Radio / Cassette Bremen RCM 127 Operating instructions Table of contents Traffic safety .................................................................. 2 Important information ................................................... 3 Quick reference ............................................................. 5 KeyCard - Anti-theft system ....................................... 10 Detailed operating instructions ................................. 14 First-time installation ............................................................... 14 Operating the radio with RDS .................................................. 17 RDS information ...................................................................... 23 PTY - Programme Type ........................................................... 25 Traffic safety As the driver of a motor vehicle, it is your responsibility to pay attention to the traffic situation at all times. Never use your car radio in a way that could distract you. Please keep in mind that you travel a distance of 14 m per second at a speed of only 50 km/h. Should the traffic situation become particularly demanding, we advise you not to use the car radio equipment. Always make sure that you are still able to hear any warning signals coming from outside of the vehicle, such as police or fire engine sirens, so that you can react accordingly. As a result, you should always select a moderate volume for playing your car radio equipment while you are driving. Traffic message reception with RDS-EON ................ 29 Traffic Memo (TIM) ...................................................... 32 Warning .............................................................................. 37 Operating the tape player ........................................... 39 Operating the CD changer (optional) ........................ 44 Operating the AUX mode............................................ 52 Audio settings ............................................................. 53 DNC ......................................................................................... 54 EQ (equalizer) .......................................................................... 56 Manual equalizer ..................................................................... 56 Hi-fi calibration ......................................................................... 57 Programming with DSC .............................................. 61 Muting the audio source while using the car phone ................ 66 Specifications .............................................................. 67 2 Important information Precautions Before operating your new car radio for the first time, please read the following information carefully. Accessories Use accessories and spare parts approved by Blaupunkt only. You can use the following Blaupunkt products with this car radio: Amplifier: All Blaupunkt amplifiers, the pre-amp out cable 7 607 893 093 is required. Subwoofer pre-amp out for connecting an amplifier. CDC F 07 Installation If you would like to install your new car radio yourself or add other audio components to the existing ones, then please read the enclosed instructions on installation and connection carefully. Sub out: Changer: Car phone If there is a mobile telephone installed in your vehicle, the radio, tape player or CD player (optional) can be muted automatically when the phone is being used. It is possible to program the system so that traffic messages or the playback of stored traffic messages always have priority over the use of the telephone. (For more information, please refer to the section on muting the audio source while using the car phone.) Remote control: With the infrared remote control RC 07 you can control all of the important functions of your car radio system from the steering wheel. Navigation: The Blaupunkt RGN 06 navigation component can be added to allow active route guidance (expected to be available: mid 1997) Navigation components can only be installed by specialised Blaupunkt navigation dealerships. Other components are currently in the planning. 3 DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL CD - Betrieb (Option) PORTUGUÊS 1 2 3 4 5 6 7 8 9 10 11 14 13 12 15 2 Remote control RC 07 (optional) 1 Mute 13 4 Quick reference 1 ON / Mute Switching on/off: Press ON. To switch the set on with the ON button, the KeyCard has to be inserted. The unit will play at the pre-adjusted volume level (VOL FIX). To switch the set off, press ON for longer than 0.5 seconds. Mute: On/off: Press ON or on the remote control briefly. MUTE will appear in the display when the mute function has been activated. The set will switch off automatically if it is set to mute for longer than 5 minutes. Switching the set on for the first time: If the set is switched on for the first time or after the power supply has been disconnected, the FIRST INSTALL menu will appear in the display. If you would like to alter any of the settings, read the instructions in the section on "First installation". You can exit the FIRST INSTALL menu by pressing the selection button marked EXIT . Switching on/off with the KeyCard: Switch the set on by pressing ON. Note First read the information in the section on the "KeyCard anti-theft system". Switching on/off with the ignition: It is possible to switch the set on and off with the vehicle ignition if it has been installed to do so. After the set has been switched off using the ignition, a double beep will remind you to remove the KeyCard before you leave the vehicle. Switching the set on when the ignition is off: The set can be switched on again by pressing ON if the KeyCard is left in the set after the double beep. After playing for one hour, the set will switch off again automatically in order to save battery power. If you press ON again, the set will play again for one hour. 5 DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL CD - Betrieb (Option) PORTUGUÊS 2+/Adjusting the volume: The volume can be adjusted from VOLUME +0 to VOLUME +80. Press + or - to adjust the volume in either direction in 15 increments per second. Each time the set is switched on, it will play at the preadjusted volume level. The pre-adjusted volume level (VOL FIX) can be altered. Read the information in the section on "Programming with DSC ­ VARIOUS". Switching the volume to zero immediately: Press ON briefly. MUTE will then appear in the display and the volume will be reduced to zero immediately. Press ON again, and the set will resume playing at the volume level last set. The set will switch off automatically if it is set to mute for longer than 5 minutes. 3 TIM (traffic memo) Setting the TIM times: Press TIM for approximately 1 second. Recalling stored traffic messages: Press TIM briefly. Switching TIM off while using a car wash: Press ON to switch the set off and then press TIM. TIM-FUNCTION DEACTIVATED will appear briefly in the display. The motor antenna will retract. Be sure to read the section on "Traffic Memo (TIM)" for more important information. 4 TU (tuner) Press this key to switch to operating the radio (main menu). If you press TU while the radio is playing, the set will switch between the main menu and the menu selected last. 5 CC (compact cassette) Press to switch to operating the tape player. 6 CDC (CD changer) Press to switch to operating the CD changer (optional). If the Blaupunkt CDC F 07 changer has not been connected, NO CHANGER CONNECTED will appear in the display. 7 AUX Press to switch to any additional equipment connected. Refer to "Accessories" to find out which auxiliary equipment can be added to this system. 6 8 S (select) Press S briefly: The current time will appear in the display header. The menu for the sound settings will appear in the display. Press / to retrieve the function you would like to alter. 9 Display/Selection menu The selected mode of operation and the functions which can be selected appear in the display. It is possible to preselect colour, illumination and other settings. Refer to the operating instructions in the section on "Display settings". : Display header Indicates the current selections, e.g. when operating the radio, the station; when operating the tape player, the track. Press / or << / >> to select TREBLE, BASS, FADER or BALANCE. If LOUDNESS is highlighted in the display, this means that this function is currently active. Switch it off by pressing the corresponding softkey again. Refer to the section on "Programming with DSC ­ VARIOUS" to set the intensity. The settings for EQ (equalizer) and DNC are described separately. ; Cassette eject Open/close panel. Eject/insert cassette. / Softkeys Use these keys to select the functions appearing in the display (a new menu will appear). Other functions can be switched on/off (alternates between normal and highlighted display). to return to the previous (main) menu. Press EXIT < DSC main menu: Press S for approximately 1 second.: This activates the DSC MAIN MENU. Here you can adjust the programmable basic settings. For further information, read: "Programming with DSC". 7 DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL CD - Betrieb (Option) PORTUGUÊS = Multi-functional rocker switch or remote control buttons (optional) Radio mode CD changer mode (optional) <> Switching between reception and memory table (preference menu) / Scrolling in the selected table up / down Using the remote control, you can select the following or previous station. Select CD >> up << down Select track up: Press down: Press briefly. two or more times in quick succession. CUE - fast forward (audible): Hold pressed down. Restart same track: Press briefly. Review - fast reverse (audible): pressed down. Hold Cassette mode Additional functions for the rocker switch: Other settings can be selected in combination with the S (select) key. / >> << Select the title (S-CPS) forwards / reverse fast forward fast rewind Stop the function by pressing the opposite key. 8 > KeyCard anti-theft system You must insert the KeyCard in order to be able to operate this set. KeyCard Inserting the KeyCard While the KeyCard tongue is protruding out of its opening, insert the KeyCard into the slot with the contact area facing up. If necessary, press the KeyCard tongue to release it. Be sure to read the information in the section on the "KeyCard anti-theft system". Flashing KeyCard tongue It is possible to program this unit so that the KeyCard tongue will flash when the set is switched off and the KeyCard has been removed. This flashing light indicates to thieves that it is useless to try and steal the set. The flashing light can be switched off if desired. For further information, read the section on "Programming with DSC". ? SRC Remote control (optional) Press SRC as often as necessary in order to switch between the different operating modes for radio, tape player, CD changer (optional), AUX (if activated). 9 DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL CD - Betrieb (Option) PORTUGUÊS The KeyCard anti-theft system One KeyCard is included with the set. You can, however, also use a second KeyCard with your set. You can purchase a second KeyCard at any specialised dealership. Starting up the unit · Press ON to switch the set on. With the KeyCard tongue protruding out of its opening, insert the KeyCard into the slot with the contact area facing up. Make sure that the KeyCard is inserted properly. The car radio is now ready to operate. If a KeyCard which does not belong to the set is inserted, KEYCARD ERROR will appear in the display. Do not attempt to use the equipment in this case. After approximately 10 seconds the unit will switch off automatically. If you insert any other type of card (e.g. telephone or credit card) into the slot, the display will indicate THIS IS NO KEYCARD for approximately 2 seconds. Remove the incorrect card and insert the correct KeyCard into the unit. Following KEYCARD ERROR or THIS IS NO KEYCARD · press ON to switch the unit on. KeyCard 10 Removing the KeyCard · Press the KeyCard tongue. The KeyCard can now be removed. · Pull the KeyCard out of the slot. "Training" the second KeyCard / replacing the KeyCard A KeyCard can be "trained" as an additional KeyCard if the unit is still being operated with the original KeyCard. If you want to "train" a second KeyCard: · insert the original KeyCard and switch the unit on. · · Press S for approximately 1 second. DSC-MAIN MENU will appear in the display header. S DSC-MAIN MENU TUNER DISPLAY VARIOUS KEYCARD EXIT Select the following functions one after the other: KEYCARD (playback will be set to mute) and LEARN KC. PLEASE CHANGE CARD will appear in the display. · Remove the original KeyCard and insert the new KeyCard. LEARNING READY will then appear in the display, the new KeyCard is now "trained". The new KeyCard can now be used to operate t ...