MODEL NO. KCR2610 UNDERCOUNTER LCD TV CLOCK RADIO OWNER'S MANUAL PLEASE READ BEFORE OPERATING THIS EQUIPEMNT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. ATTENTION The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. DANGER: Invisible and hazardous laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. LASER SAFETY: This unit employs a laser. Only qualified service personnel should attempt to service this device due to possible injury. CAUTION: USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. 1 PREPARATION FOR USE Unpacking and Setup · Carefully remove the unit from the display carton and remove all packing material from the unit itself. · The detachable AC power cord is packed in the carton separately from the unit. Make sure the AC power cord is not accidentally discarded with the carton or packing material. · Press the CD Door OPEN/CLOSE area to open the CD compartment door. There is a white card in the CD compartment which is intended to prevent the CD pickup from moving during shipment of the product. Remove this card from the CD compartment before use. Power Sources This portable audio system is designed to operate on AC 120V~60Hz or by using eight (8) "C" batteries, (batteries not included). Attempting to operate this unit from any other power source may cause damage to the unit, which is not covered by your warranty. AC Operation Unwind the AC cord and extend it to its full length. Insert the small end of the AC cord into the AC power socket on the rear of the unit. Insert the other end of the AC cord into any convenient AC 120V~60Hz household outlet. Battery Installation To use this unit with battery power, remove the battery compartment on the bottom of the unit by sliding it towards the rear of the unit and lifting the battery door off. Insert eight (8) "C" size batteries (batteries not included) following the diagram in the compartment. NOTE: The power cord must be disconnected from the AC power socket on the rear of the unit in order for the unit to operate on battery power. 2 LOCATION OF CONTROLS 5 7 8 16 12 11 1 4 14 13 6 10 9 15 2 3 1. 2. 3. 4. 5. 6. 7. 8. TIMER BUTTON MEM DN BUTTON MEM UP BUTTON TUNER/CLK BUTTON MOUNTING BRACKET FUNCTION BUTTON CH. UP BUTTON VOLUME BUTTON 9. MENU BUTTON 10. ITEM BUTTON 11. CH. DN BUTTON 12. EQ BUTTON 13. BAND BUTTON 14. SLEEP BUTTON 15. MEM/CLK SET BUTTON 16. POWER BUTTON 3 LOCATION OF CONTROLS 1 2 3 4 5 15 14 13 12 11 10 6 7 8 9 1. 2. 3. 4. 5. 6. 7. 8. MEM. CH. UP/DN BUTTON FUNCTION BUTTON NUMBERDIAL BUTTONS DISPLAY BUTTON ITEM/ENTER BUTTON TIMER BUTTON MEM/CLK SET BUTTON TUNE/CH BUTTON 9. MENU BUTTON 10. TFT ON/OFF BUTTON 11. BAND BUTTON 12. EQ BUTTON 13. VOLUME BUTTON 14. MUTE BUTTON 15. POWER BUTTON 4 POWER SOURCES NOTE: Battery is for time backup only. The clock and alarm memory will be retained during a power interruption. During battery backup operation, the display will not light up, but the correct time will be maintained internally. BATTERIES NOTE: The button cell battery contains mercury, don't put in the trash. Recycle or dispose as hazardous waste. NOTE: You may need to remove a protective covering from the remote's battery compartment before using the remove. 5 POWER SOURCES DC ADAPTOR(NOT INCLUDED) OPERATING INSTRUCTIONS 1. SETTING THE TIME (POWER OFF MODE) 2. LISTENING TO THE RADIO 6 OPERATING INSTRUCTIONS PROGRAM RADIO STATIONS 3. TELEVISION OPERATION 7 OPERATING INSTRUCTIONS 4. SET UP 8 OPERATING INSTRUCTIONS 9 OPERATING INSTRUCTIONS AUTO SCAN 10 OPERATING INSTRUCTIONS 5. LISTENING TO AN AUXILIARY SOURCE FROM VIDEO OUTPUT FROM RIGHT AUDIO OUTPUT FROM LEFT AUDIO OUTPUT TV, VCR, STEREO, VIDEO GAME SYSTEM, ETC. 6. SETTING KITCHEN TIMER 7. EQ REPEATEDLY 11 CARE AND MAINTENANCE GENERAL * Use a soft, clean cloth moistened with plain, luke-warm wafer to clean the exterior of the unit. * Never use solvents such as benzene or other strong chemical cleaners since these could damage the unit's finish. * It is important that no liquid reaches the inside of the unit. 12 TROUBLESHOOTING GUIDE PROBLEM No sound is heard. POSSIBLE CAUSE GENERAL Power is not on. VOLUME Control is set to minimum. Mute is on. RADIO Station has not been tuned properly. FM reception is weak. Wrong function is selected. Press the POWER button. Adjust the VOLUME Control. Press Mute on remote. Tune station properly . Extend the FM cord. Press the FUNCTION button to the radio position. SOLUTION No sound is heard. Snowy picture; noisy sound. TV Station has not been tuned properly. Align the antenna or connect an external antenna. Dotted lines or stripes. This may be caused by local interference (e.g. Cars, neon signs, hair dryers, etc.) This may be caused by reflections from nearby mountains or buildings. VOLUME control is set to minimum. This may be caused by reflections from nearby mountains or buildings. This may be caused by reflections from nearby mountains or buildings. Power is not on. Adjust the antenna for minimum interference or connect an optional external antenna. A highly directional antenna may improve the picture. Adjust the volume. Double images or "ghosts". Good picture; no sound. Good picture; noisy sound. A highly directional antenna may improve the picture. A highly directional antenna may improve the picture. Set the FUNCTION Switch to the TV position. Good picture; no sound. No picture 13