C ongratulations on your purchase of this Ungo Convenience System. Please read this manual thoroughly to familiarize yourself with your system's components and operation. Discuss any questions you might have with your installing dealer. Record the serial number of your Ungo system and keep all dealer records and receipts. Be sure to discuss the installation with the dealer so that you understand the specifics of the installation in your vehicle. CAUTIONS · USE IF THE UNGO CS150 IS THE RESPONSIBILITY OF THE OWNER. · KEEP THE REMOTE TRANSMITTERS OUT OF THE REACH OF CHILDREN. · THE UNGO CS150 IS NOT INTENDED FOR USE ON VEHICLES EQUIPPED WITH A MANUAL TRANSMISSION. · BE SURE THE TRANSMISSION IS IN PARK BEFORE LEAVING THE VEHICLE. · TURN THE ON/OFF SWITCH TO "OFF" WHEN THE VEHICLE IS BEING SERVICED OR PARKED IN A GARAGE. · ONLY REMOTE START THE VEHICLE IN A WELL VENTILATED AREA. Table of Contents 1. 2. About Your System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 1 Remote Transmitters Remote Transmitter Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2 Adding a New Transmitter into the System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2 Deleting Transmitters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2 Battery Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2 Additional Remote Transmitters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 3 3. Basic Features Remote Starting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 3 Shut Down . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 3 Valet Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 4 Stop and Go . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 4 Auto Cold Starting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 4 4. Optional Features Remote Keyless Entry . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 5 Auxiliary Function Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 5 5. 6. 7. Reference Chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 6 Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 6 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 7 Note: Certain features described in this manual may require additional parts and/or labor. Also, some features of the Ungo CS150 convenience system have selectable options that must be activated or programmed during the system's installation. These items will be identified in the following sections. Your Authorized Ungo Dealer will be happy to discuss these features with you and help you design your system to meet your needs. About Your Ungo Convenience System The Ungo CS150 is a remote controlled car start system. When activated, the CS150 will safely start your car by remote control, without your key in the ignition. If your vehicle is powered by a diesel engine, the CS150 will turn on the ignition for 20 seconds prior to starting the engine, in order for the glow plugs to warm up. Once the CS150 has started the engine, it will turn on your preset accessories (heater/air conditioner) to provide you with the maximum comfort when you enter your vehicle. After activation, the CS150 will allow the vehicle to run for approximately 12 minutes (or 24 minutes if selected by your installer at the time of installation) before automatically shutting off. Ungo CS150 System comes with: · Main Unit - The "brain" of the system. · 2 - Three Button Remote Transmitters · Extended Range Receiver - Specifically designed to maximize the operating range of the Remote transmitters. · Status LED - Red illuminated indicator that provides system status information. · Valet / Service Mode Switch - used to disable the remote starting system in case the vehicle is to be serviced. Optional keyless entry features will still function. Safety To provide you with the maximum safety and reliability, the CS150 incorporates the following safety features: · Brake Pedal Shutdown - Shuts down the CS150 when the brake pedal is pressed. · Hood Pin Switch Protection (optional) - Prevents the engine from being started while the hood is open. · Valet Mode - Prevents the vehicle from being started when being serviced. Options The CS150 Remote Start system also has the capability of controlling the following optional convenience features: · Remote Keyless Entry (Door Lock/Unlock) · Remote Trunk Release · Window Roll-up CS150 Owner's Manual - Page 1 Remote Transmitters Remote Transmitter Layout Button 1 Button 3 LED Button 2 The Ungo CS150 comes with 2 Remote Transmitters used to control the system's features. Each time a transmitter button is pressed, the LED will flash to indicate that a transmission is taking place. Button 1 Locks and Unlocks the doors*. Button 2 activates the system's auxiliary function (usually used for optional trunk release)*. Button 3 is used to Remote Start the vehicle. It is also used to shutdown the engine if remote started. *optional features Adding or Deleting Remote Transmitters The Ungo CS150 has the ability to recognize 2 individual remote transmitters. If the vehicle is used by multiple drivers, each can have their own Remote Transmitter. To add a Remote Transmitter: 1. Turn the ignition on, off, on, off, on within 4 seconds. · The status LED and parking lights will flash once. 2. Press and hold the Valet switch for 2-3 seconds. · The status LED and parking lights will flash 3 times. 3. Release the program switch. 4. Press Button 3* on each Remote Transmitter. 5. Turn off the ignition. *Be sure that you press only Button 3. Pressing any other transmitter button will cause the unit to recognize the individual transmitter buttons incorrectly. Note: The CS150 will respond to only those remote transmitters learned during this procedure. Any previous remotes will be deleted. Battery Replacement Your Ungo Remote Transmitter uses a 12 volt alkaline battery, which will need to be replaced from time to time. Under normal conditions, the battery should last for up to a year before it needs replacement. Page 2 - CS150 Owner's Manual When your Remote Transmitter's battery is in need of replacement, you will notice a decrease in your system's operating range or a decrease in the brightness of the Transmitter's LED indicator. To change the battery, remove the 2 screws at the back of the Transmitter and carefully separate the top and bottom halves of the Transmitter case. Insert the new battery, making sure that the positive and negative terminals are positioned correctly and replace the cover. Battery Type: 23A Additional Remote Transmitters Additional Remote Transmitters for your CS150 are available from your Authorized Ungo dealer. Basic Features Remote Starting To Remote Start the System: 1. Be sure the System is not in Valet Mode. 2. Press Button 1. · · · · The parking lights will turn on. The LED will flash rapidly. The engine will start and run for the duration of its programmed Run Timer.* The heater or air conditioner will turn on (if turned on prior to exiting the vehicle). Turning on the ignition key then pressing the brake pedal will disengage the CS150 and allow you to operate and drive your vehicle in a normal manner. *If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times. If the vehicle fails to start after a total of 3 times the parking lights will flash 4 times and the doors will lock (if installed). Shut Down The following will shut down the engine when it is under Remote Start control: 1. Pressing Button 1. · After the engine shuts down the doors will lock (if installed). 2. Pressing the Brake Pedal. 3. Opening the Hood. 4. Remote Start Time-Out (completion of the timed run cycle). CS150 Owner's Manual - Page 3 Valet Mode Allows you to temporarily disable the remote starting feature when the car is being serviced or turned over to a parking attendant. To turn Valet Mode on: 1. Turn on the ignition. 2. Within 5 seconds, press and hold the Valet button for 3 seconds. · The LED will turn on solid. · The parking lights will flash once. To turn Valet Mode off: 1. Turn on the ignition. 2. Within 5 seconds, press and hold the Valet button for 3 seconds. · The LED will turn off. · The parking lights will flash twice. While Valet Mode is on, you can continue to lock and unlock the doors with the Remote Transmitters, as well as operate the optional Auxiliary Function. Stop and Go The Stop and Go Feature allows you to remove the ignition key and exit the vehicle while keeping the engine running during short stops. To leave the vehicle running: 1. Press the Brake Pedal and hold. 2. While pressing the Brake Pedal, push Button 1 on the Remote Transmitter. · The LED will flash rapidly. · The parking lights will flash four times. 3. Release the Brake Pedal. 4. Remove the key from the ignition switch. 5. You may now exit the vehicle and lock the doors manually or using the Remote Transmitter To re-enter the vehicle and resume driver control: 1. Unlock the doors manually or by pressing Button 1 on the Remote Transmitter*. 2. Turn on the ignition. 3. Press the Brake Pedal to disengaged the CS150. · The LED will turn off. *If optional keyless entry feature is installed. Auto Cold Starting The Auto Cold Starting Feature allows the vehicle to automatically start the vehicle every two hours and run for the preset Run Time. To turn on Auto Cold Starting: 1. Press and hold Button 1 for 5 seconds. · The parking lights will flash 5 times. · The engine will start and run for 30 seconds. · The LED will emit double flashes. Page 4 - CS150 Owner's Manual CS150 Owner's Manual - Page 4 To turn off Auto Cold Starting: 1. Press and hold Button 1 for 5 seconds. · The parking lights will flash 10 times. · The LED will stop flashing. Note: Pressing the brake pedal will also turn off the Auto Cold Starting feature. Optional Features Remote Keyless Entry To Lock and Unlock the doors: 1. Press Button 1 on the Remote Transmitter. · The parking lights will flash once. · The doors will lock. · The LED will begin flashing slowly*. 2. Press Button 1 again on the Remote Transmitter. · The parking lights will flash twice. · The doors will unlock. · The LED will stop flashing*. *If the Auto Cold Starting feature is activated, the LED will emit double flashes. Auxiliary Function Output The system is equipped with an Auxiliary Function output that can be used to remotely control an optional feature such as, electric trunk release, remote car starter, power windows, power sunroof, garage door receiver, etc. To operate the Auxiliary Function, press and hold Button 3 for two seconds. · This function will operate regardless of whether the system is locked or unlocked. Reference Chart You can use this chart to quickly identify and interpret the CS150's parking light and LED indications. Status LED Indications Flashes Slow Rapid Double Solid Flashes 1 2 4 5 10 Functions Doors are locked (optional) Remote Started/Running Valet mode Auto Cold Starting engaged Parking Light Indications Functions Doors are locked (optional) Doors are unlocked (optional) Unable to Remote Start vehicle Auto Cold Starting engaged Auto Cold Starting disengaged CS150 Owner's Manual - Page 5 Technical Data Specifications Main Unit Voltage: 12v, negative ground Current Consumption: <15mA Temperature Range: -40oF to +257oF -40oC to +125oC Auxiliary Output Capability: 500mA Internal Relays: (4) 30A, (1) 15A Transmitter Current Consumption: <.00mA, standby Battery Type: miniature 12v, type 23A FCC ID: J5523518 T1 J5523518 R1 THIS DEVICE COMPLIES WITH FCC RULES PART 15. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE THAT MAY BE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Ungo Security Corporation Gardena, CA USA Warranty Information Model No.: CS150 Serial No.: Dealer Name: Address: Purchase Date: Page 6 - CS150 Owner's Manual Warranty Information 1. Ungo Security Corporation of Gardena, California ("Ungo Security") wa ...