CD 210 PWR FM TS RPD 552 ISP NS D LD/SE MIX RPT AM VOL AUD Robert Bosch Corporation Sales Group -- Blaupunkt Division 2800 South 25th Avenue, Broadview, Illinois 60155 PORTUGUÊS ESPAÑOL FRANÇAIS High-Power FM/AM/CD Receiver with Detachable Face Autoradio AM/FM à Lecteur CD de Forte Puissance et à Face Amovible Receptor FM/AM/Reproductor de CD de Alta Potencia y con Panel Extraíble Rádio FM/AM/CD de Alta Potência com Face Removível ENGLISH RPD 552 RK N/T TU FCC WARNING This equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Precautions · Carefully read this manual before using the unit. If you encounter any problems that are not covered in this manual, please consult the dealer where you purchased the unit or the dealer nearest to you. · Avoid installing the unit where it would be subject to high temperatures, such as in direct sunlight or a hot air stream from the heater, or where it would be subject to dust, dirt, or excessive vibration. · Do not turn on the unit if the temperature inside the car is very high. Always cool down the unit before usage. Parking your car in direct sunlight will result in a temperature rise. · If the unit does not turn on, check the connections first. Then check whether the fuse at the back of the unit is blown. · This unit has been designed specifically for playback of compact discs bearing the mark. Other discs cannot be played. · Do not use non-conventional discs such as heart-shaped, octagonal discs, etc. The player could be dameged. Handling the Front Panel Attaching the Front Panel ENGLISH Place the right hand side of the front panel so that the parts A of the front panel are engaged with the parts B of the unit as shown below. Then push the left hand side of the front panel until it is securely locked. Detaching the Front Panel Remove the CD from the unit, if any, and turn off the power of the unit. Press the REL to unlock the front panel from the unit. Grasp the front panel as shown below and remove it from the unit. Features · Detachable front panel · Built-in power amplifier (max. output : 52.5W × 4ch) · Digital 12-hour quartz clock · FM/AM PLL synthesizer tuner · 30 Station preset memory · Auto Store / Scan tuning · 2-ch preamp output Handling Compact Discs · Be careful when removing a compact disc after the playback is completed because the disc may be extremely hot. · Do not expose compact discs to direct sunlight or any direct heat source. · Check all compact discs before playing, and discard cracked, scratched or warped discs. · Wipe dirty or damp discs outward from the center with a soft cloth. · Do not use any solvent such as commercially available cleaners, antistatic spray, or thinner to clean the compact discs. Security To avoid theft or loss of the front panel, you can deactivate the release button REL by installing the locking screw provided. 1. 2. 3. Unscrew the bolt marked (See diagram above) Attach the front panel. * at the left front side of the unit. Select a locking screw from the mounting hardware (See page 6) and screw it into the same hole to fasten the front panel. Notes · Do not press hard on the front panel when affixing it to the unit. No more than light to moderate pressure should be needed. · Make sure there is no dust or dirt on the electrical terminals on the back of the front panel as this could cause intermitent operation or other malfunctions. E-1 Identification of Controls ENGLISH RPD 552 210 PWR CD TRK TUN/ VOL FM TS MIX RPT LD/SENS DISP AM AUD 1 2 3 4 5 6 7 8 9 10 REL button Releases the detachable front panel. CD insertion slot Insert the CD here. LCD Display window PWR button Turns the power of the unit on. Mute on/off during power on. Press for more than 2 seconds to turn off. Eject button Ejects the CD. CD button Switches the CD playback mode. FM button Selects the FM Band & FM Travel store. AM button Selects the AM Band & AM Travel store. DISP button Display selector. Clock adjustment. LD/SENS button Switches the reception sensitivity between local and distance. Loudness on/off. 11 PRESET MEMORY button During radio reception : 1 - 6/ ; For Preset memory During CD mode : 4/MIX ; For Mix play 5/RPT ; For Repeat play ; For Pause 12 AUD button Audio control selector; Bass, Treble, Balance, Fader & Mute level. Mute level is selectable. 13 / button Used to tune in to the desired station. Adjusts the bass/treble/balance. 14 / button Scan/Preset scan tuning. Scan play in CD mode. Adjusts the bass/treble/fader. 15 VOL + / ­ button Adjusts the volume and mute level. Mute is adjustable from 0 to -80. 6/ E-2 General Operations Power On/Off Turning on the power Press the PWR Volume Level Control Press the VOL / to adjust the volume level. : Volume up : Volume down. You can check the volume level visually with the indicators in the display window. Volume level meter Adjusting the Sound Characteristics Press the AUD to select the desired adjustment mode. BASS TREBLE BALANCE & FADER Mute level Press the following buttons to adjust the selected item. Make the adjustment within 5 seconds after selecting. After 5 seconds, the display window will revert to previous indication. Adjustment Range BASS -7 BASS 7 TREB -7 L to turn on the unit. Turning off the power Press the PWR 2. for more than 2 seconds. Setting the Clock The clock uses a 12-hour display system. BASS TREBLE BALANCE / / / / TREB 7 R R 1. 2. 3. Turn the ignition key to the ON position. Press the PWR 9 (Full left) 9 (Full front) 9 (Full right) 9 (Full rear) to turn on the unit. Muting the Sound Briefly press PWR while the receiver is on. on the display While muting the sound, the MUTE indicator is blinking. To restore the previous volume level, press PWR again. FADER MUTE LEVEL F (-80) (-0) Press the DISP and hold 2 seconds to start. Use the following buttons to set the clock. (The blinking section can be adjusted.) / : Adjust the Hour and minute : To activate Hour blink : To activate Minute blink Press the DISP You can check the each level visually with the indicators in the display window. Center level mark Loudness Effect When listening to music at low volume levels, this feature will boost the extremes of the bass and treble ranges to compensate for the negative characteristics of human hearing. Press the LD/SENS . The "LD" indicator appears in the display window. Pressing this button again will cancel this feature. BALANCE FADER 4. to activate the clock. Ignition-off Clock Call The display will illuminate showing the time and then automatically shut off after 5 seconds. Briefly press the DISP while the ignition switch is in the " OFF " position to activate. Display Selector Each time the DISP is pressed, the display window will change as shown below; · Radio mode Frequency and Clock. · CD mode Elapsed track time and clock. E-3 ENGLISH 1. Radio Reception Seek Tuning ENGLISH Preset Scan Tuning 1. 2. Press the AM Receiving the Memorized Stations to select the desired radio band. 1. Press the AM or FM to select the desired band. FM I FM II FM III or AM I AM II Press the or to tune in stations. Seek tuning automatically stops at a broadcasted frequency. When tuning to FM stereo broadcasting stations, the " " stereo indicator will light up in the display window. or FM 2. Press the . The unit will scan preset memory for the 12 stations from the AM I/AM II band or the 18 stations from the FM I or FM II and FM III bands. The unit will stop at each preset station for 8 seconds, before continuing to the next preset station. again to stop Preset Scan Tuning and rePress the main this on the selected frequency. 1. 2. Press the Press the AM 1 or 6/ FM to select the desired radio band. momentarily. Local/Distant (LO/DX) Selection This feature is used to select the strength of the signals at which the radio will stop during Seek Tuning. Press the LD/SENS for more than 2 seconds to select the Local setting and only the strongest (local) stations will be received. The "lo" indicator appears in the display window. Pressing again for 2 seconds will select the Distant setting and the radio will stop at a wider range of signals, including weaker more distant stations. The "lo" indicator will go out on the display window. The "Distant" setting is the recommended default mode of reception. Manual Tuning 1. 2. Press the AM Memorizing Stations Automatically (Travel Store) FM or to select the desired band. Press the or and hold for more than 0.5 second to activate the manual tuning mode. Press again to tune in to stations. After 4 seconds duration of completing Manual Tuning, the tuning control will revert to the Seek Tuning mode. 1. 2. Press the AM or FM to select the desired band. Hold the AM or FM pressed for longer than 2 seconds. Up to 6 stations with strong signals will be automatically stored in preset memory for the selected band. Note This function is available for FM III and AM II. Scan Tuning 1. 2. Press the AM or FM to select the desired radio band. Memorizing Only the Desired Stations A total of 30 stations (18 for the FM I, FM II and FM III, 12 for AM I and AM II) can be stored in preset memory. Press the . The unit will scan the selected radio band for stations. again to stop Scan Tuning and remain on Press the this selected frequency. Tips When tuned in to broadcasting stations, the antenna indicator on the display window is lit. 1. 2. 3. Press the Press the AM or or FM to select the desired radio band. to tune in stations. Press and hold the desired preset memory button 1 6/ for about 2 seconds until the frequency indicator flashes twice. The number of the pressed preset memory button appears on the display window. Note If/when you store another station on the same preset number button, the previously stored station is replaced with new one. E-4 CD Operations Playing the CD player Loading Discs Insert the disc into the CD insertion slot with the labeled side facing up. '' indicator will light up in the display window and play`` back begins automatically. Labeled side up Listening to a disc that is already loaded Press the CD to select the CD mode. Playback begins automatically. Scan Play Pausing Playback Press the 6/ . To resume playback, press the 6/ again. Stopping Playback Press the AM Repeat Play Press the 5/RPT during CD mode. The ``RPT'' indicator appears in the display window and the current track is played repeatedly. Press the 5/RPT again to cancel this feature. or FM to select the radio reception. Ejecting Discs Press the to eject the disc. Note I NEVER Insert 3-inch CD's. This unit is designed for playback of standard 5-inch CD's only. Do not attempt to use 3-inch CD singles in this unit, either with or without an adaptor, as damage to the player and/or disc may occur. The unit will turn-on automatically when a CD is inserted if the ignition switch is ``ON''. MIX Play Press the 4/MIX during CD mode. All the tracks on the current disc are played in random order. Press the 4/MIX again to cancel this feature. Playing a CD in various modes Track Search Press the or during CD mode. Track numbers appear in the display window. : Playback starts from the beginning of the next track. : Playback starts from the beginning of the current track. Press again to play the previous track. Tip/FYI During playback of a CD, the pie-shaped indicator spins. Cue / Review Press and hold the or during CD mode. Release when you have found the desired point. : To search forward. : To search backward. E-5 ENGLISH Press the during CD mode. The ``SCAN'' indicator appears in the display window. This will play the first 10 seconds of all the tracks on the disc. Press the again to cancel this feature. Installations Supplied Mounting Hardware ENGLISH Mounting Example Installation in the dashboard. Bushing Use * 3. 1. Sleeve Bushing, Screw Locking Mounting Strap Release Screw and Screws Keys Install the sleeve in the dashboard. As shown in the figure below, securely fasten the screw, which has been inserted into the bushing, at the r ...