BLOCK DIAGRAM CALIBRE BLACK GROUND #8 X 1/2" TEK *NOTE: THE RED WIRE SHOULD BE CONNECTED TO A MINIMUM 16 GAUGE +12 VOLT IGNITION WIRE. RED INTERIOR NETWORK MODULE IGNITION SWITCHED +12 VOLTS AMPLIFIED SPEAKER BROWN BLUE WHITE GRAY WHITE BLUE FRONT +12 VOLT BATTERY OR IGNITION SOURCE RECEIVER CABLE FUSE CONNECTION REAR RECEIVER CABLE FRONT RADAR pod FUSE CONNECTION REAR RADAR pod (CALIBRE DL-P model only) 1AMP WHITE YELLOW* BROWN* BLACK YELLOW* BROWN* BLUE 1AMP +12 VOLT BATTERY OR IGNITION SOURCE BLACK COPPER COPPER SILVER (NOT USED) CLEAR ZIP CORD GROUND #8 X 1/2" TEK COPPER COPPER SILVER (NOT USED) GROUND #8 X 1/2" TEK BLACK ZIP CORD CLEAR ZIP CORD BLACK ZIP CORD *THE YELLOW AND BROWN RADAR RECEIVER WIRES ARE USED TO CONNECT TO THE OPTIONAL LASER DEFUSER(S). IF A LASER DEFUSER IS NOT BEING INSTALLED WITH A RADAR RECEIVER (FRONT AND/OR REAR), THE YELLOW AND BROWN WIRES WILL NOT BE USED. FRONT LASER DEFUSER (OPTIONAL) REAR LASER DEFUSER (OPTIONAL) IGNITION AND GROUND 1. Use a test meter to locate an ignition on source for the Interior Network Module with +12 volts when ignition key is both on and cranking. 2. Connect the black wire to a solid chassis ground using the provided ring terminal and silver selftapping screw. 3. Radar receivers may be connected to either a +12 volt ignition on source or +12 volt constant battery source. GRAY GRAY SILVER SILVER BLOCK DIAGRAM CALIBRE BLACK GROUND #8 X 1/2" TEK *NOTE: THE RED WIRE SHOULD BE CONNECTED TO A MINIMUM 16 GAUGE +12 VOLT IGNITION WIRE. RED INTERIOR NETWORK MODULE IGNITION SWITCHED +12 VOLTS AMPLIFIED SPEAKER BROWN BLUE WHITE GRAY WHITE BLUE FRONT +12 VOLT BATTERY OR IGNITION SOURCE RECEIVER CABLE FUSE CONNECTION REAR FRONT RADAR LED REAR RADAR LED (CALIBRE DL model only) RECEIVER CABLE FUSE CONNECTION 1AMP WHITE YELLOW* BROWN* BLACK YELLOW* BROWN* BLUE 1AMP +12 VOLT BATTERY OR IGNITION SOURCE BLACK COPPER COPPER SILVER (NOT USED) CLEAR ZIP CORD GROUND #8 X 1/2" TEK COPPER COPPER SILVER (NOT USED) GROUND #8 X 1/2" TEK BLACK ZIP CORD CLEAR ZIP CORD BLACK ZIP CORD *THE YELLOW AND BROWN RADAR RECEIVER WIRES ARE USED TO CONNECT TO THE OPTIONAL LASER DEFUSER. IF NO LASER DEFUSER IS BEING INSTALLED WITH THE RADAR RECEIVER (FRONT AND/OR REAR), THE YELLOW AND BROWN WIRES WILL NOT BE USED. FRONT LASER DEFUSER (OPTIONAL) REAR LASER DEFUSER (OPTIONAL) IGNITION AND GROUND 1. Use a test meter to locate an ignition on source for the Interior Network Module with +12 volts when ignition key is both on and cranking. 2. Connect the black wire to a solid chassis ground using the provided ring terminal and silver selftapping screw. 3. Radar receivers may be connected to either a +12 volt ignition on source or +12 volt constant battery source. 44586-1 4/06 GRAY GRAY SILVER SILVER ...