User manual DUAL XD5110

XD5110 INSTALLATION/OWNERS MANUAL AM/FM/CD Receiver XD5110 INSTALLATION Preparation Please read entire manual before installation. Before You Start · Disconnect negative battery terminal. (consult a qualified technician for instructions) · Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started · Remove 2 transit screws located on top of the unit. · Remove trim ring by pulling up gently in the center. · Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve. · Install mounting sleeve into opening, bending tabs to secure. · Connect wiring harness and antenna. (consult a qualified technician if you are unsure) · Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately). · Test for correct operation and slide into mounting sleeve to secure. · Snap trim ring into place. 2 XD5110 INSTALLATION Installation TYPICAL MOUNTING METHOD 3 XD5110 INSTALLATION Antenna Connector Wiring Diagram RCA Cable (sold separately) GRAY Rear Preamp Output Connect to amplifier RCA Input BLUE Remote Turn-On Connect to amplifier or power antenna. Insulate wire if not used. AMP BLACK Ground Connect to vehicle chassis ground. 1 AMP AGC Fuse RED Accessory Connect to existing ignition circuit or switched 12 volt source. 5 AMP AGC Fuse FUSES Connect to battery circuit or constant 12 volt source. YELLOW Memory Right Front Gray/Black (-) Gray (+) Right Rear Violet/Black (-) Violet (+) Left Front White/Black (-) White (+) Left Rear Green/Black (-) Green (+) When replacing fuses, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XD5110 uses one 1 amp AGC fuse (Ignition) and one 5 amp AGC fuse (Battery) located in-line. * CAUTION - Do not attach any speaker leads to ground as severe damage will occur. 4 XD5110 OPERATION Control Locations 1 2 3 4 13 12 11 10 9 8 7 6 5 1 Power 2 Volume 3 Track Up/Down 4 Eject 5 Band 6 Display 7 Local/Distance/CD Repeat 8 Play/Pause 9 Bass Boost/CD Random 10 Mono/Stereo/CD Intro 11 Reset 12 Audio 13 Tuning 5 XD5110 OPERATION General Operation Power On/Off Press PWR to turn the unit on. Inserting a CD will turn the unit on automatically. Press PWR to turn the unit off. Insert a CD or press playback. CD Mode l / II to begin or resume Tuner Mode Press PWR or BAND to begin or resume tuner operation. Press BASS to activate and deactivate bass boost curve. Activating this feature will enhance the bass frequencies when listening to music at low volumes. Adjust volume using VOL or VOL (0-63). Press DISP to display the clock. The radio frequency (tuner mode) or CD track/elapsed time (CD player mode) show by default. Press and hold DISP until the clock begins to flash, then release. Press TRACK << to adjust the hours and TRACK >> to adjust the minutes. Press DISP momentarily to save the selected time. Bass Boost Volume Display Set the Clock 6 XD5110 OPERATION General Operation Reset Press and hold for more than 2 seconds to RESET the unit upon initial installation or if abnormal opeartion occurs. Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. Audio Bass Press AUD until BAS appears Press VOLUME or to adjust (7 maximum / -7 minimum) Press AUD until TRE appears Press VOLUME or to adjust (7 maximum / -7 minimum) Press AUD until BAL appears Press VOLUME (LEFT) or (RIGHT) to adjust (BA.L 10/BA.R 10) BAL 0 represents equal balance. Press AUD until FAD appears Press VOLUME (FRONT) or (REAR) to adjust (FA.F 10/FA.R 10) FAD 0 represents equal fader. Treble Balance Fader 7 XD5110 OPERATION Tuner Operation Tuning FM Mono/Stereo Turn TUNE knob to select desired station. Press MONO during FM tuner operation to select mono or stereo (default) reception of the broadcast signal. Press LOC to activate local tuning for strong station reception only. Press LOC again to cancel and resume Distance tuning (default). Press BAND to select between FM and AM bands. Local/Distance Band 8 XD5110 OPERATION CD Player Operation Insert CD With the label facing up, insert a standard CD into the CD slot. The CD will automatically begin playback. Press the EJECT button to stop and eject the CD. The unit will change to tuner mode. If the disc is not removed within 10 seconds, the unit will reload the disc. Press TRACK >> to skip to the beginning of the next track. Press TRACK << to return to the beginning of the current track. Pressing TRACK << again skips to the beginning of the previous track. Press and hold TRACK << or TRACK >> to fast forward or reverse a track. Press Press Eject CD Track Select Fast Forward and Reverse Pause l l / II to temporarily stop CD playback. / II again to resume playback. Intro Press INT to play the first 10 seconds of each track. Press INT to cancel. Press RPT to continuously repeat selected track. Press RPT to cancel. Press RDM for more than 2 seconds to play all tracks in random order. Press RDM again for more than 2 seconds to cancel. Some CD-Rs and CD-RWs may be incompatible with this unit, depending on media type and recording method. Repeat Random CD-R/CD-RW Compatibility 9 XD5110 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Namsung America Inc. warrants this product to the original purchaser to be free from defects in material and workmanship, under normal conditions, for a period of one year from the date of the original purchase. Namsung America agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new or renewed product in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase. During the One-Year Warranty Period: For One Year from the date of purchase, your product will be replaced with a new, renewed or comparable product (whichever is deemed necessary) if it becomes defective or inoperative. This is done without charge to you. Replacement products are warranted for the balance of the original warranty period. Who is covered? This warranty is extended to the original retail purchaser for products purchased and used in the U.S.A., in the 48 contiguous states ONLY. What is covered? This warranty covers all defects in material and workmanship in this product. The following are not covered: installation/removal costs, damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product. What to do? If the product requires warranty service, you must prepay the initial shipping charges. DUAL will pay the return shipping charges if the product is returned to an address within the USA. Namsung America Inc. Attn: Returns Center 21318 64th Ave. South Kent, WA 98032 U.S.A. Toll Free: 1-866-626-7863 Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company's negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages. 10 XD5110 OPERATION Specifications CD Player Signal-to-noise: >86dB Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 12dBf 50dB quieting sensitivity: 16dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz Tuning range: 530kHz-1720kHz AM sensitivity: 30uV Frequency response: 80Hz-2kHz Total power output: 100 Watts Peak Power output: 25Wx4 @ 4 ohms, 14.4 VDC Operating voltage: 11-16 VDC, negative ground Speaker output impedance: 4~8 ohms Fuses: 1 amp fast blow AGC, 5 amp fast blow AGC Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm) Design and specifications subject to change without notice FM Tuner AM Tuner General 11 XD5110 OPERATION Troubleshooting Problem Unit will not turn on (no power) Cause Yellow or red wire not connected or incorrect voltage Black wire not connected Action Check connections for proper voltage (11~16VDC) Check connection to ground Replace fuse Check connections at speakers Insulate all bare speaker wires from each other and chassis ground Check for pinched wire Check for pinched wire Use fuse with correct rating Check mounting sleeve and backstrap support Check media for scratches Press eject or RESET Fuse blown Unit has power Speaker wires not connected (but no sound) One or more speaker wires touching each other or touching chassis ground Unit blows fuses Yellow or red wire touching chassis ground Speaker wires touching chassis ground Incorrect fuse rating Excessive skipping Unit is not mounted correctly or backstrap is not secure Physical defect in media (CD, CD-R or CD-RW) Err appears on Load/Eject operation error display Namsung America Inc. 21318 64th Ave. South Kent, WA 98032 Toll Free: 1-866-626-7863 www.dualav.com ©2004 Namsung America, Inc. EVOK0104-V02