User manual BOSE 151

BOSE 151 ® ® ENVIRONMENTAL SPEAKERS OWNER'S GUIDE AM171297_09_V.pdf July 15, 2003 Customer information The serial numbers on my 151® speakers are: and I purchased them on: from: Table of contents How and where to use Bose® 151 speakers ................................. 3 Decide where you want the speakers ................................. 4 Unpack the speakers ............................ 5 How to hook up Bose 151 speakers ....... 5 Choose the speaker cord ...................... 5 Use the cord properly ........................... 6 Make the connections ........................... 6 Retailer Check the connections ......................... 7 Test the connections ............................. 7 Address Accessories ............................................. 8 How to maintain Bose 151 speakers .................................. 8 Protect the connections ........................ 8 How to clean the speakers .................... 8 City State Zip Telephone How to check out problems .................. 9 Warranty period .................................... 9 For information .................................... 10 Technical information ........................... 11 2 AM171297_09_V.pdf July 15, 2003 Thank you for purchasing Bose® 151® environmental speakers. Their proprietary Bose technologies and all-weather construction offer you listening enjoyment both indoors and out. How and where to use Bose 151speakers Bose 151 speakers are designed to meet the challenges of year-round outdoor use. They can deliver Bose quality sound to areas where you work, play, and relax outside. From potting shed to workshop, patio to poolside, they will extend your musical pleasure. You can even install 151 speakers on board your boat. You may also use these speakers indoors, in areas where high humidity is common, such as an indoor pool area or bathroom. Once you decide where you will use your 151 speakers, consider the optional allweather mounting and installation accessories from Bose. (Refer to "Accessories" on page 8.) AM171297_09_V.pdf July 15, 2003 3 Decide where you want the speakers For best results, mount both speakers on the same wall, facing the listening area. Make sure they do not face each other. (Outdoors, if you are not using an existing wall, consider the length of your listening area as your "wall.") Measure the length of the wall and divide that length by six. Place one speaker onesixth the length from the left end of the wall. Place the other speaker one-sixth the length from the right end (see Figure 1). If you place your 151® speakers outdoors, you will probably connect them to an amplifier or receiver that is inside. Note: You may want to consult an electrical installer who can route wires underground or through walls if necessary. Whether you mount them inside or out, consider the following: · Measure the length of speaker cords you need to connect each speaker to your receiver or amplifier. To determine the wire gauge you will need, refer to the wire gauge recommendations under "Technical information" on page 10. · It is important that the speaker cord not be tripped over, pinched, or pulled. Determine the best route to protect the wire. ;;;;;;; ;;;;;;; Length of wall 1/6 length of wall ® ® ;;;;;;;; ;;;;;;;; ;;;;;;;; Figure 1 Place one speaker one-sixth of the way from each end of the wall. 4 AM171297_09_V.pdf July 15, 2003 · Regardless of where you place your speakers, make sure they cannot fall and cause injuries. See "Accessories" on page 8. · Bose 151® speakers are not magnetically shielded. Keep them at least 9 inches (23 cm) from any video screen or monitor. Note: Magnets in the speakers will affect a boat compass. Consider this in choosing a speaker location, or make sure to correct for this deviation. · On a boat, you can surface mount the speakers or mount them flush to the bulkhead. (Refer to "Accessories" on page 8.) Note: To flush-mount 151 speakers in a boat, you must cut a hole in the bulkhead for each speaker. You may want to consult a marine electronics installer (employed by most boat yards) before cutting any holes. How to hook up Bose 151 speakers ® CAUTION: Before making any connections, turn off your receiver or amplifier and unplug it from the outlet (the AC power mains). Choose the speaker cord Be sure to use the proper gauge (thickness) of speaker cord. Standard zip cord (2conductor, 18-gauge wire found at electrical and hardware stores) works for most applications. If your speakers will be more than 30 feet (9 m) from the receiver or amplifier, see the wire recommendations under "Technical information" on page 10. Or check with your authorized Bose dealer. If you decide to run the speaker cord through a wall or underground, check your local building code requirements, or contact an electrical installer before proceeding. Note: Be sure to cut enough cord to reach from the receiver to each speaker. Unpack the speakers Unpack each speaker carefully. Save the carton and packing materials for possible later use. If either speaker appears damaged, do not operate either one. Repack both speakers in the original carton and notify your authorized Bose dealer immediately. AM171297_09_V.pdf July 15, 2003 5 Use the cord properly Speaker cord consists of two insulated wires. The insulation around one wire is striped, collared, or ribbed. This marked wire is always positive (+). The plain wire is always negative (­). These correspond to the red (+) and black (­) terminals on the back of the speaker, receiver, or amplifier. Be sure to connect each wire to the proper terminal (positive to positive, negative to negative). · Prepare the ends of each cord At the ends of each cord, strip approximately 1/2 inch (12 mm) of insulation from both wires. Twist the bare ends of each wire. · Connect the cords to your speakers At the back of your speaker, unscrew the hex knob on one terminal post. This reveals a small opening through the post. Insert the bare end of one wire into the opening. Tighten the knob to secure the wire. Now insert the second wire into the second terminal post (see Figure 2). · Protect the cord To guard against weather wear on exposed wires, see "How to maintain Bose® 151® speakers" on page 8. Make the connections 1. Connect the first cord to the left channel of your receiver or amplifier. a. Attach the marked wire at one end to the red (+) terminal. b. Attach the plain wire at that end to the black (­) terminal. 2. Connect the other end of the same cord to your left speaker. a. Attach the marked wire to the red (+) terminal post. b. Attach the plain wire to the black (­) terminal post. 3. Connect the second cord to the right channel and right speaker, following the same procedure. ® Figure 2 Insert the bare wire end into the opening on the terminal post. 6 AM171297_09_V.pdf July 15, 2003 ® ® Receiver or Amplifier Figure 3 Check the connections Check the speaker and receiver or amplifier connections carefully. Make sure no loose strands of wire touch across terminals. This could create short circuits that can damage an amplifier or receiver. Tighten any loose connections before you plug in the receiver or amplifier. Test the connections To make sure your speakers operate correctly: 1. Set your receiver or amplifier for MONO (monophonic) and turn it on. Set the balance control to normal (centered). Place the speakers less than 6 inches (15 cm) apart, facing each other. Play some deep bass passages of music through the speakers. 2. 3. The sound should seem to come from a point between the two speakers. The bass should be full and natural. If not, your connections may be out of phase. Reverse the connections on the back of one speaker. Then repeat steps 1 ­ 3. AM171297_09_V.pdf July 15, 2003 7 Accessories Bose Model SM-1 outdoor surface-mount brackets give sturdy support to 151® speakers attached to a shelf, wall, ceiling, roof overhang, or boat. You can mount the brackets horizontally or vertically, and change the angle to direct the sound. Bose FM-1 outdoor flush-mount brackets securely anchor 151 speakers to the bulkhead of a boat. These brackets install through the bulkhead surface, so only the speaker face and bracket trim are exposed. To order these brackets, or for more information about them, contact your authorized Bose retailer, or to contact Bose directly, see "Bose Corporation" on page 63. How to maintain Bose 151 speakers ® Protect the connections The bare wire ends of the speaker cord can be affected by exposure to the elements. This is especially true of salt water exposure. You may use a silicone caulking material, such as RTV adhesive, to protect the connections. It is commonly available at hardware stores. If you do use caulking, apply it only after the wires are connected and the knobs tightened down. Check the caulking annually, and re-apply as needed. How to clean the speakers Use a cloth dampened in mild detergent and water to remove dust or dirt from the outside of your 151 speakers. Or use a hose to rinse them thoroughly with fresh water. Do not use enough pressure to force water behind the grille and into the driver or the acoustic port. 8 AM171297_09_V.pdf July 15, 2003 How to check out problems If you have any problems with your 151 environmental speakers, the suggestions below may save you a call for service. If neither speaker plays · Check the settings on your receiver or amplifier. Refer to the owners guide that came with it for instruction on settings. If the bass or treble is weak · Check the tonal balance setting on your receiver or amplifier. If only one speaker plays · Check the balance control on your receiver or amplifier. · Check the wires connected to the speaker that does not play. Make sure the wires are in good condition and are firmly connected. Review the "Hook up your speakers" section on page 5. If one speaker still does not play Disconnect the wires from the speaker and the receiver or amplifier. Disconnect the other cord from its speaker, and connect that end of the cord to the speaker that doesn't play. · If the speaker still doesn't play, the problem is in the speaker. · If the speaker now plays, continue checking for the source of the problem. Disconnect the same cord from the amplifier or receiver. Connect it to the other outputs on the amplifier or receiver. ® · If the speaker plays, the problem is in the original cord that was connected to that speaker. · If the speaker does not play, the problem is in that channel of the receiver. If the above solutions fail to solve your problem, contact your authorized Bose® dealer to arrange for service, or to contact Bose directly, see "Bose Corporation" on page 63. Bose Corporation will make every effort to resolve the problem, within the terms of your warranty . Warranty period Bose 151 environmental speakers are covered by a limited five-year transferable warranty. Details of coverage are on the warranty card that came with your speakers. Please fill out the information section, detach, and mail it to Bose. AM171297_09_V.pdf July 15, 2003 9 Technical information Protective features · Nickel-plated brass connection terminals · Syncom® computer quality control Driver complement · One (1) 4.5" (11.4 cm) full-range environmental driver per speaker Enclosure · Dual-port molded polypropylene · Black or white Dimensions · 6.1"H x 9.1"W x 5.9"D (15.5 x 23.1 x 14.9 cm) Compatibility · Rated 40W IEC power handling; rated 4 ohms. Compatible with amplifiers or receivers rated 10-80 watts per channel Conditioned · Designed to withstand: ­ salt fog, sun, high humidity (100%RH) ­ temperature extremes (-22 to 140°F; -30° to 60°C) ­ vibrations, mechanical shock Wire recommendations · Based on a maximum frequency response deviation of ± 0.5 dB/ Gauge 18 (0.75 mm ) 16 (1.5 mm ) 14 (2.0 mm ) Weight · 9.5 lb (4.3 kg) per pair, in the carton 2 2 2 Length 30 ft (9 m) maximum 45 ft (14 m) maximum 70 ft (21 m) maximum 10 AM171297_09_V.pdf July 15, 2003 Bose Corporation USA Bose Corporation, The Mountain Framingham, MA 01701-9168 1-800-367-4008 Phone hours - ET (eastern time) Weekdays 8:30 a.m. to 8 p.m. Saturdays 9 a.m. to 3 p.m. Canada Bose Ltd., 1-35 East Beaver Creek Rd. Richmond Hill, Ontario L4B 1B3 1-800-465-2673 Phone hours - ET (eastern time) Weekdays 9 a.m. to 5 p.m. European Headquarters Bose B.V., Nijverheidstraat 8 1135 GE Edam, Nederland TEL 0299-390111 FAX 0299-390114 Australia Bose Australia, Inc. 1 Sorrell Street Parramatta, N.S.W. 2150 TEL 02 204-6111 FAX 02 204-6122 Austria Bose Ges.m.b.H., Vienna Business Park Wienerbergstrasse 7 (10.OG) A-1100 Vienna TEL 01-60404340 FAX 01-604043423 Belgium Bose N.V., Limesweg 2 B-3700 Tongeren TEL 012-390800 FAX 012-390840 Denmark Bose A/S, Industrivej 7 2605 Brøndby FAX 4343-7818 TEL 4343-7777 France Bose S.A., 6, rue Saint Vincent 78100 Saint Germain en Laye TEL 01-30616363 FAX 01-30614105 Germany Bose GmbH, Max-Planck-Straße 36d D-61381 Friedrichsdorf TEL 06172-71040 FAX 06172-710419 Holland Bose B.V., Nijverheidstraat 8 1135 GE Edam TEL 0299-390111 FAX 0299-390109 India Bose Corporation India Private Limited W-16, Greater Kailash-II New Delhi 110 048 TEL (011) 648 4462 FAX (011) 648 4463 Ireland Bose Corporation Carrickmacross, Co Monaghan TEL 042-9661988 FAX 042-9661998 Italy Bose S.p.A., Via della Magliana 876 00148 Roma TEL 06-65670802 FAX 06-65680167 Japan Bose K.K., Shibuya YT Building, 28-3 Maruyama-cho, Shibuya-ku, Tokyo 150 TEL 3-5489-0955 FAX 3-5489-0592 Norway Bose A/S, Solheimsgate 11 N-2001, Lillestrøm TEL 63-817380 FAX 63-810819 Sweden Bose A/S, JohanneFredsgatan 4 S-43153 Mölndal TEL 31-878850 FAX 31-274891 Switzerland Bose AG, Rünenbergerstrasse 13 4460-Gelterkinden TEL 061-9815544 FAX 061-9815502 United Kingdom Bose Limited 1 Ambley Green Gillingham Business Park Gillingham, Kent ME8 0NJ TEL 0870-741-4500 FAX 0870-741-4545 Other Locations Bose Service,1 New York Avenue Framingham, MA 01701-9168 USA TEL (508) 766-1900 FAX (508) 766-1919 World Wide Web www.bose.com AM171297_09_V.pdf July 15, 2003 ©2003 Bose Corporation, The Mountain Framingham, MA 01701-9168 USA 171297 AM Rev.09 JN10781 AM171297_09_V.pdf July 15, 2003