User manual DYSON DC04

1 Assembling your Dyson 2 Operating your Dyson 3 On/off. Washing your pre-motor filter 1 2 3 4 Remove clear binTM. Press catch to release pre-motor filter. 1 2 3 Circle your two 6 monthly washes 5 6 A Slide wand fully into hose. Repeat steps A and B until water runs clear B 4 5 6 7 8 9 Twist tools before locating. Wind cable around cable winders, in an anti-clockwise direction. USER GUIDE IMPORTANT SAFETY INSTRUCTIONS Always work above the cleaner on the stairs. Unplug the cleaner when not in use. Turn the cleaner off before unplugging from the mains. It is not recommended to use this cleaner on hard floor surfaces without using the wand with one of the accessory tools. The brushbar continues to rotate while the hose is in use. Allow 12 hours for filter to dry. Make sure it is completely dry before replacing in the machine. Please read carefully before use 4 Emptying your clear bin TM 5 3 4 5 1 Wipe bin with a damp cloth. Changing/fitting belt 6 Finding and clearing blockages 7 Dyson Customer Care Note your Serial number 1 2 2 Check that tools are clear. Every new Dyson domestic vacuum cleaner comes with a 2 year guarantee (for the UK there is an option to purchase an extended warranty for a further 3 years). If you have a query about your Dyson, just call the Dyson Customer Helpline, with your serial number and details of where/when you bought the cleaner. Most queries can be solved over the telephone by one of our factory-trained Helpline staff. If your cleaner needs attention from our engineers, we aim to have it repaired and tested within 3 working days. Recommended postion for changing the belt, with wand removed. Undo fasteners using a coin and remove soleplate. UK 08705 275 104 7 days a week 8am - 8pm Dyson Ltd, Tetbury Hill, Malmesbury, Wiltshire SN16 0RP e-mail: service@dyson.com . 3 4 IE (01) 475 7109 Dyson ROI, Unit 2 Baldonnell Business Park, Naas Road, Co. Dublin 1800 239766 Dyson Appliances (Aust.) Pty. Ltd., Unit 8, 7-11 Parraweena Road, Taren Point, Sydney 22 29 0800 397 667 Avery Robinson Ltd., PO Box 18-057, Glen Innes, Auckland AU 6 Undo fasteners using a coin and remove soleplate. Empty into a plastic bag (recommended for asthma/allergy sufferers)... Remove any debris and check spindle is clean. To replace the belt Loop belt around brushbar and feed through hole. Clear the brushbar obstruction. Carefully cut away any threads from the brushbar. NZ 5 6 Important · Check that your electricity supply corresponds to that shown on the rating plate. The appliance must only be used as rated. · If the supply cable of the appliance is damaged, disconnect the appliance from the socket outlet immediately. The supply cable must be replaced only by Dyson Ltd. or their appointed agent, as special purpose tools and service techniques are required. · Do not use the cleaner if the cable or plug are damaged or if the cleaner has been damaged, dropped or has come into contact with water or any other liquid. In these cases, contact the Helpline. · When vacuuming, certain carpets may generate small static charges in the clear bin. These are entirely harmless and are not associated with the mains supply. To minimise any effect from this, do not put your hand or insert any object into the clear bin unless you have first emptied it and rinsed it out with cold water. · Do not continue to use the cleaner if any part appears to be faulty, missing or damaged. · Do not carry out any maintenance work other than that shown in this manual or advised by the Helpline, and do not put anything into the openings or moving parts of the machine. · Only use parts produced or recommended by Dyson; failure to do so could invalidate your guarantee. European conformity information: a sample of this product has been tested and found to be in conformity with the following European Directives: 73/23/EEC Low voltage (safety) Directive, 93/68/ EEC CE Marking Directive and 89/336/EEC EMC Directive. Wait for dust to settle ...or directly into a dustbin. Check end caps are in place. Using the back of the cleaner as a lever, loop the belt around your thumb. 7 Optional You may rinse the clear binTM with water. Do not use detergents. Do not immerse the whole cleaner in water. Do not remove bin inner or cone seals. Ensure completely dry before replacing. 7 8 For your safety Turn belt through 90°, stretch and release over spindle. Belt should be free of twists as shown. This product is protected by the following Intellectual Property Rights: US 4593429, US 4853011, US 4826515, US 5078761, US 5160356, US 5558697, US 5853440, US 5893936, CA 1182613, CA 1241158, CA 2056161, AU 637272, AU 669539, AU 691710, AU 697029, EP 0489565, EP 0636338, EP 0647114, EP 0800359, EP 0800360, EP 0799094, WO 94/00046, WO 96/19936, WO 96/19937, WO 98/02080, WO 99/27834, WO 99/29223, WO 99/49978, WO 00/04816, WO 00/21425, WO 00/21427, WO 00/21424, WO 00/17980, GB 2342283, GB 2341907, GB 2342282. Design Registrations: GB 2076926, GB 2074319. Eqivalent patents, registered designs and applications exist in other countries. 9 10 Do not pull on supply cable. Do not use cleaner above you on the stairs. Do not use cleaner near naked flames. Do not leave cleaner near heat sources. 8 9 10 The British Allergy Foundation considers that this product may in proper use reduce exposure to both House Dust Mite (Der p 1) and Cat Allergen (Fel d 1). It is strongly recommended that a sensitive person should take care when emptying the clear binTM. We recommend the manufacturers' emptying instructions should be strictly followed. Assessment carried out by BAF indicate that an individual's exposure can be reduced but this does not mean that an individual's allergic symptoms will necessarily diminish. BAF's opinion applies only to the products and allergen stated. The product should be used only for its intended purpose and strictly in accordance with the manufacturers' instructions at all times. Exposure to allergen can be dangerous. If you believe that you may suffer from an allergy you should seek medical advice. The British Allergy Foundation is a national charity (Charity Reg. No. 1003726) founded in 1991 with the aim of improving awareness, prevention and treatment of allergy. The Foundation continually strives to help sufferers to help themselves, often seeking to avoid or reduce exposure to relevant allergens. The Seal of Approval scheme forms a part of this initiative. Rest the three tabs on the inside of the green bumper strip, before pivoting soleplate into position. Please note that clearing blockages and changing the belt is not covered under your cleaner's guarantee. Turn power off and unplug before attempting to clear any obstruction or change the belt. Should any part of your machine become blocked it may overheat and stop due to the thermal cut-out being triggered. Unplug from mains and leave to cool down. Do not place hands under brushbar when in use. Do not use cleaner to pick up water or any other liquid. Do not run over supply cable. Do not use cleaner to pick up burning objects of any kind. JN06079 PN02001-07-03 04/07/01