4TUBE UNDER CAR LIGHTING KIT INSTRUCTIONS PLEASE READ CAREFULLY BEFORE INSTALLING NEON *WARNING* 1) DISCONNECT YOUR CAR BATTERY BEFORE INSTALLING NEON TUBES 2) THIS IS A HIGH VOLTAGE SYSTEM AND MAY CAUSE BURN OR SHOCK IF NEON TUBES ARE NOT PROPERLY CONNECTED.LOOSE WIRES CAN ARC AND MAY CAUSE FIRE. 3) CONSULT YOUR MECHANIC OR TECHNICIAN IF NOT SURE OF WIRING OR INSTALLATION OF NEON TUBES. *IMPORTANT* 1) MOUNT NEON TUBING A) AS HIGH INTO CHASSIS AS POSSIBLE B) AWAY FROM ALL FULL LINES .AND ANY AREA WHERE VENICLE MAY BE JACKED OR LIFTED. C) AWAY FROM EXHAUST SYSTEM,EXTREME HEAT AND MOVING PARTS. NOTE: SOME COMPACT CARS WILL ONLY ACCEPT TUBES MOUNTED BEHIND THE GRILL OR UNDER THE BUMPER. 2) WIRING : A) TRUN OFF SURPLUS WIRE BEFORE CONNECT.MAKE SURE ALL WIRES ARE AS SHORT AS POSSIBLE ,AND CLOSE TO TUBE AS ILLUSTRATED IN WIRING DIAGRAM B) ALLOW AT LEAST 2 INCHES OF CLEARANCE AF THE END OF EACH TUBE SO THAT WIRE MAY BE EASILY BENT BACK. C) MOUNT MULT-OUTLETS POWER CONNECT NEAR TO BATTERY BUT AWAY FROM ENGINE ON A FLAT METAL SURFACE. D) BLACK(GROUND) WIRES CAN BE INDIVIDUALLY SECURED TO CHASSIS ,OR TO THE BATTERY(-) CAUTION: BEFORE SWITCHING ON SYSTEM ,BE SURE TO SECURELY CONNECT ALL THE WIRES FROM TUBES TO BATTERY. 3) GENERAL INFORMATION: A) THE 12 VOLT ELECTRONIC NEON TUBES DRAW ONLY 6 AMPS AN8 AMP IN LINE FUSE IS PROVIDED. B) EACH PREWIRED NEON GLASS TUBE IS SEALED AND PROTECTED IN A HIGH IMPACT ACRYLIC TRANSPARENT COVER FOR INCREASED LIFE AND DURABILITY. C) ALWAYS CONNECT WIRES TO EACH OTHER AND SOLDER IN PLACE AND TAPE FOR BEST CONNECTIONS CONTAINS: ONE 4-TUBES KIT CONSISTING OF :4 NEON TUBES(2-3FT & 2-4FT) 1 MULTI-OUTLETS POWER CONNECTOR BLOCK,NOUNTING BRACKETS ,FUSE.SWITCH AND ALL HARD WARD WIRING DIAGRAM& INSTRUCTIONS ,READ INSTRUCTIONS CAREFULLY FOR SIIOW USE ONLY . ...