BAC14/19IUK05EM1.qxd 11/24/05 4:08 PM Page 1 High Velocity Air Circulator BAC14 BAC19 Holmes Products (Europe) Ltd 1 Francis Grove London SW19 4DT England Fax: +44 (0)20 8947 8272 Email: info-europe@theholmesgroup.com Website address: www.bionaire.com UK - Free phone Customer Service Helpline ­ 0800 052 3615 © 2005 JCS/THG, LLC Bionaire® and the Bionaire logo® are registered trademarks of JCS/THG, LLC. 9100010006091 BAC14/19IUK05EM1 INSTRUCTION MANUAL BAC14/19IUK05EM1.qxd 11/24/05 4:08 PM Page 3 U.K. and IRELAND PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: · Use the fan only for purposes described in the instruction manual. · To protect against electrical shock, do not immerse the fan, plug or mains cable in water or spray with liquids. · Close supervision is necessary when any appliance is used by or near children. · Unplug from the electrical outlet when not in use, when moving the fan from one location to another, before putting on or taking off parts and before cleaning. · Avoid contact with any moving parts. · Do not operate in the presence of explosives and/or flammable fumes. · Do not place the fan or any parts near an open flame, cooking or other heating appliance. · Do not operate any appliance with a damaged mains cable, plug, after the appliance malfunctions, or has been dropped/damaged in any manner. · The use of attachments not recommended or sold by the appliance manufacturer may cause hazards. · Do not let the mains cable hang over the edge of a table or counter, or come into contact with hot surfaces. · To disconnect from the electrical supply, grip the plug and pull from the wall outlet. DO NOT pull on the mains cable. · Always use on a dry, level surface. · Do not operate without the fan grills properly in place. · This product is intended for household use ONLY and not for commercial or industrial applications. · Should the appliance stop working, first check the fuse in the plug (UK only) or fuse/circuit breaker at the distribution board is operating, before contacting the manufacturer or service agent. · If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. · The appliance contains no user serviceable parts and should the product suffer damage or breakdown it must be returned to the manufacturer or its service agent. · Do not use outdoors. OPERATING INSTRUCTIONS 1. Set fan on a dry, level surface. 2. Before you plug in the cord, please make sure the speed control is in the Off position. Before plugging in the unit, fully unwind the power cord. This high quality air circulator features a multi-speed air flow selector switch, allows you to select the desired amount of air and its velocity. Air flow settings are as follows: I = Low II = Medium III = High 0 = Off BIONAIRE® Air Circulators can be used alone or in conjunction with an air conditioning unit to circulate the cooled air or to force the air into other rooms. During summer months, the portable BIONAIRE® Air Circulators can be used as a hassock fan to pick up the cooled air at floor level and circulate the cool air throughout the entire room. During the winter months your BIONAIRE® Air Circulators may be used to enhance the distribution of heated air in your home. CLEANING AND MAINTENANCE · Always unplug the fan before cleaning. · Do not allow water to drip on or into the fan motor housing. FAN STORAGE When storing your fan in the off season, it is important to keep it in a safe dry location. It is important to protect the fan from dust. WE STRONGLY RECOMMEND USING THE ORIGINAL BOX FROM PURCHASE. FITTING A REPLACEMENT PLUG FOR U.K. AND IRELAND ONLY. If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. Please refer to "Installation of a plug" below. INSTALLATION OF A PLUG APPLICABLE TO U.K. AND IRELAND WARNING - THIS APPLIANCE MUST BE EARTHED The wires in the mains lead are coloured as such: GREEN AND YELLOW - EARTH BROWN - LIVE BLUE - NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter 'E' or by the earth symbol or GREEN AND YELLOW. The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. GUARANTEE PLEASE KEEP YOUR RECEIPT AS THIS WILL BE REQUIRED FOR ANY CLAIMS UNDER THIS GUARANTEE. · This product is guaranteed for 5 years. · In the unlikely event of breakdown, please take it back to the place of purchase, with your till receipt and a copy of this guarantee. · The rights and benefits under this guarantee are additional to your statutory rights which are not affected by this guarantee. · Holmes Products Europe undertakes within the specific period, to repair or replace free of charge, any part of the appliance found to be defective provided that: · We are promptly informed of the defect. · The appliance has not been altered in any way or subjected to misuse or repair by a person other than a person authorised by Holmes Products Europe. · No rights are given under this guarantee to a person acquiring the appliance second hand or for commercial or communal uses · Any repaired or replaced appliance will be guaranteed on these terms for the remaining portion of the guarantee. THIS PRODUCT IS MANUFACTURED TO COMPLY WITH THE E.E.C. DIRECTIVES 73/23/EEC, 89/336/EEC AND 98/37/EEC. Waste electrical products should not be disposed of with Household waste. Please recycle where facilities exist. Check on the following website for further recycling and WEEE information: www.bionaire.com or e-mail info-europe@theholmesgroup.com NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. Replacement 3A fuses must be BSI or ASTA BS1362 approved. ...