User manual CAMBRIDGE SOUNDWORKS CONTROL CLOCK 88

An Overview of the Control Clock 88 "ALM ONE" - indicates alarm 1 is on "TONE RADIO" - indicates which type of alarm will activate; tone, radio or both "ALM TWO" - indicates alarm 2 is on Colon flashes every second "AM" or "PM" - indicates morning or evening "BATT" - indicates battery needs replacing Directional infrared control emitter "v" "w" - alarm time set controls "T" - activates "Tone" wake-up "T" - activates "Tone" wake-up T R "R" - activates "Radio" wake-up Turns alarm one or two "on" or "off" T R ALARM TWO TIME ON OFF RADIO On Off "v" "w" - clock time set controls "SET" - press and hold for time set "v VOLw" and "AM FM PRESET" buttons - control Model 88 radio functions "SLP DLY" - hold down to activate sleep delay turn off period ALARM ONE ON OFF ON OFF SET SLP DLY VOL AM FM PRESET "SNOOZE" - pressing once delays tone or radio wake-up SNOOZE CONTROL CLOCK 88 Thank you for purchasing the Control Clock 88 by Henry Kloss. It adds "clock radio" functions to your Model 88. Place your Model 88 anywhere in the room. Your Control Clock 88 keeps all essential control functions close at hand. The Control Clock 88 offers the convenience of two separate alarms. Either may be set to tone wake-up, music wake-up, or both. See next page for alarm setting instructions. Please read this operation manual to receive maximum benefit from your Control Clock 88. Save this manual for future reference. Setting up Installing a 9-volt battery maintains accurate time in case of a power outage. Install it in the bottom of the unit (see Figure 1). An alkaline battery is recommended. During a power outage, the display will not light up. If the Control Clock 88 "TONE" alarm was on when the power was interrupted, it will still function. The "RADIO" wake-up will not work during a power outage. The battery maintains time and alarm settings for approximately 48 hours. Remove the battery if the unit is unplugged for more than an hour or so. The low battery indicator (see Figure 2) will light if the battery needs replacement or power is interrupted. After battery replacement or when power is restored, this indicator may take 15 minutes to disappear. This is normal. Verify time and alarm settings after battery replacement. IMPORTANT: Remove battery when unit is not connected to AC Power for more than an hour. Placement The Control Clock 88 tone alarm is most effective when the unit is placed on a hard, flat surface. If the unit is placed on a soft cloth surface, the tone output level may be reduced. Battery Compartment Plug the Control Clock 88 into an unswitched AC outlet. Place the Control Clock 88 in a convenient location. Place your Model 88 in its best sounding location. You may wish to adjust the Model 88's subwoofer control for optimum bass output. Test the remote control functions of the Control Clock 88 to verify proper operation. Adjust the Control Clock 88's directional emitter as necessary to establish control of the Model 88 (see Figure 4). MANUFACTURED UNDER LICENSE FOR CAMBRIDGE SOUNDWORKS, INC. 311 NEEDHAM ST., NEWTON, MASSACHUSETTS 02464 USA THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE CONDITION THAT THIS DEVICE DOES NOT CAUSE HARMFUL INTERFERENCE. DO NOT EXPOSE TO RAIN OR MOISTURE. CONTROL CLOCK 88 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Opening for alarm tone ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR MADE IN CHINA 117VAC 50/60Hz 1 Amp Figure 1 Front display "ALM ONE" "TONE RADIO" "ALM TWO" CLOCK DISPLAY Indicates alarm 1 is on. Indicates which wake-up will activate; tone, radio or both. Indicates alarm 2 is on. Shows the current time. When either alarm's "on" button (see Figure 3, F) is pressed, it shows the alarm time, which remains displayed for about 5 seconds after release of the button. Indicates battery needs replacing. After replacement, this display may take up to 15 minutes to disappear. This is normal. Wakeup Operation · The Control Clock 88 stores two separate wake up times (ALARM ONE and ALARM TWO). · Each Control Clock 88 alarm can activate the clock's internal alarm (TONE), turn on the Model 88 (RADIO), or both. These instructions apply to either alarm. · To wake to the radio, be sure the Model 88 is off, and was last tuned to a radio station and left at an adequate volume. · The wake up time for either ALARM ONE or ALARM TWO can be adjusted to an earlier or later time by pressing the "v" and "w" buttons (C). This adjustment can be made at any time. "BATT" To set clock Hold down "SET" (G) button to activate time setting. Use the "TIME" buttons, "v" or "w" (H), to change the current time setting. When setting time, the display moves forward or back slowly for the first 5 digits, then proceeds rapidly. If you pass the desired setting, simply reverse direction to set desired time. The "v" and "w" buttons are not active unless "SET" (G) is held down. Activating ALARM ONE or ALARM TWO to "Wake To Radio" and "Wake To Tone" Press the "ON" button (F). The "TONE" and "RADIO" displays begin blinking. While the display blinks, select either "T" (tone), "R" (radio), or both. Pressing either "T" or "R" again will turn off that choice. "ALM ONE," "ALM TWO," "TONE," or "RADIO" will illuminate on the display. The Control Clock 88 is now set to wake you as desired. The display will revert to the current time approximately 5 seconds after the last button is pressed. To check either alarm's "Wake To" time, press the "On" button (F). The time will be displayed for 5 seconds. Turning off the alarms Low Battery Indicator After the "Wake To Radio" feature has turned on the Model 88 radio, you may turn off the radio with the "OFF" button (J). The radio may also be turned off with its faceplate "OFF" button or remote control's power button "·". Control Clock 88's "Wake To Radio" feature remains active and will turn on the radio 24 hours later. After the Control Clock 88 wakes you by sounding its internal TONE alarm, defeat the tone by pressing the "OFF" button (F) on the Control Clock 88. This "OFF" button (F) may also be used to deactivate either "Wake To Radio" or "Wake To Tone" settings. "Wake To Radio" or "Wake To Tone" must be reactivated every time the "OFF" button (F) is pressed. Figure 2 Top controls A B Infrared control emitter. Directional infrared control emitter. This emitter rotates 350° (see Figure 4). Place your Model 88 radio in its best sounding location. Test the operation of the radio controls of the Control Clock 88. Adjust the emitter if needed. "v" or "w" - alarm one or two time set controls. T R F G H Turns on tone for alarm one or two. Turns on Model 88 radio for alarm one or two. Turns alarm one or two "on" or "off" . "SET" - activates time set. "v" or "w" - set desired time. L Radio controls I J K "ON" "OFF" "vVOLw" - press left side of button to raise volume. Press right side to lower volume. "AM FM PRESET" - press left side of button to cycle through AM preset stations. Press right side of button to cycle through FM preset stations. C T C B T H A T T R ALARM TWO ON OFF TIME SET SLP DLY ON OFF RADIO VOL AM FM PRESET M "SLP DLY" - Press and hold to activate sleep delay turn-off period for Model 88 radio (in 10 minute increments up to 60 minutes). Display will show "d10" up to "d60" depending on length of time , button is held. I J N C R R F ALARM ONE ON OFF "SNOOZE" - pressing once will defeat tone or radio sound for a nine minute period. This is repeatable until the alarm is shut off. Adjust for best radio control (see Placement) K L SNOOZE N CONTROL CLOCK 88 M G Figure 3 Figure 4 Important Safety Information 1. Read Instructions. All the safety information and operating instructions should be read before the product is operated. 2. Retain Instructions. The safety information and operating instructions should be kept for future reference. 3. Observe Warnings. All warnings, either on the product or in the operating guide should be followed. 4. Follow Instructions. Operate the product in accordance with the written instructions. 5. Cleaning. Unplug this product from a wall outlet before cleaning. Do not use liquid or spray cleaners. Use a cloth moistened with water for cleaning. 6. Water and Moisture. Do not use this product near water ­ for example, near a bathtub, wash basin or sink, or washing machine; in an area subject to water leakage, like a basement; near a swimming pool or other similar areas. 7. Accessories. Do not place this product on an unstable surface of any kind. The product may fall causing serious injury to a child or adult. Falls may also damage the product. Any mounting of the product should be secure and not subject to failure when struck or vibrated. Always transport the product alone. Do not transport the product within or on top of a rolling carrier. 8. Power Sources. This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your local power company. 9. Grounding or Polarization. This product is equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. 10. Power-Cord Protection. Power-cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the security of a power-cord near where it meets a plug, convenience receptacles, and the point where the power-cord exits the product. 11. Periods Of Inactivity. The power-cord of the product should be unplugged from an outlet when left unused for a long period of time. 12. Lightning. For added protection of this product during a lightning storm, or when it is to be left unattended and unused for a long period of time, unplug it from the wall outlet. 13. Overloading. Do not overload wall outlets, extension cords, or integral convenience outlets, as this can result in a risk of fire or electric shock. 14. Object and Liquid Entry. Never push objects of any kind into this product through openings, as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. 15. Servicing. Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 16. Damage Requiring Service. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: · The power-cord or the plug has been damaged; or · Objects have fallen onto, or liquid has been spilled into the product; or · The product has been exposed to rain or water; or · The product does not operate normally when following the operating instructions. Do not attempt to open the product to adjust any internal parts; or · The product has been dropped or damaged in any way; or · The product presents a noticeable and obvious change in performance ­ this indicates a need for service. 17. Replacement Parts. Do not allow anyone, including qualified service technicians, to use replacement parts other than those recommended by the manufacturer. Unauthorized substitutions may result in fire, electric shock or other hazards. 18. Safety Check. Upon completion of any service or repair to this product, ask the service technician to perform safety checks to determine whether the product is in proper operating condition. 19. Heat. The product should be positioned away from heat sources such as radiators, stoves, or other products that produce heat. Note: Do not change or modify this device in any manner. Any changes or modifications could void the owner's authority to operate this device. WARNING SHOCK HAZARD DO NOT OPEN 1-Year Limited Warranty To the original purchaser, Cambridge SoundWorks, Inc. will warrant the Control Clock 88 to be free from defects in material and workmanship for a period of one (1) year from date of purchase. With respect to defects, Cambridge SoundWorks will, at its option, replace the product or repair the defect in the product with no charge to the original purchaser for parts or labor. This warranty does not extend to any defect, malfunction or failure caused by misuse, abuse, accident, faulty hookup, defective associated equipment or use of the Control Clock 88 with equipment for which it is not intended. This warranty is valid only when the Control Clock 88 is returned to Cambridge SoundWorks. Call for a Return Authorization Number for the unit and return it to the accompanying address, freight prepaid, together with a copy of the original sales slip to establish warranty status. Please do not return the Control Clock 88, or any of its parts, to Cambridge SoundWorks without prior authorization. This is the sole and expressed warranty. This warranty is in lieu of all other warranties, expressed or implied, of merchantability, fitness for purpose or otherwise. In no event shall Cambridge SoundWorks be liable for incidental or consequential damages or have any liability with respect to defects other than the obligations set forth above. To ensure warranty coverage it is incumbent upon the original purchaser to inform Cambridge SoundWorks or any of its Authorized Service Agencies of the defect within the warranty period. The only acceptable method of establishing warranty status is a copy of the original proof of purchase indicating customers name and purchase date. For warranty information contact: AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: To prevent electric shock, match wide blade of plug to wide slot. Insert fully. ATTENTION: Poer eviter les chocs electriques, introduire la lame la plus large de la fiche dans la borne correspondante dede la prise et pousser jusqu'au fond. Batteries Please dispose of used batteries properly, following any local regulations. Do not incinerate. 311 Needham Street, Newton MA 02464 1-877-937-4434 Fax: 617-527-3194 www.cambridgesoundworks.com Email: info@cambridgesoundworks.com P81-1310 0400 A Company