ug603-5539_3750E_304 6/25/04 2:08 PM Page 1 Lift-OffTM BAGLESS USER'S GUIDE 3750 SERIES-220/240V 3 Safety Instructions 4 Product Diagram 5-6 Assembly 6-8 Operations / Special Tools 9-13 Maintenance 14 Troubleshooting 15 15 16 Consumer Services Replacement Parts Warranty ug603-5539_3750E_304 6/25/04 2:08 PM Page 2 Thanks for buying a BISSELL Lift-OffTM We're glad you purchased a BISSELL Lift-Off Vacuum. Everything we know about floor care went into the design and construction of this powerful, high-tech home vacuuming system. Your BISSELL Lift-Off is well made, and we back it with a limited comprehensive two-year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a problem, you'll receive fast, considerate assistance. My great-grandfather invented the floor sweeper in 1876. Today, BISSELL is a global leader in the design, manufacture, and service of high quality homecare products like your BISSELL Lift-Off. Thanks again, from all of us at BISSELL. Mark J. Bissell President and Chief Executive Officer 2 ug603-5539_3750E_304 6/25/04 2:08 PM Page 3 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: I I I I READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM. Always connect to a properly Earthed Outlet. Unplug from outlet when not in use and before conducting maintenance or troubleshooting. To reduce the risk of fire, electric shock, or injury: I Use indoors only. I Do not leave machine when it is plugged in. I Do not service machine when it is plugged in. I Do not use with damaged cord or plug. I Do not use machine if it has been dropped, damaged or dropped into water. I Do not handle unit with wet hands. I Do not pull or carry by cord, use cord as a handle, close door on cord, pull cord around sharp corners or edges, run appliance over cord, or expose cord to heated surfaces. I Do not carry the appliance while in use. I Do not unplug by pulling on cord. Unplug by grasping plug. I Do not handle plug or appliance with wet hands. I Do not put any object into appliance openings, use with blocked opening, or restrict air flow. I Do not expose hair, loose clothing, fingers or body parts to openings or moving parts. I Do not pick up hot or burning objects. I Do not pick up flammable or combustible materials (lighter fluid, petrol, kerosene, etc.) or use in the presence of explosive liquids or vapour. I Do not use appliance in an enclosed space filled with vapours given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapours. I I I I I I I I I I I WARNING: Not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. Remove plug from electrical outlet before cleaning or maintaining the appliance. If the supply cord ia damaged, it must be replaced by the manufacturer or its service agent in order to avoid a hazard. Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, petrol, etc.). Do not modify the Earthed plug. Do not allow to be used as a toy. Do not use for any purpose other than described in this User's Guide. Use only manufacturer's recommended attachments. Keep openings free of dust, lint, hair, etc. Keep appliance on a level surface. Turn off all controls before unplugging. Unplug by grasping the plug, not the cord. Be extra careful when cleaning stairs. Pay close attention when working around children. SAVE THESE INSTRUCTIONS. THIS MODEL IS FOR HOUSEHOLD USE ONLY. WARNING:This appliance must be Earthed. IMPORTANT FOR OPERATION ON A 220/240 VOLT A.C. 50/60 Hz POWER SUPPLY ONLY. FOR RESIDENTS OF THE UNITED KINGDOM ONLY If your appliance is fitted with a nonrewireable BS 1363 plug it must not be used unless a 13 amp (ASTA approved to BS 1362) fuse is fitted in the carrier contained in the plug. (Spares may be obtained from your BISSELL supplier). If for any reason the plug is cut off, it must be disposed of, as it is an electric shock hazard should it be inserted into a 13 amp socket. 3 ug603-5539_3750E_304 6/25/04 2:08 PM Page 4 Comfort Grip Handle Cord Clip Dusting Brush/ Upholstery Tool Hose Clip Release Button Stretch Hose Upper Tank Knob Crevice Tool Quick Release Cord Wrap Carrying Handle Power Switch Brush On/Off Switch Detachable Cylinder Louvers/Filter Frame Upper Tank Filter (Inside Louvers) Hepa Media PostMotor Filter Telescoping Extension Wand Hose Grip Power Cord Dirt Container Pre-Motor Filter Upper Tank Handle Release Pedal Lock 'n SealTM Lever Hose Grip Base Height Adjustment Knob CAUTION: vacuum Do not plug in your cleaner until you are familiar with all instructions and operating procedures. Powerfoot Furniture Protection Guard 4 ug603-5539_3750E_304 6/25/04 2:08 PM Page 5 How To Use This Guide This User's Guide has been designed to help you get the most satisfaction from your BISSELL Lift-Off. You'll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this User's Guide thoroughly before assembling your vacuum cleaner. Pay particular attention to the product diagram, assembly instructions, and part names. Locate and organize all parts before assembly. Familiarize yourself with the parts and where they fit. Following this User's Guide will greatly enhance your ability to get the most performance from your BISSELL Lift-Off for many years. WARNING: Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children. How To Put It Together The only tool you'll need to assemble your vacuum cleaner is a screwdriver. Attach Handle To Vacuum 1. 2. 3. 4. Locate the vacuum Handle and remove the screw packet taped to the base of the Handle. Stand the vacuum upright and slide the base of the Handle firmly into the grooves at the top of the vacuum body. Check to be sure the Handle is fitted to the vacuum body. If there is a gap in front, continue to push firmly until the Handle is flush. Insert two of the screws from the screw packet into the existing holes. Tighten securely with a screwdriver. Attach Vacuum Hose and Tools 1. 2. Position the Hose Assembly on the back of the Cylinder as shown. Attach the Hose with the remaining two screws from the packet. Tighten securely with a screwdriver. 5 ug603-5539_3750E_304 6/25/04 2:08 PM Page 6 Attach Vacuum Hose and Tools Continued 3. Slide the end of the Hose Grip onto the Hose Grip Base. Place the Hose into the Hose Clip. NOTE: The Powerfoot will not operate effectively unless the Hose is firmly attached to the base. Combination Tool 4. Snap the Telescoping Extension Wand, Crevice Tool, and Combination Tool into the storage clips as shown. Crevice Tool Telescoping Wand How To Use Your BISSELL Lift-Off Power Cord Quick Release The Power Cord is stored at the side of the Detachable Cylinder, wrapped around two Cord Wraps. Rotate the Upper Cord Wrap toward floor and slip the Power Cord off. CAUTION: vacuum, make Before using your sure that the Dirt Container and Upper Tank are in locked position and that all Filters (Upper Tank, Pre-Motor and Post-Motor) are in place. Do not operate your vacuum without these Filters. Quick Release Cord Wrap 1. 2. 3. Plug into an electrical outlet. To keep the Power Cord out of your way while cleaning, place it in the Cord Clip, located near the top of the Handle. Power Switch/Brush Switch The Power Switch is located just below the Handle on the front of the Detachable Cylinder. Push the rocker switch "ON" (I) to vacuum, and "OFF" (O) when cleaning is complete. The Brush Switch is located just below the handle on the front of the Detachable Cylinder next to the Power Switch. This switch turns the Rotating Brush on and off. The Brush Switch should be in the "ON" (I) position for normal carpet cleaning. You may want to turn the Brush Switch "OFF" (O) for bare floor cleaning or other delicate surfaces. NOTE: Your BISSELL Lift Off vacuum is equipped with a special internal switch that turns the Rotating Brush off whenever the unit is in the Upright position. Brush Power Handle Positions 1. 2. Upright ­ For storage and above floor cleaning with tools. Normal Cleaning ­ Press the Handle Release Pedal with your foot to recline. 6 ug603-5539_3750E_304 6/25/04 2:08 PM Page 7 Power Height Adjustment The Powerfoot on your BISSELL Lift-Off can be adjusted to clean several floor surfaces. NOTE: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. Tip: Before cleaning under low furniture, check area first for objects that might harm the unit or block the Vacuum Hose. 1. 2. Place Handle in Upright Position. Turn Height Adjustment Knob to desired setting. Lowest Setting ­ For bare floors. Medium Settings ­ For short and medium pile carpets. Highest Setting ­ For plush pile carpet. NOTE: You may also adjust the setting while in the Normal Cleaning Position. Special Tools Your BISSELL Lift-Off is not only a powerful floor vacuum cleaner, it's also a versatile stairs and above floor vacuum when you select one of the special tools. NOTE: The tools can be used with the vacuum in the Upright Position or with the Detachable Cylinder. Detach the Vacuum Hose by grasping the Hose Grip and lifting to separate from the Hose Grip Base. 1. 2. Attach tools by firmly pushing onto Vacuum Hose or Telescoping Extension Wand. Combination Dusting Brush/Upholstery Tool: Two types of cleaning tools are included in one attachment; rotate for desired tool. I Use Brush side to dust furniture, blinds, books, lamps, shelves, and baseboards. I Use Upholstery side for curtains, draperies, cushions, and fabrics. Crevice Tool: Use in tight narrow spaces. Stair Cleaning Tool: Use for stairs, area rugs, and other small carpeted areas. This tool can also be used for bare floors. Telescoping Extension Wand: Use with desired attachment for a longer reach. To extend the Wand, twist the collar to "Unlock" position and push away from you. Twist the collar to the "Lock" position to lock into place. To retract, twist to unlock, pull toward you and twist to relock. All items may not be included with your model. More tools are available; to order please refer to page 15. CAUTION: cleaner on Always place vacuum floor in its fully Upright Position and make sure it is locked into place before removing Cylinder or when using tools. Placing the Lift-Off in its full Upright Position automatically stops the rotating brush. 7 ug603-5539_3750E_304 6/25/04 2:08 PM Page 8 Cleaning With The Detachable Cylinder The Detachable Cylinder feature makes it possible to easily take the powerful cleaning action of your BISSELL Lift-Off to stairways, auto interiors, and other hard-to-reach areas of your home. Before detaching the Cylinder, your Lift-Off must be in its fully Upright Position. You do not need to turn off the power first. Press the Release Button at the top of the Cylinder Handle and lift the Cylinder to remove. Release Button 1. 2. 3. 4. 5. Detach the Vacuum Hose from the Hose Grip Base at the back of the Cylinder. Attach the desired tool(s) to the Hose Grip at the end of the Vacuum Hose. When you're done, remove the tool(s) and reconnect the Hose to the Hose Grip Base. Return the Cylinder to the Powerfoot by aligning the "feet" on the front with the bumps on the foot of the Upright Vacuum. Push the Cylinder toward the vacuum frame until it "clicks" into place. NOTICE: certain While vacuuming, Power Cord Storage When you are done using your BISSELL Lift-Off, return it to the Upright position and store the Power Cord. Turn vacuum cleaner off (O). carpets and low humidity conditions may generate small static discharges. The discharges are entirely harmless and are not associated in any way with the main power supply. 1. 2. 3. Unplug Power Cord by grasping the plug (NOT the cord) and disconnect from outlet. Loop Power Cord around Cord Wraps on side of the Cylinder. Transporting Cleaner 1. 2. To move your vacuum cleaner from room to room, put the Handle in the Upright Position, tilt the cleaner back on its rear wheels and push forward. The cleaner can also be moved by using the Carrying Handle on the Detachable Cylinder. CAUTION: Button Do not press the Release while using the Carrying Handle to transport the vacuum cleaner. The Cylinder could detach causing the rest of the vacuum to fall. Carrying Handle 8 ug603-5539_3750E_304 6/25/04 2:08 PM Page 9 How to Maintain Your BISSELL Lift-Off To maintain maximum cleaning performance, the following maintenance steps must be performed: Empty the Dirt Container when the dirt reaches the "Full" line on the side. 1. 2. WARNING: Check the ...