User manual CURTIS SR748

STEREO MICRO HI-FI SYSTEM MODEL NO.: SR-748 INSTRUCTION MANUAL MAIN UNIT SPEAKER & SUBWOOFER UK - 1 UK - 2 To achieve the utmost in enjoyment and performance, please read this manual carefully before attempting to operate the unit in order to became familiar with its features, and assure you years of faithful, trouble free performance and listening pleasure. Important Notes * * Keep instructions the safety and operating instructions should be retained for future reference. Avoid installing the unit in locations described below: Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters. On top of other stereo equipment that radiate too much heat. Places locking ventilation or dusty places. Places subject to constant vibration. Humid or moist places. Make sure not to obstruct the ventilation opening. Operate turning controls and switches as instructed in the manual. Before turning on the power for the first time, make certain the power cord is properly installed. Store your tapes or CD in a cool area to avoid damage from heat. * * * For safety reasons, do not remove any covers or attempt to gain access to the inside of the product. Refer any servicing to qualified personnel. Do not attempt to remove any screws, or open the casing of the unit; there are no user serviceable parts inside, refer all servicing to qualified service personnel. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER(OR BACK), NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE Conductor dangerous voltage, that may be of sufficient magnitude to constitute a risk of electric shock to persons is present within this product's enclosure. ATTENTION The owner's manual contains important operating and maintenance instructions, for your safety, it is necessary to refer to the manual. WARNING : TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO DRIPPING OR SPLASHING. Note: This unit will become warm when used for a long period of time. This is normal and does not indicate a problem with the unit. This CD player includes micro-processors which may malfunction as a result of external electrical interference or noise. If the CD player is not working properly, disconnect the power source and then reconnect it. UK - 3 FEATURES AND CONTROLS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. SKIP / SEARCH UP BUTTON SKIP / SEARCH DOWN BUTTON PLAY / PAUSE BUTTON STOP BUTTON REPEAT BUTTON PROGRAM BUTTON PHONES JACK BUTTON LCD DISPLAY WINDOW POWER BUTTON MUTE BUTTON IR SENSOR TUNING KNOB CD DOOR AM / FM / FM.ST SWITCH CD / RADIO SWITCH VOLUME UP / DOWN BUTTON CD DOOR OPEN BUTTON 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. X-BASS ON / OFF SWITCH SPEAKER TERMINALS FM ANTENNA SUBWOOFER LINE-OUT AC POWER MAIN SWITCH 110V / 220V DUAL VOLTAGE (OPTIONAL) AC CORD SPEAKER SUBWOOFER VOLUME UP / DOWN BUTTON SUBWOOFER POWER ON / OFF BUTTON SUBWOOFER LINE-OUT JACK DUAL VOLTAGE SWITCH SUBWOOFER POWER STANDBY INDICATOR REMOTE CONTROL 1. 2. 3. 4. 5. 6. 7. 8. 9. POWER BUTTON PLAY / PAUSE BUTTON STOP BUTTON SKIP / SEARCH DOWN / UP BUTTON REPEAT BUTTON RANDOM BUTTON MUTE BUTTON VOLUME DOWN / UP BUTTON BATTERY DOOR Press down of the compartment cover, and slide the cover off open the compartment. Place the two ( UM3 ), ( AA ), (R6 ) batteries in the remote control according to the polarity markings ("+" and "--') inside the compartment and on the batteries. Place the cover over the compartment, press down lightly, and push it upward until it snaps on. NOTE : Replace all batteries at the same time. Remove the batteries the remote control is not in use for long periods, don't mix normal batteries with rechargeable batteries, when the batteries become weak, remote control will be not functioned, replace with new batteries if above happened. UK - 4 PUTTING THE BATTERIES INTO THE REMOTE CONTROL UNIT ** BATTERIES NOT INCLUDED ** INSTALLING THE SPEAKER WIRE TO THE SPEAKER TERMINALS 1. 2. Speakers Connection Extend the SPEAKER WIRES and connect them to the SPEAKER TERMINALS. Power Cord Connection Before using, connect the AC Power Cord to the AC outlet, then turn on the main switch of the unit. INSTALLING THE SUBWOOFER WIRE TO THE SBB LINE IN TERMINALS 1. Subwoofer Connection Extend the SUBWOODFER WIRE and connect it to the SBB LINE IN TERMINAL. 2. Power Cord Connection Before using, connect the AC Power Cord to the AC outlet, then turn on the main switch of the SUBWOOFER. OPERATING THE UNIT When you first plug the unit into the AC outlet, the unit will be in standby mode.You can press the POWER button on the unit (or on the remote control) to switch the unit ON and OFF. Pull the AC plug out of the wall socket if you want to switch off completely. ADJUSTING THE SOUND Press the volume +/- buttons to set the sound level. For increased bass at all volume levels, switch the BASS SWITCH on to boost the low frequency sound. To mute the sound, press MUTE button and the "POWER" indicator will flash. To resume the sound, press the MUTE button again or just press the volume +/- button to disable the MUTE function. A stereo headphone jack is provided for private listening. To listen to the unit with headphones(not included)insert the 3.5mm mini-stereo plug from the headphones into the PHONES jack on the front panel. The external speakers are automatically disconnected when headphones are in use. LISTEN TO THE MUSIC BY USING HEADPHONE RADIO OPERATION Set the FUNCTION switch to RADIO. FM Select FM mode band selector switch. Turn the TUNING control to select the required station. The FM stereo indicator light will show a stereo broadcast is being received. Fully extend the FM antenna and adjust its direction for best FM reception. AM Select AM on band selector switch. Turn the TUNING control to select the required station. For operation on AM the set control a built-in ferrite aerial which is directional. Therefore, the set should be positioned for the best signal strength. FM STEREO RECEPTION For reception of a FM stereo broadcast station, set the AM / FM / FM ST. switch to FM ST. position. The " " will indicate on the LCD display when a FM STEREO broadcast is being received. FM ANTENNA FM antenna wire for better FM reception. UK - 5 LISTENING TO COMPACT DISC (CD) The LCD indicator always shown the tracks of a disc or program which are still to be played. It works in all modes, in stop mode, all tracks of the disc or the program are shown. Playing The Entire Disc 1. Playback will start by pressing PLAY/PAUSE, the " " indicator then appears. Playback starts with the first track.The display shown the current track number and its elapsed time. 2. To interrupt playback, press PLAY/PAUSE. The " " indicator will flash. 3. To resume playback, press PLAY/PAUSE again. 4. To stop playback, press STOP. Selection A Different Track During Play 1. Press SKIP/SEARCH button on the unit (or remote), the required track number appears in the display. 2. Press PLAY/PAUSE button to starting playing. Starting again with the track that is currently playing. Starting Again With The Track That Is Currently Playing 1. Press SKIP F.R. once. 2. The track will be started again from the beginning. Stopping Play 1. Press STOP if you wish to stop play. The disc and track number which can be played will now appear in the display. 2. Open the CD door on the unit to remove the CD. 5. 6. 7. Up to 20 tunes can be programmed for listening and played. 1. Press the PROG button.(F.1) 2. Select the desired track number using the SKIP/SEARCH button on the unit (or remote).(F.2) 3. Press the PROG button to memories the track selection. 4. Repeat steps 1 and 3 as to memories up to 20 tracks. To stop playing, press the STOP button. Opening the door clears all programmes. PROGRAMMED PLAYBACK (F.1) Press PLAY / PAUSE button, to play starts with the first track of the program. (F.2) RANDOM PLAY (for Remote Handset) 1. 2. 3. Press the RANDOM button once, and the "RANDOM" indicator will light up. Press the PLAY / PAUSE button to start playing. The tracks will be played randomly. To cancel random play, either press the STOP button twice or press the RANDOM button once again, until the "RANDOM" indicator disappeared. REPEAT PLAY 1. 2. 3. When playing CD, If repeat the same track only, press the REPEAT button once and the "REPEAT" indicator will light up and flash. If you desire to repeat all, press REPEAT button twice and the "REPEAT" indicator will light up and not flash. To cancel repeat play, press the STOP button twice until the repeat indicator disappeared. UK - 6 COMPACT DISC 1. Always use a compact discs bearing the mark as shown. 2. Notes on handling discs Removing the disc from its storage case and loading it. * Do not touch the reflective recorded surface. * Do not stick paper or write anything on the surface. * Do not bend the disc. 3. Storage * Store the disc in its case. * Do not expose discs to direct sunlight or high temperatures, high humidity or dusty places. Cleaning a disc * Should the disc become soiled, wipe off dust, dirt and fingerprints with a soft cloth. * The disc should be cleaned from the center to the edge. FROM THE CENTRE TO THE EDGE 4. CORRECT INCORRECT * * * Never use benzene, thinners, record cleaner fluid or anti static spray. Be sure to close the CD door so the lens is not contaminated by dust. Do not touch the lens. UK - 7 CD DISPLAY WINDOW A. B. C. D. E. F. STEREO INDICATOR PROGRAM INDICATOR RANDOM INDICATOR REPEAT INDICATOR TRACK NUMBER INDICATOR PLAY INDICATOR SPECIFICATION POWER SUPPLY : SUBWOOFER : OUTPUT POWER : UNIT DIMENSION : SPEAKER BOX DIMENSION : N. W.: RADIO SECTION FREQUENCY RANGE : COMPACT DISC SECTION OPTICAL PICKUP : FREQUENCY RESPONSE : AC 120V~ 60Hz 20WRMS 4.5 WATTS x 2 135 (L) x 253 (W) x149 (H) mm 90 (L) x 225 (W) x 190 (H) mm 4.2 kg FM 87.5 - 108 MHz AM 530 - 1710 kHz 3 - BEAM LASER 100Hz - 16kHz SPECIFICATION SUBJECT TO CHANGE WITHOUT FURTHER NOTICE. D ri p p in g w a r ni n g : " The product shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the product." Ventilation war ning : " The normal ventilation of the product shall not be impeded for intended use." UK - 8