with or without break-through, Colours: Black, Red, Green, Orange, Clear With Pin (e), with or without break-through, Colours: Black, Red, Green, Orange, Clear MOUNTING ADVICE To install the shield, first push out the level, than insert the shield (pins backwards) in the device of the scope body. Reinstall and clip in the level. e f d g i h j SIGHT INSERTS Rings and Square in following colours: Black, Red, Green, Orange Rings: 4mm (f), 6mm (i) or 9mm (g) Square: 6mm (j) or 9mm (h) Use the 4mm Ring only on the shield for level without pin! Using sight inserts, the cross in the thread ring should be cut out with small pliers. Werner Beiter Technische Kunststoffteile - Daimlerstraße 18 - D-78083 Dauchingen Tel. +49/7720/85680 Fax+49/7720/4238 www.wernerbeiter.com MADE IN GERMANY e-mail: info@wernerbeiter.com ...