INTRODUCTION The RGC-1 remote gain control is specifically designed for use with ORION amplifiers. The RGC-1 allows dashboard control to your current Orion amplifier or earlier XTR, XTR Pro or HCCA amplifier. Used on subwoofer amplifiers, it provides subwoofer level control. Used on the first amplifier in a daisy-chain, it works as a remote pre-amp volume control. Warning: The RGC-1 can be used only on ORION amplifiers that have a 1/8-inch mini-jack remote gain port on the connection panel. Using the RGC-1 with other ORION products will damage the system. OPERATION The RCG-1 is shipped in its retracted position. To adjust the control, press and release the knob. The knob will extend for adjustment. Clockwise rotation of the control knob increases the gain of the amplifier. Counterclockwise rotation reduces the gain. See the "Adjustment" section for information on how to set the various level controls in the system to get the proper range of operation for the RGC-1. The control knob can be pushed in to its retracted position after adjustment. WIRING Connect the RGC-1 to the ORION amplifier connector with the attached 1/8-inch mini-plug cable. If your system requires a longer cable, a standard head phone extension cable can be used. The RGC-1 has optional night-time illumination provided by the GREEN and RED wires. For Red color illumination, connect the RED wire to a +12 Vdc source and the GREEN wire to chassis ground. For Green color illumination, connect the GREEN wire to a +12 Vdc source and the RED wire to chassis ground. INSTALLATION Under Dash Mounting To mount the RGC-1 under the dash or in an area that cannot be drilled through to accommodate the control, use the supplied under dash mounting bracket. Find a suitable location which will not interfere with driving that is easy to reach. Mount the bracket in place using the 2 screws and secure the RGC-1 to the bracket as shown below. ©2004 Directed Electronics, Inc. 1 AC502 Nut Under Dash Mounting Bracket Label Nut Knob Screws In-Dash Mounting Note: There must be enough clearance behind the dash-panel before selecting the location to mount the RGC-1. A 1/2-inch hole must be drilled to mount the RGC-1 in the dash panel. Side in the control from the rear of the dash panel and place the trim label on the threaded shaft. Secure the control with the nut and mount the knob If there is no access to the back of the dash panel, drill a 3/4-inch hole in order to pass the entire RGC-1 through the hole from the front of the dash panel. Once the control is through the hole, the clip shown below is passed through the hole and slid around the threaded shaft of the control. Place the trim label on the threaded shaft and secure the control with the nut and mount the knob. AC502 Front Mount Nut Clip Dashboard Trim Panel Label Nut Knob AC502 Nut Dashboard Label Nut Rear Mount Knob 2 ©2004 Directed Electronics, Inc. ADJUSTMENT PROCEDURE 1. Set the gain controls of the amplifier according to the "Adjusting the Sound of Your System" in your owner's manual. The amplifier primary gain controls determine the maximum allowed output level that the amplifier. 2. Set the control knob of the RGC-1 to its mid-rotation position. 3. Check the output level of the subwoofer. The amount of bass can be adjusted for the type of music and individual preference. Warning: DO NOT increase the amplifier gain without repeating Step 1. Failure to do so may damage your amplifier and speakers. This will void your warranty. ©2004 Directed Electronics, Inc. 3 Warranty LIMITED TWO YEAR CONSUMER WARRANTY: Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase by the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. During this two year period, there will be no charge for this replacement PROVIDED the unit is returned to Directed, shipping pre-paid. If the unit is installed by anyone other than an authorized Directed dealer, the warranty period will be 1 year from date of purchase by the dealer as indicated by the date code marking of the product. During this 1 year period, there will be no charge for this replacement PROVIDED the unit is returned to Directed, shipping pre-paid. This warranty is non-transferable and does not apply to any unit that has been modified or used in a manner contrary to its intended purpose, and does not cover damage to the unit caused by installation or removal of the unit. This warranty is void if the product has been damaged by accident or unreasonable use, neglect, improper service or other causes not arising out of defects in materials or construction. ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, AND WARRANTY OF NONINFRINGEMENT OF INTELLECTUAL PROPERTY ARE EXPRESSLY EXCLUDED TO THE MAXIMUM EXTENT ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT. DIRECTED HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING ITS AUTHORIZED DEALERS OR INSTALLERS. Unit must be returned to Directed, postage pre-paid, with: consumer's name, telephone number, and address, authorized dealer's name and address, and product description. IN ORDER FOR THIS WARRANTY TO BE VALID, YOUR UNIT MUST BE SHIPPED WITH PROOF OF INSTALLATION BY AN AUTHORIZED DIRECTED DEALER. ALL UNITS RECEIVED BY DIRECTED FOR WARRANTY REPAIR WITHOUT PROOF OF DIRECTED DEALER INSTALLATION WILL BE COVERED BY THE LIMITED 1 YEAR PARTS AND LABOR WARRANTY. Note: This warranty does not cover labor costs for the removal and reinstallation of the unit. BY PURCHASING THIS PRODUCT, THE CONSUMER AGREES AND CONSENTS THAT ALL DISPUTES BETWEEN THE CONSUMER AND DIRECTED SHALL BE RESOLVED IN ACCORDANCE WITH CALIFORNIA LAWS IN SAN DIEGO COUNTY, CALIFORNIA. © 2004 Directed Electronics, Inc. All rights reserved. G58000 04-04 ...