Product Division Terminals User Manual GB DUAL-COM 738 900 /1800 PRECAUTIONS Exposure to radio frequency signals Your mobile handheld portable telephone is a low power radio transmitter and receiver. When it is on, it receives and also sends out radio frequency (RF) signals. In August, 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for handheld mobile phones. Those guidelines are consistent with the safety standards set by both U.S and international standard bodies: ANSI C95.1 (1992)* NCRP Report 86 (1996)* ICNIRP (1996)* Those standards were based on comprehensive and periodic evaluations of the relevant scientific lite-rature. For example, over 120 scientists, engineers, and physicians from universities, government health agencies, and industry reviewed the available body of research to develop the ANSI Standard (C95.1). The design of your phone complies with the FCC guidelines and the above standards. Phone operation Normal position: Hold the phone as you would any other telephone with the antenna pointed up and over your shoulder. Tips on efficient operation: - Extend your antenna fully. - Do not touch the antenna unnecessarily when the phone is in use. Contact with the antenna affects call quality and may cause the phone to operate at a higher power level than otherwise needed. Driving Check the laws and regulations on the use of mobile telephones in the areas where you drive. Always obey them. Also, if using your phone while driving, please: - Give full attention to driving. Driving safety is your first responsibility. - Use hands-free operation, if available. - Pull off the road and park before making or answering a call if driving conditions so require. Aircraft Antenna care Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, or attachments could damage the phone and may vio-late FCC regulations. * American National Standards Institute; National Council on Radiation Protection and Measurement; International Commission on Non-Ionizing Radio Protection. FCC regulations prohibit the use of phones while in the air. Switch off your phone before boarding an aircraft. Blasting areas To avoid interfering with blasting operations, turn your phone off when in a "blasting area" or in areas posted: "Turn off two-way radio". Obey all signals and instructions. 2 PRECAUTIONS Electronic devices Most modern electronic equipment is shielded from RF signals. However, certain electronic equipment may not be shielded against the RF signals from your mobile phone. Pacemakers The Health Industry Manufacturers Association recommends that a minimum separation of 2.5 cm be maintained between a handheld mobile phone and a pacemaker to avoid potential interference with the pacemaker. These recommendations are consistent with the independent research by and recommendations of Wireless Technology Research. Persons with pacemakers: - Should always keep the phone more than 2.5 cm from their pacemaker when the phone is turned on. - Should not carry the phone in a breast pocket. - Should use the ear opposite the pacemaker to minimize the potential for interference. - If you have any reason to suspect that interference is taking place, turn your phone off immediately. Hearing aids Some digital mobile phones may interfere with some hearing aids. In the event of such interference, you may want to consult your network operator or service provider or call the customer service line to discuss alternatives. Other medical devices If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from external RF signals. Your physician may be able to assist you in obtaining this information. Turn your phone off in health care facilities when any regulations posted in these areas instruct you to do so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF signals. Potentially explosive atmospheres Turn your phone off when in any area with a potentially explosive atmosphere and obey all signs and instructions. Sparks in such areas could cause an explosion or fire resulting in bodily injury or even death. Areas with potentially explosive atmosphere are often but not always clearly marked. They include fuelling areas such as petrol stations, below deck on boats, fuel or chemical transfer or storage facilities, vehicles using liquefied petroleum gas (such as propane or butane), areas where the air contains chemicals or particles, such as grain, dust, or metal powders, and any other area where you would normally be advised to turn off your vehicle engine. Airbags An airbag inflates with great force. Do not place objects, including installed or portable mobile equipment in the area over the airbag or in the airbag deployment area. If in-vehicle mobile equipment is improperly installed and the airbag inflates, serious injury could result. 3 PRECAUTIONS / IMPORTANT NOTICE Vehicles RF signals may affect improperly installed or inadequately shielded electronic systems in motor vehicles. Check with the manufacturer or its representative regarding your vehicle. You should also consult the manufacturer of any equipment that has been added to your vehicle. This telephone is designed for use in either GSM 900 and GSM 1800 networks Handover between the two types of network takes place automatically and seamlessly or GSM 900 and GSM 1900 networks The telephone connects automatically to the present network. Children A mobile telephone is not a toy. Keep the phone in a safe place out of children's reach. Children may harm themselves or others and they may damage the phone. SIM card limitations Network operators offer different kinds of services and different kinds of SIM cards. Please contact your network operator for further details. Depending on your type of SIM card some features described in this user guide may not be available to you or may not be operated in the way described. Where a feature relates to the network you will see this symbol in the user guide. The memory capacity of your SIM card may differ from one type of card to another. Electrical safety This mobile telephone is intended for use when supplied with power from MA 4001, MA 4002, MA 4003 and MA 4004 chargers. The use of any other battery charging equipment will invalidate any approval given to this apparatus as well as the manufacturer's warranty. Accessories The use of other types of chargers, batteries or any accessories other than those recommended for use with this telephone will invalidate any approval given to this apparatus as well as the manufacturer's warranty on the telephone. Batteries Batteries may explode if incinerated. To prevent any injury or burn please observe that the battery terminals never get in contact with conducting objects or are short circuited. Never dispose of old batteries in your household refuse. Return them to the place of purchase or take them to a recycling centre so that they may be disposed of in an environmentally friendly manner. Care of your phone Do not try to open the phone as this might damage vital parts. The phone contains no components which can be repaired by the user. Any repair requires expertise and should be carried out only by an authorized service centre. To clean your phone, wipe over with a soft cloth. Do not use alcohol or other solvents as these will harm your phone. Do not use your mobile phone in high humidity environments or where the temperature falls below -10° or exceeds +55° C. 4 CONTENTS Precautions Page Page Page 2 4 6 7 8 Tones setup Phone setup Page 31 Page 32 ................ ........... ........... ................ ................ Important notice Keypad functions Message setup . . . . . . . . . . . . . . Page 34 Phone book setup .......... Display symbols . . . . . . . . . . . . Page Before you start ............ ....... Page 35 Page Call timers and charge . . . . . . Page 35 Security .................... .................. ................ Making your first call Options when in conversation Phone book Page 10 Page 12 Page 36 Page 38 Page 39 Calculator ...... Accessories ................ ........ ... Page 14 Index . . . . . . . . . . . . . . . . . . . . . . . Page 42 Page 15 Page 17 Page 18 Page 19 Page 19 Page 20 Page 21 Page 24 Page 26 Page 28 Page 29 Page 30 Phone book editing Alternative phone books List menu system Outgoing calls Answered calls Missed calls Messages ........... ............. ............. ................ ................... ......... Setup menu system Call divert .................. ................ ................ Call barring Call waiting Supplementary network services ........... 5 KEYPAD FUNCTIONS LED (Status indicator) Slow green flash: Your phone is in contact with a network. Fast green flash: Indicates an incoming call. Slow red flash: Your phone cannot get in contact with a network. Fast red flash: The battery needs recharging. Earphone LED On/off key Press the key for one second to switch your telephone on or off. Function keys with text line in display The function of each key varies according to whether you are in standby, menu or conversation mode. The text line at the bottom of the display will inform you of the actual function of each key at any time. Arrow keys up/down For controlling volume level when in conversation, and scrolling through menus, phone book, lists, messages etc. Voice mail key Quick access to your voice mail. Key Inserts the "+" before international phone numbers. Microphone Key Inserts a pause between the main number and the extension number. 6 DISPLAY SYMBOLS Introduction Making a call Enter phone number. Press CALL Answering a call The telephone rings. Press ANSWER Ending a call Press END Back to standby mode Press EXIT The telephone automatically returns to standby mode when no key has been pressed for 60 seconds. Call indicator SMS message indicators There is a new message for you. On: There are still unread messages. Flashing: The SMS memory is full. Voice mail indicator Indicates that there is a voice mail for you. Call divert indicator On: All calls to your mobile telephone are diverted to another telephone number. Flashing: Check the status of your call diverts. Battery level indicator See page 8 for more information. Microphone off indicator Volume level indicator Indicates volume level when adjusting. Signal strength indicator The stronger the signal (more signal bars displayed), the better the radio connection. Ring volume off indicator All-tones-off indicator List menu indicator Phone book indicator Scroll indicators Shows you that there are more functions up or down which you can access. Also used for scrolling though the list menus. Indicates which key to press to increase and decrease the volume level. See page 31 for more information. Calculator Survey of arithmetic operations in the calculator menu. Display and keypad backlighting The backlight switches on automatically when you press a key. In standby mode the light will automatically switch off if no key is pressed for 10 seconds or more. 7 BEFORE YOU START Insert rechargeable battery When changing the battery your phone should always be switched off. 1 1 2 2 3 Insert Remove Charge the battery The battery supplied with this telephone is completely discharged. The telephone will initiate charging as soon as you have inserted the charger plug. The battery takes 1 to 4 hours to become fully charged depending on type and size of the battery. To obtain optimum battery performance in daily use, wait until the battery is completely discharged, before recharging to full capacity. Battery level indicator During charging the battery symbols will flash on and off one after another continuously from the bottom of the display up. When the battery is fully charged all 4 symbols are permanently displayed as long as the phone is switched on. 4 batteries: Battery is fully charged. 1- 3 batteries: Battery is partly discharged. 0 batteries: Battery needs recharging. You have limited conversation time left. At the same time the phone will emit a short warning tone and the LED on top of the phone will emit a fast red flash. If you insert another battery, this should be fully charged in order to read out the battery capacity accurately. 8 BEFORE YOU START Insert SIM card Before you can make a call on your mobile phone you have to insert the SIM card. Should you have forgotten to insert the SIM card the telephone will ask you to do so. Before inserting the SIM card into the phone please make sure that any plastic remains from the frame punching have been removed. 1. Switch off your phone. 2. Remove the battery if attached on the phone. 3. Insert the SIM card in the slot and slide it upwards until the locking catch snaps. Please note that the truncated corner should be at the b ...